Question about 1999 Chevrolet Suburban

1 Answer

When backing up, my suburban stalled. I bought a pocket scan and the code came up P0332.? any ideas?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

It's a knock sensor code. Google tells all...

Posted on Jul 31, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Stalls while driving but restarts while coasting in neutral. Just bought the car and drove fine first 100 miles. Car had set up for long period before I got it. Any idea what's causing this?


bad gas, clogged fuel filter, weak fuel pump, vacuum leak, crank sensor, ignition control module, coil pack going south, the list goes on and on...
scan for check engine codes to see if the computer caught the fault.

Mar 16, 2015 | Cars & Trucks

1 Answer

Code p0332


P0332 Knock Sensor 2 Circuit Low Input (Bank 2)
__________
car code reader

May 14, 2013 | 2004 Chevrolet Avalanche

1 Answer

I have a 2002 Yukon P0332 Code


when you replace sensor trouble codes must be cleared out. or it will keep showing up, like yours

Feb 15, 2013 | 2002 GMC Yukon XL

1 Answer

Have a code come up p0332 on a cadilillac 2004


P0332 DTC Code - Knock Sensor 1 Circuit Low Input (Bank 2)
A knock sensor tells the engine computer when one or more of your engine's cylinders are "knocking", that is, exploding the air/fuel mixture in a way that delivers less power and can be damaging to the engine if prolonged.

The computer uses this information to tune the engine so that it doesn't knock. If your knock sensor on Bank #2 is generating a low output voltage (perhaps under 0.5V), then it will trigger a P0332 DTC. This P0332 code may show up intermittently or the Service Engine light may be lit constantly. Other knock sensor related DTC codes include P0325, P0326, P0327, P0328, P0329, P0330, P0331, P0333, and P0334.

You may notice drivability problems including fluctation engine RPM, a loss of power, and perhaps some hesitation. There may also be other symptoms.

Potential causes for a P0332 DTC include (but are not limited to):
The knock sensor is faulty and needs to be replaced
There is a wiring open/short/fault in the knock sensor circuit
The PCM/ECM has failed

For aditional details, just Contact Us.

Hope this helps; just keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Have a nice day and thanks for using FixYa.

Jose.

Oct 19, 2011 | 2004 Cadillac Escalade Ext

1 Answer

My 08 Suburban only has 32000 miles and the check engine symbol is lit up on the dashboard. What do you think is causing this to happen? What can I do to fix it?


{: ) There are a lot of reasons. The best way to have an idea of the possible cause is to have it checked by a scan tool. You can try to turn off the engine, remove key, open then close driver door, for 1 minute to reset the module. Then try to start the engine again.
However, if the trouble code is current, the engine light will just keep on coming back.

Nov 13, 2010 | 2008 Chevrolet Suburban

1 Answer

How do you correct repair code P0332 and how what should the cost be for a 2004 gmc denali?


P0332 Is set by a knock sensor, desiganted by GM as "Knock Sensor 2".

There could be many causes for this, from a misfire, to a loose sensor; so an appraisal from anyone without access to the vehicle is out of the question.

Dec 01, 2009 | 2004 GMC Sierra Denali

1 Answer

1992 350 suburban 4x4 stalls


check to make sure there is no vacuum going to the egr valve at idle if there is plug the line.

Apr 25, 2009 | 1995 GMC Suburban

2 Answers

Car has no power. Intermittent problem.


Thru all of the above, has the check engine light ever gone on? Even if it hasn't I'd have the engine codes checked w/ a scan tool, to see if there are any stored codes on the Suburbans computer. U can have it done for free at most parts stores, and they will give u info on what to do to correct any trouble codes that show up. Do the above, and after discussing any codes w/ parts store , if u need further help, let me know. Good Luck!

Nov 02, 2008 | 1998 Chevrolet Suburban

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

157 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...