Question about 1989 Honda Prelude

1 Answer


Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Check your fuses, and battery terminals. or what happened with my 1990 prelude is the coil and camshaft positioning sensor gave out one day check those parts to see if they have enough ohms going throught them just take those parts to autozone they will tell you there.

Posted on Jul 29, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Ive changed the spark plugs in my honda prelude and now the car wont start

does it even crank? put the old ones back and if it starts then you have the wrong spark plugs or they were not gapped correctly.

Aug 05, 2010 | 1991 Honda Prelude

1 Answer

How do you find tdc for a 1991 honda prelude 2.1

remove the #1 spark plug. rotate the engine in the direction it rotates when operating. use a socket and ratchet on the crankshaft bolt. while cranking, place your finger over the spark plug hole. when you feel pressure building. insert a wooden dowel into the hole and contact the piston. while holding the dowel against the piston, continue cranking while observing the dowel. when the piston reaches the top, the dowel will stop and begin reversing direction. when it starts reversing direction, stop and crank it back to the top. go slowly when performing all steps. obviously this procedure works best with 2 people.

the #1 plug should be the first one at the front of the engine. if you remove all plugs it will be easier to turn.

May 12, 2010 | 1991 Honda Prelude

1 Answer

How come my 1991 honda prelude does not hold charge?

Because the battery is going dead. If the alternator was at fault, the car would die after 3 hrs or less of driving, and it wouldnt restart. Same with the voltage regulator. The only culprit when a car starts like it was the last time, is when the battery is getting charged, but it is unable to hold it. If you turn off car, and restart it right away, and it sounds fine, it is one more indication of an exhausted battery.

Mar 07, 2010 | 1991 Honda Prelude

1 Answer

My 1991 Honda prelude has lost a headlight ground. Where is it?

There are fuses for the headlights, right and left. G201 is the ground connection number. I have no picture but its located RH Center of eng compartment. Usually on the radiator support.

Dec 16, 2009 | 1991 Honda Prelude

1 Answer

A 1991 mitsubishi montero , recent dead battey and no park lights

Change or recharge the battery. Repair any exposed wires (insulation broken or worn off) on wires in affected circuit that may be shorting out and drawing current from the battery.

Sep 20, 2009 | 1991 Mitsubishi Montero

1 Answer

No spark at plugs on my 1991 volvo 240

Did you replace the plugs? How hot is the spark from the coil thin and blue? if it is big and orange it is a weak coil and should be replaced. If it is good try an other wire from a different car (do not put a spark plug in it) and see what the spark looks like if good put the plug in it and check the spark again if this is a good the wires are bad

Mar 06, 2009 | 1991 Volvo 240

1 Answer

My onlu transprotation

look at your timing belt if its not that check your rotor make sure its tight

Feb 19, 2009 | 1991 Honda Prelude

1 Answer

Engine will not shut off

Not exactly sure, but I believe is the ignition indide the distrubitor. It's out of timing.

Jan 11, 2009 | 1991 Honda Prelude

2 Answers

Spark plug gaping

Go to your nearest Autozone or other parts house and buy an inexpensive plug gapper. I gap the Honda plugs at .045 .

Jun 16, 2008 | 1991 Honda Prelude

Not finding what you are looking for?
1989 Honda Prelude Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides