Question about 2001 Chevrolet S-10

1 Answer

Troublecode P0141 Problem code is Oxygen Sensor Bank 1 sensor 2, where and which sensor is this, truck has sluggish performance, is this likely cause ?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

I replaced mine and come to find out my Catalytic converter was bad. If you have under 60,000mi. take it to your dealer Emission products are covered. Bank 1 sensor two is the one nearest the rear of truck under cab. The o2 sensors are the same. After 60 miles the check engine light will go off on its own... Or you can unplug the battery over night and it will turn back on after 60mi. if problem persist. And yes this can cause power loss


....Hope this helps

Posted on Jul 30, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

97 Cadillac deville all four 02s keep coming back after repairs was made P0135, 0138, 0141, 0155,or could it be the coil packs


all of those codes listed have a common fault listed and that is the ECM
substitute it with a known good unit and then see what happens

Sep 05, 2016 | 1997 Cadillac DeVille

1 Answer

Codes p0054 p0141 p0036


code p0054 is
Possible causes - Faulty Heated Oxygen Sensor Bank 1 Sensor 2
- Heated Oxygen Sensor Bank 1 Sensor 2 harness is open or shorted
- Heated Oxygen Sensor Bank 1 Sensor 2 circuit poor electrical connection
When is the code detected?Heater current requirements too low or high in the heated oxygen sensor (HO2S) heater control circuit Symptoms- Engine Light ON (or Service Engine Soon Warning Light)
code p0141 is O2sensor heater circuit malfunction( bank one sensor 2)
there is chance that wire from that sensor is touching,part of your exhaust system,and either is open or shorting to ground

code p0036
036 - HO2S Heater Control Circuit Bank 1 sensor 2check the wire from the sensor for the sign cut or melting,and change the sensor

Apr 18, 2013 | 2006 Chevrolet Suburban 1500

2 Answers

What does the codes p0442,p0136 &p0141 mean on my 2001 ford taurus it failed inspection for these codes


P0442 FORD - Evaporative Emission System Leak Detected Small Leak

Possible causes- Missing or loose fuel cap
- Incorrect fuel filler cap used
- Fuel filler cap remains open or fails to close
- Foreign matter caught in fuel filler cap
- EVAP canister or fuel tank leaks
- EVAP system hose leaking
- Fuel tank leaking
P0136 - O2 Sensor Circuit Malfunction Bank 1 Sensor 2
Possible causes- Rear Heated Oxygen Sensor Bank 1 harness is open or shorted
- Rear Heated Oxygen Sensor Bank 1 circuit poor electrical connection
- Faulty Rear Heated Oxygen Sensor Bank 1
- Inappropriate fuel pressure
- Faulty fuel injectors
- Intake air leaks may be faulty
- Exhaust gas leaks

P0141 FORD - O2 Heater Circuit Bank 1 Sensor 2

Possible causes- Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit fuse
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit open shorted to ground
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit poor electrical connection
- Faulty Engine Control Module (ECM)

Sep 27, 2012 | 2001 Ford Taurus

1 Answer

Error codes p0141 on ford windstar 2002


Hi there:


P0141 - O2 Sensor Heater Circuit Malfunction (Bank 1, Sensor 2)
This code means that the heated circuit in the oxygen sensor on bank 1 decreases time needed to enter closed loop. As the O2 heater reaches operating temperature, the oxygen sensor responds by switching according to oxygen content of the exhaust surrounding it. The ECM tracks how long it takes for the oxygen sensor to begin switching. It the ECM determines (based on coolant temp) that too much time elapsed before the oxygen sensor began operating properly, it will set P0141. See also: P0135 (Bank 1, Sensor 1).



A code P0141 may mean that one or more of the following has happened:



open or short to ground in the wiring harness
O2 heater circuit wiring high resistance
O2 heater element resistance is high
Internal short or open in the heater element
Note: Typically a failed catalytic converter does not cause this code. You're more likely to see a P0420 code for a failed converter.


Use this link on previous answer to check diagra location.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Aug 22, 2012 | Ford Windstar Cars & Trucks

1 Answer

Code p0141


P0141 - O2 Sensor Heater Circuit Malfunction Bank 1 Sensor 2
Possible causes- Faulty Rear Heated Oxygen Sensor Bank 1
- Rear Heated Oxygen Sensor Bank 1 harness is open or shorted
- Rear Heated Oxygen Sensor Bank 1 circuit poor electrical connection
- Inappropriate fuel pressure (to high)
- Faulty fuel injectors
- Intake air leaks
- Exhaust gas leaks

Jun 27, 2012 | Cars & Trucks

1 Answer

I have Nissan Altima 2001 running 93500 K. since last a week service engine soon light on and showing P0141 & 0325 codes. What is the fix for P0141 and P0325 error codes.


p0325 = bank 1 sensor 2 oxygen sensor p0141 = knock sensor
if it were me you could watch the sensor on a scanner to see if working properly but without a scanner i'd replace the oxygen sensor bank 1 = passenger side
sensor 2 is sensor behind the catalictic converter screwed in

good luck

Jun 27, 2011 | Nissan Altima Cars & Trucks

1 Answer

What is diagnostic procedures for DTC p0135 & p0141


Oxygen Sensor problems... P0135 (Bank 1, Sensor 1) and P0141 (Bank 1, Sensor 2)

P0135 - Oxygen O2 Sensor Heater Circuit Malfunction (Bank 1, Sensor 1)
This code refers to the front oxygen sensor on Bank 1. The heated circuit in the oxygen sensor decreases time needed to enter closed loop. As the O2 heater reaches operating temperature, the oxygen sensor responds by switching according to oxygen content of the exhaust surrounding it.

The ECM tracks how long it takes for the oxygen sensor to begin switching. It the ECM determines (based on coolant temp) that too much time elapsed before the oxygen sensor began operating properly, it will set P0135.

Symptoms: You will likely notice poor fuel economy the illumination of the MIL.

Causes: A code P0135 may mean that one or more of the following has happened:
O2 Heater element resistance is high
Internal short or open in the heater element
O2 heater circuit wiring high resistance
open or short to ground in the wiring harness

Possible Solutions:
Repair short or open or high resistance in wiring harness or harness connectors
Replace oxygen sensor (cannot repair open or short that occurs internally to sensor)



P0141 - O2 Sensor Heater Circuit Malfunction (Bank 1, Sensor 2)
This code means that the heated circuit in the oxygen sensor on bank 1 decreases time needed to enter closed loop. As the O2 heater reaches operating temperature, the oxygen sensor responds by switching according to oxygen content of the exhaust surrounding it. The ECM tracks how long it takes for the oxygen sensor to begin switching. It the ECM determines (based on coolant temp) that too much time elapsed before the oxygen sensor began operating properly, it will set P0141.

Symptoms: You will likely notice poor fuel economy the illumination of the Check Engine Light.

Causes: A code P0141 may mean that one or more of the following has happened:
open or short to ground in the wiring harness
O2 heater circuit wiring high resistance
O2 heater element resistance is high
Internal short or open in the heater element

Note: Typically a failed catalytic converter does not cause this code. You're more likely to see a P0420 code for a failed converter.

Possible Solutions:
Replace oxygen sensor (cannot repair open or short that occurs internally to sensor)
Repair short or open or high resistance in wiring harness or harness connectors


Hope this helps (remember to rate this answer)..

May 11, 2011 | 2000 Nissan Maxima

1 Answer

Engine Light on --Scaning appeare Code 0141


P0141 - O2 Sensor Heater Circuit Malfunction (Bank 1, Sensor 2)
This code means that the heated circuit in the oxygen sensor on bank 1 decreases time needed to enter closed loop. As the O2 heater reaches operating temperature, the oxygen sensor responds by switching according to oxygen content of the exhaust surrounding it. The ECM tracks how long it takes for the oxygen sensor to begin switching. It the ECM determines (based on coolant temp) that too much time elapsed before the oxygen sensor began operating properly, it will set P0141. See also: P0135 (Bank 1, Sensor 1).

Symptoms
You will likely notice poor fuel economy the illumination of the Check Engine Light.

Causes: A code P0141 may mean that one or more of the following has happened:
* open or short to ground in the wiring harness
* O2 heater circuit wiring high resistance
* O2 heater element resistance is high
* Internal short or open in the heater element

Note: Typically a failed catalytic converter does not cause this code. You're more likely to see a P0420 code for a failed converter.

Possible Solutions
* Replace oxygen sensor (cannot repair open or short that occurs internally to sensor)
* Repair short or open or high resistance in wiring harness or harness connectors

Hope helps (remember to rate this answer).

Apr 05, 2011 | 2003 Acura RSX

1 Answer

Code # P0141 and P0138


You said you changed the O2 sensors, which ones? I do believe that sensor 2 is the Catalyst efficiency monitor, it looks like an O2 but it's function is different. This sensor is behind the Catalytic converter, the O2 is in front. Bank one is the bank that # 1 cylinder is on, so the sensor that is defective is the 2nd sensor back on that sides exhaust pipe.

P0141 - Heated Oxygen Sensor (HO2S) Heater Performance Bank 1 Sensor 2

P0138 - Heated Oxygen Sensor (HO2S) Circuit High Voltage Bank 1 Sensor 2

Oct 26, 2008 | 1998 Jeep Grand Cherokee

1 Answer

Trouble codes


P0108 - Manifold Absolute Pressure (MAP) Sensor Circuit High Voltage,
Possiable MAP sensor defective

P0134 - Heated Oxygen Sensor (HO2S) Circuit Insufficient Activity Bank 1 Sensor 1
P0141 - Heated Oxygen Sensor (HO2S) Heater Performance Bank 1 Sensor 2 , I recommend you replace both O2 sensors, bank 1 and bank 2

Oct 13, 2008 | 1996 Pontiac Grand Am

Not finding what you are looking for?
2001 Chevrolet S-10 Logo

Related Topics:

167 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74418 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22082 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7254 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...