Question about 1988 Chevrolet Corsica

1 Answer

95 Chevy Corsica 2.2L

Hi all,

the POS starts, runs (if you want to call it that) pops and chokes and then dies. Any suggestion as to where to start looking. As a side note, I just changed the fuel pump a few months ago. Has been running fine until Friday when this started. Any help will be greatly appreciated.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Have you been smelling rotten eggs or seeing black smoke out the exhaust?

Posted on Sep 23, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 650 brute force wont start unless hooked to battery booster neg on battery pos on hot wire it will run when I touch it to pos on the battery it dies like a kill switch


Can you break down your paragraph ? Not sure I understand which cable is connected to where. Please be a bit more detailed to give you a better suggestion as to possible problems and repairs.

Nov 12, 2016 | Cars & Trucks

2 Answers

Hi , my engine start and then stops after 5 seconds and it is not the relay of the pump for gas or ecu


I suggest disconnecting the mass airflow sensor and see if the car idles. If the car starts then you have a bad sensor. The next step would be to inspect data on scantool and look for scewed coolant sensor reading . coolant sensor readings should not fluctuat. Good luck

Jun 26, 2015 | 1986 Nissan 300ZX

1 Answer

Starts but wont run after ignition switch is returned to the run position from the start position.


The problem is that when you have the switch in the START position, you are getting power to the ignition system, but not when in the RUN position. Most likely causes are a bad ignition switch, a faulty aftermarket alarm system [if it has one] or a bad ballest resistor wire going to the ignition coil's + terminal. You need to break out your test light and start checking to see where the fault lies.

Jul 14, 2014 | 1981 Ford F 150

2 Answers

Took battery out of my 1993 buick riviera,put back in now starts then dies


how did you disconnect the battery, pos first then neg ? or neg first then pos ? try starting it and after started, hold your rpm at 1500, for about two minutes, then if still running, drive it to get to.speeds of 40 for about 15 minutes, this is to relearn if not, disconnect your battery, take the pos and neg cable and touch them together and hold for about a minute, then Connect them back, neg.first.then pos, then follow steps above to.relearn.

Dec 09, 2013 | 1993 Buick Riviera

1 Answer

1995 toyota tacoma 2.7 ,I have put a new fuel pump,fuel filter, disturbuter, ignition modul, runs great sometimes then will just start to die and choke down as if no gas or no fire


Sounds like you may need a fuel pressure regulator. These are an often over looked culprit for the problems your vehicle is experiencing. After replacing the mentioned parts and components, The fuel pressure regulator would be the next thing to look at. A side note: it is never a good idea to just throw parts in trying to find the problem. Always use the process of elimination. Most often the problem is minor.

Oct 21, 2013 | 1995 Toyota Tacoma

1 Answer

Keeps dying


You will need to figure out if you are loosing spark or fuel when it stops running. Each system has its own group of tests to run to find the cause.
Is the check engine light staying on ?

Aug 27, 2013 | Chevrolet Corsica Cars & Trucks

1 Answer

Vehicle seems to not be getting enough gas because it chokes up when u accelerate and dies when you put it in gear


it could be the pickup screen in the tank is clogged from dirt in the tank being stirred up when you ran it dry then put gas in you will have to drop the tank to look at it or dirt could have made it to your injectors or throttle body

Oct 04, 2012 | 1995 Chevrolet K1500

1 Answer

97 sw2 1.9 saturn wont start


You need to check your ing switch if it's starting fine right then when you let go of the key so it;s in the run pos and it dies. check the switch.

Jan 01, 2012 | 1999 Saturn SL

1 Answer

I have a 95 chevy corsica. It will run good on highway but when i stop it dies and i have to let it sit for about 15 min and it will start . Now it wont start at all. it will turn over but no...


So what it sounds like, is that your not getting any fuel. More than likely your fuel pump died and you will need to get this replaced. You can have a friend or relative lay under the car and hit the underside of the gas tank with a rubber mallet; sometimes this will jiggle the fuel pump enough to allow gas flow. If this works, you could make it to your local repair shop to have it replaced.

Aug 30, 2011 | 1995 Chevrolet Corsica

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

172 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...