Question about Chevrolet Camaro

Open Question

1994 CAMARO WONT SHIFT AT PROPER RPM. hAVE TO LIFT OFF GAS TO GET IT TO SHIFT.

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Molson02536
  • 3854 Answers

SOURCE: tramission prom

Take it to a transmission shop that has a Tech 2 scanner. The tech 2 scanner will not only scan the transmission but can also recalibrate the shift points. Other reason to why it wont shift under WOT it low transmission fluid pressure so check the fluid level and have a pressure test done on the line.
The 4L60E is a great transmission but there are some things that don't work well with them like some shift kits. The ECM is program the shift points which get's messed up if done wrong. best upgrade on the 4L60E was to swap out the servos for corvette servos or after market performance one's all for under $100.00 and in most case better then a after market shift kit.
Good luck and hope this help. take care not to burn up the transmission.

Posted on May 26, 2009

Ad
m036_094
  • 107 Answers

SOURCE: 1994 camaro wont start security light blinking

try locking and unlocking the drivers door with the key. hope this helps. mike

Posted on May 29, 2009

  • 10 Answers

SOURCE: runs rough, wont start at proper timing setting

usually when the camaro runs rough that could be bad fuel injectors-o2sensor and fuel filter-thats my guess i had the same problem and i put bad gas in and the fuel filter went bad

Posted on Feb 17, 2010

  • 1 Answer

SOURCE: My 1994 toyota camry wont

94 camry won't shift into overdrive

Posted on Jul 16, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Wont idle right (sometimes wont start unless put gas in the throttle bottle). Transmission wont shift until get rpm s high. All this happened after removing and installing engine again.


make sure all vacuum lines are connected properly and there are no pinched fuel or air lines. Also make sure all electrical connectors are properly installed.

Nov 29, 2015 | 1994 GMC Sierra

1 Answer

Troubleshooting rpm problems


You mean 4,000 rpm . No engine goes 40,000 rpm . senor on the transmission that control the rpm. No SENSOR on the transmission ! Crank sensor's Take it to someone who has a tool like in the video an knows what he is looking at .
Ignition Scan data

Jun 17, 2017 | 1994 Buick Regal Gran Sport

1 Answer

1994 camaro Z28 Convertable automatic. When driving when you release the gas pedal there is no engine braking. Engine will return to idle instanly. At all RPM's. Transmission shifts smooth during...


I'd hazard a guess that the torque converter disengages from "lock up" when you lift your foot. This would let the engine instantly idle down, and would produce no braking effect from a closed throttle.

Try driving it (at a lower speed) in direct, rather than overdrive, and see if the same thing occurs, or if you get the expected braking effect when you lift your foot off the throttle.

Feb 23, 2011 | 1994 Chevrolet Camaro

1 Answer

My camaro with a 3.1 i can start it up but won go over 1500 rpm


check throttle position sensor for proper setting and make sure map sensor is vacuum connected and functioning. hopefully the owner replace the fuel filter when they changed the pump.

Apr 26, 2010 | 1990 Chevrolet Camaro

1 Answer

Runs rough, wont start at proper timing setting


usually when the camaro runs rough that could be bad fuel injectors-o2sensor and fuel filter-thats my guess i had the same problem and i put bad gas in and the fuel filter went bad

Dec 16, 2009 | 1992 Chevrolet Camaro

2 Answers

Cannot remove shift knob on 2002 camaro z28 with automatic


Should be a U shaped clip on the front of the knob that you have to pull out then the knob will lift off

Jul 28, 2009 | 1994 Chevrolet Camaro

1 Answer

Tramission prom


Take it to a transmission shop that has a Tech 2 scanner. The tech 2 scanner will not only scan the transmission but can also recalibrate the shift points. Other reason to why it wont shift under WOT it low transmission fluid pressure so check the fluid level and have a pressure test done on the line.
The 4L60E is a great transmission but there are some things that don't work well with them like some shift kits. The ECM is program the shift points which get's messed up if done wrong. best upgrade on the 4L60E was to swap out the servos for corvette servos or after market performance one's all for under $100.00 and in most case better then a after market shift kit.
Good luck and hope this help. take care not to burn up the transmission.

May 26, 2009 | 1994 Chevrolet Camaro

1 Answer

I unbolted my gas tank but it wont come off the


disconnect tank fill neck,
supply and return lines,
electrical connection for fuel pump...

Feb 22, 2009 | 1994 Chevrolet Camaro

1 Answer

Fuel problems camaro


sounds like a fuel regulator. probily need new spark plugs also

Sep 09, 2008 | 1994 Chevrolet Camaro

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...