Spark plug wire firing order - 1993 GMC Jimmy

theres no distributor and the firing order for your 3.8 is 1-6-5-4-3-2-the following link shows the coil pack
Buick General Motor 3800 V6 Engine Firing Order DIS IDI ignition timing 3.8 Buick Engine Coil Pack Firing Order Spark Plug Wire Location Which way do the spark plug wires go on & what cylinder is what?
.
For the Buick V6 231 3.8 liter turbocharged engine:
.
Answers!
.
Firing order:
1 - 6 - 5 - 4 - 3 - 2.
.
Spark plug wire location on coil pack:
.
Closest to the back of the car, left to right: 1 - 5 - 3.
Closest to the front of the car, left to right: 4 - 2 - 6.
.
Spark plug wire location on engine:
.
drivers side, front to back of car: 1 - 3 - 5.
passenger side, front to back of car: 2 - 4 - 6.
.----and this link shows the coil pack to cylinders
.
3 8 Buick Turbo Engine Coil Pack Firing Order Spark Plug Wire Location

Firing Orders

• Firing Orders

Sending Units And Sensors

Starting System

• HOME /
• REPAIR HELP /
• 1996 CHEVROLET CAVALIER 2.2L SFI OHV 4CYL REPAIR GUIDE /
• ENGINE ELECTRICAL /
• FIRING ORDERS /
• FIRING ORDERS

GM Cavalier/Sunfire 1995-2000 Repair Guide

FIRING ORDERS

Print
See Figures 1 and 2
To avoid confusion, remove and tag the spark plug wires one at a time, for replacement.
If a distributor is not keyed for installation with only one orientation, it could have been removed previously and rewired. The resultant wiring would hold the correct firing order, but could change the relative placement of the plug towers in relation to the engine. For this reason it is imperative that you label all wires before disconnecting any of them. Also, before removal, compare the current wiring with the accompanying illustrations. If the current wiring does not match, make notes to reflect how your engine is wired.

Fig. Fig. 1: 2.2L (VIN 4) Engine Firing Order: 1-3-4-2 Distributorless Ignition System

It can be faulty or dirty spark plug itselfd.Also for reference get the fuel level checked.Is the fuel tank is empty or near to empty.
Try cleaning the spark plugs and then see if that is helpin.On some cases the black carbon layer gets collected on the spark plugs and that causes the problem,so cleaning the plugs help.But if its not helping,then spark plug has to be replaced.Spark plugs get power from ignition coil to ignite sparks.If ignitioncoils are faulty then also there will no spark.--------------

To troubleshot and confirm the issue,i suggest you to go through the help links provided below,check the procedure and it will help you to confirm the issue in your case.
----------
Click the link below:------

Car cranks, has spark but will not ?

http://howtobyme.blogspot.com/2011/12/car-crankshas-spark-but-will-not-start.html

-----------

The spark plug firing order for car?

http://schematicsdiagram.blogspot.com/2011/06/spark-plug-firing-order-for-car.html

------------

How to Replace Spark Plugs?

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-spark-plugs.html

---------------

How to Perform a Basic Engine Tune Up-Spark Plug and Wire Change

http://schematicsdiagram.blogspot.com/2011/08/how-to-perform-basic-engine-tune-up_01.html

----------

Car has no spark?

http://schematicsdiagram.blogspot.com/2011/06/car-has-no-spark.html

---------

How does the spark plug wire go on the distributor cap in 1991 Mitsubishi Mighty?

http://schematicsdiagram.blogspot.com/2011/12/how-does-spark-plug-wires-go-on.html

------------
No spark on 2008 Chevy Avalanche?

http://schematicsdiagram.blogspot.in/2012/04/no-spark-on-2008-chevy-avalanche.html

-----------

How does the spark plug wire go on the distributor cap in 1985 Pontiac sunbird?

http://schematicsdiagram.blogspot.com/2011/12/how-does-spark-plug-wire-go-on.html

--------------

Ford Plug Wires Not Coming out?

http://whoisbyme.blogspot.in/2012/06/ford-plug-wires-not-coming-out.html

--------

Ford explorer has no spark?

http://schematicsdiagram.blogspot.com/2011/12/ford-explorer-has-no-spark.html

----------

Chevy impala spark plug firing order diagrams?

http://technoanswers.blogspot.in/2012/02/chevy-impala-spark-plug-firing-order.html

------------

How to gap spark plug on Chevy Impala?

http://technoanswers.blogspot.in/2012/02/how-to-gap-spark-plug-on-chevy-impala.html

-----------

Spark plug Replacing for chevy impala?

http://technoanswers.blogspot.in/2012/02/spark-plug-replacing-for-chevy-impala.html

Chevy s-10 blazer 4.3l Spark Plug Firing Order?

http://howtobyme.blogspot.com/2011/12/chevy-s-10-blazer-43l-spark-plug-firing.html

----------------

1982 dodge rampage Spark plugs Firing Order Diagram?

http://schematicsdiagram.blogspot.com/2011/12/1982-dodge-rampage-spark-plug-firing.html

----------------

2006 Suzuki Forenza Spark plug Firing Order Diagram?

http://schematicsdiagram.blogspot.com/2011/12/2006-suzuki-forenza-spark-plug-firing.html

------------

1983 Ford Ranger Spark plug firing order?

http://schematicsdiagram.blogspot.com/2011/12/1983-ford-ranger-spark-plug-firing.html

--------

Firing Order for 1991 Lexus ES 250?

http://schematicsdiagram.blogspot.com/2011/12/firing-order-for-1991-lexus-es-250.html

----------------

Firing order for 1992 Chevrolet 5.0 engine?

http://schematicsdiagram.blogspot.com/2011/12/firing-order-for-1992-chevrolet-50.html

-----------

How to identify number one spark plug on the distributor cap?

http://schematicsdiagram.blogspot.com/2011/12/how-to-identify-number-one-spark-plug.html

-----------

How to remove rear spark plugs on 1991 Buick Regal?

http://howtobyme.blogspot.in/2012/02/how-to-remove-rear-spark-plugs-on-1991.html

---------------

These details will help.

Thanks.

It sounds like the spark plug wires are not plugged into the correct place on the distrubutor. take the distributor cap off and crank the engine over. Make a note of which direction the rotor spins. (Clockwise, or Counterclockwise) then find the firing order for that engine. Sometimes the firing order is on the intake manifold. (if you tell me which engine it has, the 4 cylinder 2.0, or the 6 cylinder 2.5; I could post you the firing order). Now on the distributor cap there is one wire post that has the #1 on it, that would be where you put the spark plug wire from cylinder 1. Following the rotation of the distributor rotor, you would put the spark plug wire for the next cylinder in the firing order after the #1 wire, and so on.

Hope this helps. The ignition coil:

• changes low-voltage pulses from the PCM to high-voltage pulses.
• fires 2 spark plugs simultaneously.
• has 3 transformers.
  • One transformer fires the spark plugs for cylinders 1 and 5
  • One transformer fires the spark plugs for cylinders 2 and 6
  • One transformer fires the spark plugs for cylinders 3 and 4

Spark plug wires:

• carry high-voltage pulses from the ignition coil to the spark plugs.

The spark plugs:

• change high-voltage pulses to spark at the gap, which ignites the fuel and air mixture.

The firing order is 1-4-2-5-3-6.

2003 Chevrolet Malibu 3.1L SFI OHV 6cyl
Spark Plug Wires - Removal & Installation

3.5L Engine

1. Before servicing the vehicle, refer to the Precautions Section.
   NOTE Twist the spark plug boot one-half turn in order to release the boot. Pull on the spark plug boot only. Do not pull on the spark plug wire or the wire could be damaged.
2. Remove the intake manifold cover, if required.
3. Disconnect the left side spark plug wires from the spark plugs.
4. Disconnect the left side spark plug wires from the ignition coil.
5. Remove the spark plug wire clips from the Manifold Absolute Pressure (MAP) sensor bracket and the heater inlet and outlet pipe tab.
6. Remove the spark plug wire assembly.
7. If replacing only one plug wire, open the retaining clips and remove the appropriate spark plug wire.
8. Disconnect the right side spark plug wires from the spark plugs.
9. Disconnect the right side spark plugs from the ignition coils.
10. Remove the spark plug wire assembly.
11. If replacing only one plug wire, open the retaining clip and remove the appropriate spark plug wire.

To install:

1. Install the spark plug wire assembly.
2. Connect the right side spark plugs to the ignition coils.
3. Connect the right side spark plug wires to the spark plugs.
4. If replacing only one plug wire, open the retaining clip and install the appropriate spark plug wire.
5. Install the spark plug wire assembly.
6. Connect the left side spark plug wires to the spark plugs.
7. Connect the left side spark plug wires to the ignition coil.
8. Install the spark plug wire clips to the MAP sensor bracket and the heater inlet and outlet pipe tab.
9. If replacing only one plug wire, open the retaining clips and install the appropriate spark plug wire.
10. Install the intake manifold cover, if required.

Fig. 2.2L Engine Firing Order: 1-3-4-2 Distributorless ignition system



Fig. 3.1L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system



Fig. 3.5L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system



Fig. 2.4L Engine Firing order: 1-3-4-2 Distributorless ignition system



Fig. 3.1L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system



Fig. 2.2L Engine Firing Order: 1-3-4-2 Distributorless ignition system


Fig. 3.5L & 3.9L Engines Firing order: 1-2-3-4-5-6 Distributorless ignition system


I really hope help you with this (remember rated this help) Good luck.

Hi,
I don't know your engine size, but the link below is a picture of the GM small block firing order with distributor.
The firing order, which should be cast into the intake manifold, for the chevy small block V8 is 1-8-4-3-6-5-7-2. The firing order is the numerical sequence in which the spark plugs are fired. The insertion position of each spark plug wire around the circumference of the distributor cap can be found according to a clock face. The insertion sequence determines the firing order. The firing order is followed clockwise around the distributor cap starting from the 6:30 position with the 6:30 position being the number one cylinder spark plug wire.

http://www.classiccarauto.com/impala/how_to/images/distributor.png

Hope this helps...

FROM LEFT TO RIGHT, 5/2 3/6 4/1. ASSUMING YOU HAVE THE 3.1L ENGINE.