Question about 1988 Chevrolet C1500

1 Answer

1988 Chevrolet C1500 v-6

Hard to start when cold otherwise fine and dandy

Posted by on

1 Answer

May have weak vacum preasure

Posted on Oct 25, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gas not staying in carb, when cold very hard to start


it sounds like the choke isn't closing on the carburetor when the engine is cold ( more gas, less air). normally step on gas pedal once to close choke before starting. need to find someone familiar with carburetors to help as it can be technical setting it up

Mar 20, 2014 | 1984 Dodge Ram 50

1 Answer

Hard starting diesel


the light means to do exactly what it says

May 28, 2013 | 1988 Mazda B2200

1 Answer

Print Email Problem with Chevrolet 1988 Corsica is hard to start after i get it started its runs good


hook up a fuel pressure gauge and run it check the fuel pressure let it sit with the gauge on it let sit for a little while and see if the fuel pressure drops off

Jun 04, 2012 | 1988 Chevrolet Corsica

1 Answer

1989 heater has started blowing cold air. new thermostat fan blowes fine just cold air


Has to be thermostat or plugged hose,,Try new thermostat first.

RB

Feb 20, 2010 | 1988 Chevrolet K2500

1 Answer

1988 Ford Taurus hard start problem


Change the coolant sensor located close to the thermostat housing. This is easy but do not over tighten it. You will have the same problem if you do. Tighten till it does not leak only.Good luck!

Nov 25, 2009 | 1988 Ford Taurus

1 Answer

Cold Starting


You have a cold start injector that is controled by coolant temp and more than likely the sensor, which is located center of intake, between #2 and 3 injector...it looks a bit like a reg. temp. sensor and will have either blue or black electrical harness connected to it. This sensor 'tells' the cold start sensor, a fifth injector for cold starting, when coolant is below a certain temp and gives extra gas. Try to find one at a junkyard, otherwise, www.getcoolparts.com about $80 new. Better yet, buy a Bentley manual and there's diagnostics using a multimeter on diagnosing specifically. I have an 88 but it is an N/A, not a turbo and is an 8v...if your's is a 16 valve, look for sensor in same spot but under fuel rail/injector area.

Sep 02, 2009 | 1988 Saab 900

1 Answer

1990 Cavalier runs rough when cold, fine when warm


have you checked plugs and wires, oxygen sensor? I would start there.

Apr 05, 2009 | 1988 Chevrolet Cavalier Z24

1 Answer

HEATER CONTROL BLOWS COLD ON RIGHT SIDE & HOT ON THE LEFT. WHEN I TURN ON THE HEATER I TURN THE PASSENGERS SIDE TO FULL HEAT & I GET FULL COLD; AS FOR THE DRIVERS SIDE ALL IS FINE AND DANDY.


your pass side blend door actuator is stuck. sometimes unhooking battery for a few minutes will allow them to reset. cut on heat then unhook when you hook back up and start vehicle the actuators will relearn themselves meaning they will move from one end to the other. if this does not work it will need to be replaced

Nov 12, 2008 | 2006 Chevrolet Silverado 2500HD 2WD

1 Answer

Won't start when hot


yes, one word ignition control module, located inside the distributor cap under rotor button, it will be the best 20-40.00 part you'll ever buy. hope this helps ya

Nov 05, 2008 | 1988 Chevrolet Cavalier Z24

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...