Question about Chevrolet Tahoe

1 Answer

Intake manifold for 97 chevy tahoe - Tahoe Chevrolet Cars & Trucks

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 74 Answers

Are you trying to locate one or replace it

Posted on Jul 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 chevy tahoe runs rough with a shake


A high idle is common with a vacuum leak. Ive done plenty of chevy intake manifold gaskets due to the gasket failing.

Jan 21, 2014 | 1997 Chevrolet Tahoe

2 Answers

Where the speed sensor located at in a 2005 chevy tahoe


The sensor is in the side of the transmission where the speedo cable once was.

Feb 22, 2013 | 2005 Chevrolet Suburban

2 Answers

IS THE INTAKE ON A 97 CHEVY TAHOE METAL OR PLASTIC


the upper intake is plastic the lower intake is aluminum

Jul 28, 2011 | 1997 Chevrolet Tahoe

1 Answer

Location of knock sensor on 2004 chevy tahoe


Either on the passenger side of the engine, below the second exhaust port.Or underneath the intake manifold.

Dec 29, 2010 | 2004 Chevrolet Tahoe

1 Answer

Resealed intake manifold on 1997 chevy tahoe.truck now is a no start .good fuel pressure. timiinng dead on,good spark. any ideas


make sure oil sending unit is plugged in check for vacuum leak between two piece manifold pull spark plugs after trying to start look for wet gas foul

Feb 21, 2010 | 1997 Chevrolet Tahoe

1 Answer

Knock sensor for 05 chevy tahoe


remove the intake manifold ,remove radiator ,remove radiator intake and outake housing, remove fan ,remove all belts: power steering, alternator and if you have a/c, remove harmonic balancer ,remove timing belt covers, remove timing belt remove intake housinng once you have remove all the above, your freaken engine will look naked, you can see the location of the knock sensor is locate in the engine valley

Jan 06, 2010 | 2004 Chevrolet Tahoe

2 Answers

My 1999 chevy tahoe is leaking antifreeze. I


it could but- check passenger side front where heater core line go into manifold right behind alternator the hose line is connected by a press clip into an alloy fitting this fitting gets eaten away by anti freeze and hose angle pulls back on fitting the part is $18 at dealer and is screwed into manifold use caution if ur r going to replace at very edge of aluminum manifold---and check ur water pump bolts the 2 longer ones should have a lock sealant on them they bolt in thru a water jacket

Oct 24, 2009 | Chevrolet Tahoe Cars & Trucks

1 Answer

Ase describe your where is the fuel pressure


If you look at the top of the upper intake manifold plenum with the air intake duct work off you will see 2 shiny fuel tubes that feed into the fuel meter body. The fuel meter body also has an electrical connector right in the middle of it. The pressure regulator is mounted on the side of that body. You'll have to remove the upper intake manifold manifold to replace it. Before you do that, be sure to bleed the pressure off the fuel system.

Aug 31, 2009 | 1997 Chevrolet Tahoe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

233 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...