Question about 2005 Hyundai Tucson

3 Answers

I have a Tucson 2005. There is an intermittent problem where the car lurches a little and the engine stalls when I slow down or come to a stop. The Hyundai service mechanics said first it was the snorkle tube and that the throttle sensor was loose when I brought the car to them a week ago and fixed the problem. But a week later, the problems have reoccurred.

Posted by on

  • Anonymous Feb 25, 2009

    i have 05 tuscon since i buy this car same problem ... some times stopping allthe light comes out and i have to start again they just change the gas pump couple months ago now it is the same problemand also rpm goes higher

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had the same problem, i thought it was the fuel injection. I came to this site and saw the solution to your problem and went out ( 5 min ago @ 7:08 eastern time) and found the 3" flex tube disconnected from teh air box. I reconnected it and drove the car around teh block without any problems...

to all thank you and god you. i will visit this site and will try to help anyone and / or confirm what works ... again thank you thank you ,, thank you.

Posted on Jan 23, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

The clamps on the air box need to be replaced with steel ones ,otherwise you are wasting your time.
Usually this problem does not show up when reversing as the engine moves to form a better seal.
achec the clamps.

Posted on Jan 22, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

An idea to consider. I had a similar problem with an automatic Nissan Primera which stalled 50 percent of the time when idling and when coming to a stop would intermittently **** forward and the engine would then stall. It turned out to be a gearbox problem. The "gears" were not being selected correctly by the lever and were out on adjustment. In my case the gear lever would also tighten up a little when going into Park. After getting the gearbox serviced and the linkages freed up the problem went away. An idea from left field for what it is worth from my own experiences.

Posted on Nov 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Having stalling issues with 2013 tucson


If check engine light not on steady.... May be hard to find problem> One thing to look for is throttle plate coking/dirty.This will cause a problem with the base idle and cause stalling at stop lights and while slowing down. Have throttle plate cleaned and decarbed if it looks dirty

May 20, 2015 | 2013 Hyundai Tucson

1 Answer

What would cause a 2005 PT Cruiser to lurch intermittently?


This would be very good justification for you to buy a cheap OBDII scanner through Amazon or your local auto parts store. Next time it happens, plug the scanner in immediately and read the error code(s) out of the computer. Then you'll know what's happening. The failure is intermittent, whatever it is, so you need to catch it while the error code is still "live".

Aug 01, 2014 | 2005 Chrysler PT Cruiser

1 Answer

Intermittent miss


is this a 4.3 engine, if so A common complaint with the Chevy 4.3 engine is that it doesn't idle well, it's loud and makes awkward noises. Examples of this are staling, lurching and poor acceleration. being you checked the plugs and wires. Look for corrosion, breaks, exposed wires and loose connections.Lack of oil will cause a knocking sound in the engine, stalling, poor acceleration and eventually engine break down. check all vacuum lines closely. good-day!



Apr 11, 2014 | 2002 Chevrolet S-10

1 Answer

Accelerate after stopping almost stalls


Does it have normal fuel pressure and has the filter been replaced ?

Jan 15, 2014 | Subaru Cars & Trucks

1 Answer

Lurching


Yes it is dangerous VERY you could be crossing traffic and it could stall any time any where. Do get that looked at or send me more details as to what is going on with the car.

Dec 20, 2013 | Cars & Trucks

2 Answers

Car drives fine but when i slow down to a stop it begins to stall and lurch forward. the brakes also lock up and the steering sometimes to if i accelerate fast enough i begins to drive fine but if i slow...


The 1995 Grand Am was GM's worst nightmare. At 120,000 the transmission is going to just blatantly fail on you w/out notice. Problems with this make and model is if it was created between 1995-96 the transmission problems are goin to start. Even if you swap the crankshaft sensor, ignition module, and coils. I had one go at the mileage i just submitted. The computer also has malfunctions. It is indeed time to rid your vehicle, Sorry. Thnx 4 using fixya.com :-)

Apr 01, 2011 | 1995 Pontiac Grand Am

1 Answer

Problems accelerating


the engine tickover is too slow when the engine is cold its running on cold start, ie:choke,, after it warms up the engine slows down this is what is causing it to stall in gear,, get some one to hold the brakes hard on and with the engine running in gear ajust the tick over till its reving at 750 - 850 rpm the revs will go up a bit when its out of gear,, before you pick a gear to go into push the foot brake down to stop the car lurching,,,

Feb 19, 2010 | 1997 Cadillac DeVille

1 Answer

My hyundia tucson keep cuting off when i drive the jeep and i have to stop it cut off any time i stop it cut off and when my foot on the brake it move when myfoot is on brake


If the vehicle is stalling when coming to a stop or slowing, look at your throttle position sensor on the throttle body. it is small, almost a box with 2 phillips head screws(not the sensor with hex head bolts, right behind it). If it is grey in color, change it.

Aug 06, 2009 | 2005 Hyundai Tucson

2 Answers

2005 Hyundai Tucson Stalls


Check the obvious, if the battery has corrosion on the terminals clean it off with some coke. It could also be your alternator. If you hear a clicking noise when you try the key to restart after a stall it might be your starter motor. Or just tell them to pull the code at the dealership and it should greatly narrow the problem. Thats standard at the Firestone I go to.

May 31, 2009 | 2005 Hyundai Tucson

1 Answer

Engine stalls when brakes applied


Sounds like you have a vacuum leak. Do you also hear any other noises when you push the brakes?

Nov 01, 2008 | 2005 Hyundai Tucson

Not finding what you are looking for?
2005 Hyundai Tucson Logo

542 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...