Question about 1999 Pontiac Grand Am GT

1 Answer

2004 pontiac grand am--turns over fast but will not crank is not ignition module

Posted by on

  • b1960a Aug 05, 2008

    turns over but will not crank had modgul ck. but is ok . i have power to eveything and i have a ground changed crank sencer what next

  • Anonymous Jan 17, 2009

    same problem



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 81 Answers

Ensure the fuel pump is working.

Posted on Sep 01, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2004 Pontiac sun fire will crank but no fire to plugs what the problem with the spark new plug

Ignition module maybe or crankshaft position sensor . Videos on youtube showing how to diagnose GM ignition system for your vehicle .
Check out this video , it runs but show's how to test ignition module coil driver , power an grounds .
2004 Saturn Ion 2 2 Misfire Case Study P0300 plus it shows where ignition module is .

Oct 01, 2017 | Pontiac Sunfire Cars & Trucks

2 Answers

I have a 2004 Pontiac grand Prix. It cranks but won't start. I took off the spark plug wires like I watched in a video and saw nothing.I was driving it and the car just cut off and won't start back up

could be a cam/crank sensor problem
could be a broken timing belt/chain not working the sensors
run the fault codes to determine the problem area

Jan 02, 2017 | Pontiac Cars & Trucks

1 Answer

2004 grand am stuttered then stopped working all together, wont start at all

Fuel pump? When you turn key to ON, do you hear the pump come on for 2 seconds to pressurize the lines? If not, you will need to have the fuel pump circuit checked for a failed fuel pump.

If the pump is working, start looking into the ignition system by checking for spark on one of the spark plug wires. If no spark, possibly the ignition control module or the crank position sensor.

Sep 30, 2013 | 2004 Pontiac Grand Am

1 Answer

How do you replace the ignition control module on a 2004 pontiac montana

first you have to remove 3 coils then remove connector, then remove ignition module.

Sep 22, 2013 | 2004 Pontiac Grand Am

1 Answer

Where is the ignition module. Can I get to it from under the hood? Should I replace the Crank module when I replace the ignition module?


The ICM is located under the hood, next to the coil pack and spark plug wires. Here the part: Pontiac Grand Am Ignition Control Module (ICM).

If you ar having distribution problem and misfire check also the crankshaft position sensor. It signal is used to control coils and sparks.

Aug 29, 2011 | 1989 Pontiac Grand Am

1 Answer

I have 2002 Pontiac Grand Am and I cleaned out the spark plugs and replaced them. The car still only cranks and will not turn over. Any help you provide will be greatly appreciated.

Possible causes:
Ignition coil bad
Electronic ignition module bad
Coil wire to the ignition module bad
All of the above.

Pull out one plug and ground it to the engine. Have someone crank the engine as you watch for a spark. No spark- see above. If there is spark the the problem lies in fuel/air/compression.

Dec 09, 2010 | 2002 Pontiac Grand Am

2 Answers

Grand am stalling and not starting

Sounds like the crank sensor or ignition module. check for spark when it is in the no start condition. Ignition modules are expensive so i would have it checked by a garage before replacing it.

Mar 21, 2009 | 1994 Pontiac Grand Am

2 Answers

2005 Pontiac grand prix 3.8 doesn't start

Try this: Turn ignition on for AT LEAST 10 minutes without doing anything else. After 10 minutes, turn the key to start, thre is a good chance of it running. Long explanation, but it has to do with the PassLock security system futzing up.

Nov 30, 2008 | 2005 Pontiac Grand Prix

Not finding what you are looking for?
1999 Pontiac Grand Am GT Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8825 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides