Question about Volvo S60

1 Answer

Does not start. message on left of dash reads: " start prevented try again" - hv tryed locking & unlocking, shifting transmission to neutral, message continues what are yr thoughts, thanks

Posted by on

  • lattservices Mar 30, 2009

    had to disconnect battery to clear alarm and restart car
    any solutions

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

If you have a 2nd key, try it. Obviously, if it works, the first key is bad. If it doesn't work, it may be the antenna in the ignition.

Sometimes disconnecting the battery for a few minutes and then reattaching it works.

If you don't have a 2nd key, you'll most likely have to tow it into a dealer.

Posted on Nov 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 Cadi Deville, can't get any locks to operate with remote or dash push buttons, the remote operates everthing but the locks! When the remote door lock is pressed, lites flash,horn blows locks not.


Power Door Lock Operation
The vehicle is equipped with power door locks. Each lock actuator is powered and controlled by the door module mounted in the individual door, but the rear integration module (RIM), which is the master control for the door lock system, determines when the lock functions are permitted. The RIM receives and examines the requested lock function from the individual door modules, or from the remote function actuator (RFA) via the class 2 serial data circuit. The RIM also examines the transmission shift selector position and the ignition switch position information available over the Class 2 serial data circuits. If the RIM determines that a lock or unlock function is permitted, it sends a class 2 message back to the individual door modules commanding them to perform that Lock or Unlock function.
Power Door Lock Components
The power door lock system consists of the following components:
?€¢
Driver door lock switch


?€¢
Passenger front door lock switch


?€¢
LH rear door lock switch


?€¢
RH rear door lock switch


?€¢
LH middle door lock switch (w/ V4U)


?€¢
RH middle door lock switch (w/ V4U)


?€¢
Driver door switch assembly (DDSA)


?€¢
Driver door module (DDM)


?€¢
Passenger front door module (PDM)


?€¢
LH rear door module (LRDM)


?€¢
RH rear door module (RRDM)


?€¢
Left middle door module (LMDM) (w/ V4U)


?€¢
Right middle door module (RMDM) (w/ V4U)


?€¢
Driver door lock actuator


?€¢
Passenger front door lock actuator


?€¢
LH rear door lock actuator


?€¢
RH rear door lock actuator


?€¢
LH middle door lock actuator (w/V4U)


?€¢
RH middle door lock actuator (w/ V4U)


?€¢
Driver door cylinder unlock switch


?€¢
Rear integration module (RIM)


?€¢
DRVMDL fuse (10-amp)


?€¢
PASS MDL fuse (10-amp)


?€¢
RRDR MDL fuse (10-amp)


?€¢
Class 2 serial data link

Sep 27, 2016 | 2002 Cadillac Deville

1 Answer

Shifter is locked in park on a 2002 bravada that sayes on dash its in reverse


PRND321 Display
The instrument panel cluster (IPC) displays the selected gear position as determined by the engine control module (ECM). The IPC - instrument panel cluster receives a serial data message from the ECM indicating the gear position. The PRND321 display blanks if:
?€¢
The ECM detects a malfunction in the transmission range switch circuit.


?€¢
The IPC detects a loss of serial data communications with the ECM. The automatic transmission shift lock control system is a safety device that prevents an inadvertent shift out of PARK when the engine is running. The driver must press the brake pedal before moving the shift lever out of the PARK position. The system consists of the following components:
?€¢
The automatic transmission shift lock control solenoid


?€¢
The automatic transmission shift lock control switch

With the ignition in the ON position, voltage is supplied to automatic transmission shift lock control switch. Voltage flows through the normally closed contacts of the automatic transmission shift lock control switch to the automatic transmission shift lock control solenoid. The automatic transmission shift lock control solenoid is permanently grounded. This energizes the automatic transmission shift lock control solenoid causing the transmission shift lever to be physically locked in the PARK position. When the brake pedal is pressed the contacts in the automatic transmission shift lock control switch open, de-energizing the automatic transmission shift lock control solenoid. This allows the shift lever to be move out of the PARK position.
The transmission range (TR) switch is part of the park/neutral position (PNP) and backup lamp switch assembly, which is externally mounted on the transmission manual shaft. The TR switch contains four internal switches that indicate the transmission gear range selector lever position. The PCM supplies ignition voltage to each switch circuit. As the gear range selector lever is moved, the state of each switch may change, causing the circuit to open or close. An open circuit or switch indicates a high voltage signal. A closed circuit or switch indicates a low voltage signal. The PCM detects the selected gear range by deciphering the combination of the voltage signals. The PCM compares the actual voltage combination of the switch signals to a TR switch combination chart stored in memory.
You need a Tech2 scan tool to diagnose this problem ! possible range sensor !

Sep 03, 2015 | Cars & Trucks

1 Answer

My 2004 buick rainer is stuck in park but dash board says its in drive how can i fix this


Automatic Transmission Shift Lock Control System
The automatic transmission shift lock control system is a safety device that prevents an inadvertent shift out of PARK when the engine is running. The driver must press the brake pedal before moving the shift lever out of the PARK position. The system consists of the following components:
?€¢
The automatic transmission shift lock control solenoid


?€¢
The automatic transmission shift lock control switch
Can you or can you not take it out of park ?
Shift Lever Does Not Move with Brake Pedal Depressed
yes or no ?
PRND321 Display
The instrument panel cluster (IPC) displays the selected gear position as determined by the engine control module (ECM). The IPC receives a serial data message from the ECM indicating the gear position. The PRND321 display blanks if:
?€¢
The ECM detects a malfunction in the transmission range switch circuit.


?€¢
The IPC detects a loss of serial data communications with the ECM.


You have a transmission range sensor or PCM problem , Need a professional grade scan tool to diagnose the problem , well that would be the easiest way to test .You should have all modules test for DTC'S - diagnostic trouble codes ! That would point you in the right direction ! I would suggest you google class 2 serial data communication network !

Aug 17, 2015 | Buick Cars & Trucks

1 Answer

I have a 2007 Cadillac cts my key stuck my Windows stuck my flashers flashing and my car starts up so what's going on


Your key is stuck ? It won't move , it won't come out of the lock cylinder ? Can you shift it from park to drive , neutral etc... Are there any lights lit on the dash , yellow wrench light , service vehicle soon light ? any messages on Driver Information Center ? Your Cadillac has numerous electronic features controlled by modules - computers ! If your not familiar with electronics an these things I suggest you take it to someone who is . Does you Cadillac have console fool shifter ?
Electronic Park Lock (EPL)/Ignition Lock Cylinder Control Actuator: If the vehicle is equipped with automatic transmission and a floor mounted console gear shift, it has an ignition lock cylinder control actuator system in the steering column. The ignition lock cylinder control actuator purpose is to prevent the ignition key from being turned to the OFF position when the transmission is in any position other than PARK and the vehicle may still be moving. The column ignition lock system consists of an ignition lock cylinder control actuator, and a park position switch that is located in the automatic transmission shift lock control switch. The ignition lock cylinder control actuator contains a pin that is spring loaded to mechanically prevent the ignition key cylinder from being turned to the lock position when the vehicle transmission is not in the PARK position. If vehicle power is lost, and/or the transmission is not in the PARK position the operator will not be able to turn the ignition key to the lock position and will not be able to remove the ignition key from the column.
Linear Shift Assembly: If the vehicle is equipped with a column mounted gear shift, it has a linear shift assembly on the steering column. The linear shift assembly has a cable that runs from the linear shift assembly to the ignition lock cylinder case. The purpose of this cable is to prevent the ignition key from being turned to the OFF position when the transmission is in gear and the vehicle may still be moving. The linear shift assembly cable contains a pin that is spring loaded to mechanically prevent the ignition key cylinder from being turned to the lock position when the vehicle transmission is not in the PARK position. If vehicle power is lost, and/or the transmission is not in the PARK position the operator will not be able to turn the ignition key to the lock position and will not be able to remove the ignition key from the column.
The windows are no exception , they are controlled by modules in each door an are connected by a serial data communication bus !
The vehicle is equipped with power windows controlled by the door modules. Each passenger door window can be operated, either from a power window switch built into the driver door switch assembly (DDSA) , or, from a power window switch mounted locally on its associated door. The driver door window can be operated only from the driver door power window switch built into the DDSA.
When the driver door module (DDM) receives a driver door window switch request from the DDSA, the DDM examines the request and inspects to see if it has received any messages from any of the other vehicle modules prohibiting the movement. If no prohibitive messages have been received, the DDM then applies power and ground to the driver door window motor to move the window as requested.
When a passenger door module, passenger front door module (PDM), LH rear door module (LRDM), or RH rear door module (RRDM), receives a window switch request from, either the DDSA or the window switch mounted locally to its door, the passenger door module examines the request and inspects to see if it has received any messages from any of the other vehicle modules prohibiting the movement. If no prohibitive messages have been received, the passenger door module then applies power and ground to its associated window motor to move the window as requested.

Jun 30, 2015 | Cadillac Cars & Trucks

1 Answer

Gear shift moves but indicator doesn't change and transmission doesn't engage.


try disconnecting cable to transmission turn the shifter on transmission manually down there connect cable again start car try it if not try it again turn once then connect cable again then try it if not the transmission is not good

Jan 31, 2013 | 2002 Nissan Maxima

1 Answer

Volvo V-70 drivetrain & electronics faults


I suspect you have some loose connections or shorts in the wiring harness. I've had similar strange things happen with an Olds Bravada. Various transmission shifting problems, faults, etc. that all seemed to come from the engine's computer system getting incorrect voltages and readings due to wiring faults/shorts.

Dec 16, 2011 | Cars & Trucks

1 Answer

Doors lock and unlock while driving and it shows on dash to be shifting from drive to park again and again. then it goes to low power,shows "service ABS system, and service stabilitrac." I took...


the locks are cycling because it thinks it is going into park there is a problem with the park nuetral switch it is on the side of transmission where shifter hooks on make sure wiring is not rubbing and cut into harness

Mar 28, 2011 | 2009 Chevrolet Silverado 2500HD

2 Answers

Gear shift is locked. we can only shift the car


The automatic transmissions on these vehicles are known to die early in the life of the car and Volvo is well aware that the vehicle has a dud auto transmission. The symptoms you have mentioned are an indication that the transmission has had it. It's basically just running in limp mode now.

You don't say what mileage this vehicle has clocked up but even low mileage vehicles have had to have the entire transmission replaced due to failures like yours. You also, no doubt, have a transmission alert showing on the dash.

The bad news is that a replacement automatic transmission will now be necessary and this will be costly. Even then, with these cars, you could experience another transmission failure after just another 30000 miles or so of driving.

Sean

Dec 19, 2009 | 2005 Volvo XC90

1 Answer

My dashboard it out on my 1997 grand carivan


The dash cluster is probably bad. Replace the assembly & you should be fine. Get the tranny checked. It sounds like you got a bad one.

Jun 24, 2009 | 1997 Dodge Grand Caravan

2 Answers

Key lock out use remote message on dash display of ranger rover


First try to re sync. the key with the car.
To re sync the controller, please do as it follows:
1: close the vehicle from the driver's side with the key!
2: Wait until the alarm is armed.
3: With the unlock button pressed turn the key in the barrel to unlock position, then back. Now release the button.
4: Now with the lock button pressed turn the key to the locked position, and back. Release the button.

Jan 03, 2009 | 1997 Land Rover Discovery

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

374 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Mark Jones

Level 2 Expert

76 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...