Question about 2003 Chevrolet S-10

1 Answer

Chevy s10 pickup truck

What will cause your front wheels to sqill when you turn a corner or backing out of a parking place

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Check your frt brake pads. sounds like wear tabs. must be getting close to needing new pads.

Posted on Dec 12, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace front brake pads on a How to replace front brake pads on a 2000 Chevy S10 4WD pickup?


First you want to remove brake fluid from brake resovoir, raise front wheels off ground and set park brake or block rear wheels. Remove front wheels, keep steering wheel unlocked so you can turn rotors side to side. Loosen bolts that hold caliper end gently pry caliper free from rotor, remove caliper and remove pads, use bungy cord to hang caliper away from rotor, have rotors measured to see if they are thick enough to have machined, replace if out of specs. Match up pads with old ones, use anti- squeak red liquid and put layer on back of pads, let dry. Use tool to put pistons back into calipers, slowly put pistons back into bore while opening up bleeder screw so ABS won't be damaged. After rotors resurfaced, wash with rubbing alchohal to remove any oils from hands, install rotors and reverse putting pads back onto caliper and reinstall, torque caliper bolts to factory specs and tighten bleeder screws. Install wheels, torque lug nuts to factory specs and replace brake fluid in resovoir. Lower car carefully to ground and press brake peddle without pumping it. Any air in system should bleed out, if not get someone to help with bleeding system. Road test to ensure no squeaks or pulling, burn brakes in slowly.

May 10, 2014 | 2007 Saturn Aura XR Sedan

1 Answer

2002 chevy S10 wheel problems


If you are talking front wheel the check for a bent steering rod (tie rod ) (rack end and ball joints.)

Jan 15, 2014 | 1998 Chevrolet S-10 Pickup

1 Answer

Replace dash lights 1988 chevy s10 pickup


http://www.justanswer.com/chevy/1edpm-change-dash-light-1991-chevy-s10.html

Jun 06, 2012 | 1988 Chevrolet S-10

1 Answer

I have an 02 chevy trailblazer. The brake makes a strange popping feel when braking hard. Also when backing out of parking or turning corner there is a grab in the wheels


Possibly a bad wheel bearing if so it should be corrected immeadiatly This is a dangerous situation. A quick check is to put the car on the it's jack and check the wheel for any play. A bad wheel bearing will allow the wheel to pitch out of alignment causing the wheel to be cocked in the brake calipers. The popping is the brake rotor popping into place between the calipers. You will also feel a bouncing or lopeing in the front end when turning in reverse.

Oct 23, 2011 | 2002 Chevrolet TrailBlazer

3 Answers

Where is the fuel filter located on a 4.3 liter v6 chevy s10


the fuel filter is located on the driver's side of the vehicle, at the front corner of the truck bed.

Mar 10, 2010 | 1999 Chevrolet S-10 Pickup

2 Answers

1998 Chevy S10 front axle will not engage when put into 4 wheel


Normal thing that happens as long as onone (worked) on it, is the vacume hose going to the engage sevevo under the battery box has fell of on either end or is brocken on the way there. Then the once or now leaky battery acid ate up this same servo. then the cable going to the front axel breaks sticks falls off or even someone needing one climbed under your truck while parked somewhere to get one to replace their brokeen one now you don't have one then theaxel engage arm or gearset is damaged

Aug 16, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

My chevy S10 has front discand rear drum the front brakes bleed out just fine the back just drips any solutions?


Sounds like your proportioning valve is stopping up. try opening the bleeder on a wheel cylinder, and kick the brake pedal hard a couple of times. Soimetimes this will free them up.

Jun 07, 2009 | 1986 Isuzu Pickup

1 Answer

Ignition will turn when key is inserted 1996 Chevy S10


Maybe the steering wheel lock causing this problem, try rocking the wheel left to right and back the other way, if that doesn't work the lock cylinder is defective and must be replaced.

May 21, 2009 | 1996 Chevrolet S-10 Pickup

1 Answer

Chevy s10 engine running fine then idles real fast all by itself


Your going to have to get the ECM scaned, there are to many things that can cause that. most places like Auto Zone or Part Source can scan your S 10 free of charge and can also give a how to's if you want to replace the part your self.
Good luck and hope this helps

Apr 09, 2009 | 1998 Chevrolet S-10 Pickup

Not finding what you are looking for?
2003 Chevrolet S-10 Logo

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...