- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Try google images but you will likely need a special jemmy type tool from a parts house or accessory shop. There are probably pop studs located all around the edge of the door panel and will need care to release, thats what the tool is for. The window mechanism will have jumped its track or if cable operated come adrift. All will be revealed. try ramforumz.com for help
You can't put up the front passenger window with it's own switch ? Did you check the POWER WINDOW RELAY in the instrument panel fuse / relay box ? An you checked POWER fuse 30amp same fuse box ? All window switches have direct power from power window relay !
Fuse Block - Instrument Panel
Left of the Steering Column, behind the storage Compartment
Sunroof Switch Assembly, Window Switch - Left Front, Window Switch - Left Rear, Window Switch - Right Front, Window Switch - Right Rear
if you make a fist and hit the door on the inside about the middle of the door card HARD while holding the button and it goes down -you have a bad regulator motor- if that doesn't do anything it may be the swicth in the passangers door but i really suspect the motor-cheers Denny
Yea your right on that one, but to be sure test the regulator connector with a test light to be sure their is power getting to the motor. to remove the panel their will be a few screws around the panel and some snap clips on the back side of it, disconnect any connectors and be careful with the plastic clip for the door handle.
Sounds like the regualte or push arm is broken. If there is no spound then sounds like the regulator. The inside door trim has to be taken off, find the regualator, remove and replace should be ok then.
vice grip? you're lucky you didn't shatter the window.
So only the passenger front window is out based on what you're describing. Or are you trying to say all the passenger windows are out? (you have three passenger windows)
I am going with just the front passenger being out and that neither the switch on the driver's door or the switch on the front passenger door work to control the window. It's rare that both switches would die at the same time, so that rules that out. Now you said you pushed the button and the window does not move, if you don't hear a sound at all, odds are the motor is toast, if you do hear a sound, then the regulator may be stripped or broken.
On the inside trim, you can remove screws that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. You'll need to lift the door panel upwards in order to
get it off the window ledge. Pull back the weather seal and you'll be
able to remove the motor which will be secured down by a few bolts
The problem may be in the wiring which if you pull up the carpet on the front passenger side by
removing the door floor trim and lifting the carpet you will see the
wiring underneath. Probably laying in water or has been. Look for splices in the
wiring which will have corroded. Repair the wiring then check the fuse. Another problem may be in the motor found inside the door.
The brushes may have worn out. If so you need to replace the motor.
Ususally the drivers side will fail first since it is the most used.
Since you have the door panel off, pul the rod for the door lock manually inside the door, this should unlock it, if it does not, there is a small push button, basicly a little peice of metal on the latch itself on the door latch inside the door, push it down this should pop the door open, you may need to spray all of the mechinisms with white lithium grease in a arosol can.....