Question about Chrysler Concorde

2 Answers

My car overheats to a boiling point .The fans are working.I loose no coolant.There is no white smoke on my exaust.There is a lot of air building up in the system ,because I have to bleed it constantly.No much coolant is coming out of bleeding screw,mostly air.I changed the thermostat,still no luck.It seems there is no pressure on coolant.Could this be a problem with the water pump?Please help!!!! Thank you.Frank

Posted by on

  • 1 more comment 
  • Frank Sedlacek
    Frank Sedlacek Jul 27, 2008

    There isw no bubling in the reservoir.Bubbling occours only when motor is hot and only from bleeding screw.


  • wulffman Aug 13, 2008

    pushes water out .no white smoke .fans and limit relay,s all working.dosn, pressure tell it is hot.the bubbles like head gasket. but when filled back up with water ok tell it gets low from leaking out psi. body valve on top is corrotid shut.should i brake loose?

  • tairy wairy Sep 30, 2008

    i have the same problem, my car is overheat all the time, i loose water or coolant i dont know what i do please help me ok. and i change the radiator and the thermostat and still the same problem



2 Answers


Posted on Aug 08, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 63 Answers

If you fill the car with anti freeze when it is cold and start it up with the cap off and its bubbling in the radiator that fast it has a bad head gasket.You can buy a kit at the parts store to confirm this.It made to detect hydro carbins in the coolant.Let me know what you find out Thanks...Dan

Posted on Jul 27, 2008

  • Dan Dubay Jul 27, 2008

    You may just have more air in the system. You need to have the car cold and open the air bleeds. Fill the system till all anti freeze is coming out of the air bleeds. Replace the radiator cap also and see what it does from there. Let me know. Thanks Dan



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2006 Pontiac Torrent..3.4 engine

Did anyone make sure the engine cooling fans work/ came on? This is my first check, unless it is obvious that the head gaskets are blown(lots of white smoke out the exhaust).

Aug 05, 2016 | 2006 Pontiac Torrent

1 Answer

Head gasket repair cost

If it's spraying out of the spout and is boiling, it's very possible that one of the head gaskets blew depending on how long it takes to overheat.

A few things to look for:
Inspect the radiator. Make sure all of the cooling fins are there, and not obstructed by dirt/debris.
Make sure the cooling fan is turning on (it should turn on when the temperature is approximately at the halfway point of the temp gauge).
Look at the color of the "smoke" coming from the tailpipe. White = steam. Some steam is normal, however, if it's constant, and a lot of it, it's a blown head gasket indicator.
Blue = burning oil. Black = unburned fuel,

May 07, 2014 | Infiniti FX35 Cars & Trucks

1 Answer

My Mitsubishi eclipse overheats in heat mode and the fans shut off that cool the engine. What do I do?

Defrost is turning the fans on so there is probably an issue with the fan controls on the car.

Dec 01, 2012 | 2003 Mitsubishi Eclipse Coupe

1 Answer

97 seville overheats slowly and loses quite a bit of anti-freeze but not smoking,or mixing in the oil and not steaming uot of the exhast.

My first guess would be the cooling system has some air in it from the radiator job, or the thermostat may be sticking.
You say it is loosing coolant, so you are putting coolant in every day or week ? Is it loosing it on the ground when it overheats ?
If you are adding coolant but not seeing it boil over, it could be burning it and you would not see smoke from the exhaust.

Jul 09, 2012 | 1997 Cadillac Seville

1 Answer

Car engine is over heating

You didn't include enough info to really help but most times overheating is caused by low coolant level from an external leak, a failed or failing thermostat, a bad radiator fan (electric or clutch type) or fan relay, coolant sensor etc. Any obstruction to air flow through the radiator or internal obstruction can also cause an overheat. Last but not least, either too much water or coolant can lower the boiling point. Make sure you have a 50/50 mix and a good pressure cap of the correct pound rating. (I think yours is rated at 16-19psi)
If you see white smoke from the tailpipe even after warm up, you may have a blown head gasket. In that case you'd need to take care of that but should also find the initial cause (any of the above).
When doing any testing be very careful...opening a system even when not in overheat can cause hot antifreeze to come out quickly and with force. (can make for very bad burns)
If you narrow down the problem a bit and need more specific info, just ask.

Jul 14, 2010 | 2003 Jeep Grand Cherokee

2 Answers

I have a 97 Plymouth Neon 4 cyl SOHC. I recently bought it and it keeps overheating. I replaced the thermostat, temp coolant sensor, radiator cap, and flushed the radiator twice. I also took it to a shop...


May 11, 2010 | Plymouth Neon Cars & Trucks

3 Answers

1982 Landcruiser, overheating

I would suggest to check to make sure the fan is not on backwards. I dont know if its possible to even put it on backwards. just check to make sure that the fan is pulling air thru the grill instead of blowing out the grill. Also look into the radiator and see if you can see any lime or sediment in the radiator tubes. It will be white in color.A small amount of scale on the inside of the tubes act as insulation, and keeps the coolant from contacting the tubes and transfering the heat to the tubes so the air passing across the radiator can carry it away. Just flushing the radiator wont remove the lime scale, the radiator would need to be remove and dissassembled and rodded out. I dont think you have a blown head gasket yeti,if it not blowing water out when its cold and you dont have any performance problems, runs fine, just overheats. You might try turning on the heater when it starts to overheat and turn the heater fan on high as it acts as a radiator and see if it cools down indicating the cooling capacity of the radiator is diminished

Aug 21, 2009 | 1983 Toyota Land Cruiser

2 Answers

Car is over heating even though it doesn't show on the gauge

check for air in the system,as it will give a reduced water volume to the coolant temperature sender. there is also a fan switch on the rad that turns on the cooling fan,if your fan does not come on it will overheat.
look for green around the coolant sensor,as it mayn be leaking and drawing in air

Aug 19, 2009 | 1990 Lexus LS 400

2 Answers


Having the radiator rodded is a good move. Retest. If it has an electric radiator fan check temp sensors. If the fan has a clutch it may need to be replaced if its slipping with the engine hot. Check bellts. Its likely a fan air flow issue if the engine overheats when the care is not moving or is moving slowly. If the engine overheats only with AC on that narrows it down. Write back if that's the case. Lots of things can cause this. Antifreeze and a good radiator cap discourages boiling. Pressure in the radiator raises the boiling point but it can't build up pressure if the cap is bad. Antifreeze also raises the boiling point. If actual boiling happens in the engine then steam builds up in critical places and drives the collant out of the block making the engine even hotter than it already is. Replace the cap. Check the antifreeze.

Jan 03, 2009 | 1991 Toyota Pickup

3 Answers

My truck blows white smoke

There are two differnt reasons for black and white smoke coming from the tail pipe.
Black smoke means fuel runs rich (car getting to much gas). Check fuel pressure/air filter.
In some cases the white smoke means car is burning oil or transmittion fluid. Have tem checked/replaced.
If you can feel a smelly smoke it can be catalytic converter.
In a worsest scenario if car blowing white smoke it can be engine coolant is getting into an engine cylinder from a bad head gasket ,or a warped/cracked head. So you need to keep your eye on coolant level and check your engine for overheat. Also might be good to check your oil for traces of coolant (on a dipstick it would be a milky substance mixture of oil and coolant).
Good Luck

Dec 06, 2008 | 2006 Ford F-250 Super Duty

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

471 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides