Question about Alfa Romeo GTV6

1 Answer

Unknown swap, the coil shuts off during cranking

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 47 Answers

Sounds like a wiring fault , check the leads from the small panel on the rear bulkhead which has a push on cover on it.

Posted on Mar 18, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 neon cranks won't start changed crank cam sensors also the coil pack still no fire to plugs


Possible ASD relay? This is an auto shut down feature for many dodges and can cause a lot of problems. Ensure all fuses are good as well. Just swap a relay from another position into the ASD spot. Use a relay that is not used to start the vehicle.

Mar 18, 2016 | Cars & Trucks

1 Answer

Where is the crank position sensor on a 98 chevy malibu 2.4L? Also what is more apt to be bad, the crank position sensor or the camshaft position sensor?


If it is either sensor you will get a check engine light. So check this, A faulty fuel pump relay can cause the car to come to a complete stop while driving, its like running out of gas. It may be getting hot and shutting fuel pump down. Try swapping another relay of the same size, For the pump to see if its a bad relay. It may be is shutting the fuel pump down, when it gets hot.


Sep 13, 2014 | 1998 Chevrolet Malibu

2 Answers

My car shuts down while i'm drivng it. After sitting for a minute it will restart. But only after sitting for a minute.


Sounds like your ignition coil is failing. Eventually it wont start at all Common problem

Jun 15, 2012 | 1993 Mazda MX-6

2 Answers

I have a 02 dodge grand caravan sport with 0351,0352,0700 codes...car runs good then shakes and even stalls at times,but not all the time...i have replaced ignition coil,wires,plugs,and catalytic...


po700 code just means you have codes
P0351-IGNITION COIL #1 PRIMARY CIRCUIT

WHEN MONITORED
With battery voltage greater than 8 volts during engine cranking or greater than 13 volts with engine running. Engine RPM less than 3000. No coil in dwell during test.

SET CONDITION
Peak current is not achieved with battery based dwell plus 1.5 msec of diagnostic offset. It takes less than 3 seconds during cranking or up to 6 seconds while running to set.

POSSIBLE CAUSES
- Ignition coil
- Intermittent condition
- ASD relay output circuit
- Ignition coil driver circuit open
- Ignition coil driver circuit shorted to ground
- PCM

P0352-IGNITION COIL #2 PRIMARY CIRCUIT

TEST NOTE
This symptom is diagnosed using the test P0351-IGNITION COIL #1 PRIMARY CIRCUIT.

WHEN MONITORED
With battery voltage greater than 8 volts during engine cranking or greater than 13 volts with engine running. Engine RPM less than 3000. No coil in dwell during test.

SET CONDITION
Peak current is not achieved with battery based dwell plus 1.5 msec of diagnostic offset. It takes less than 3 seconds during cranking or up to 6 seconds while running to set.

POSSIBLE CAUSES
- Ignition coil
- Intermittent condition
- ASD relay output circuit
- Ignition coil driver circuit open
- Ignition coil driver circuit shorted to ground
- PCM
var classElements = new Array(); var node = document; var tag = 'a'; var els = node.getElementsByTagName(tag); var elsLen = els.length; var pattern = new RegExp("(^'\\s)specs_note(\\s'$)"); for (i = 0, j = 0; i
var classElements = new Array(); var node = document; var tag = 'a'; var els = node.getElementsByTagName(tag); var elsLen = els.length; var pattern = new RegExp("(^'\\s)specs_note(\\s'$)"); for (i = 0, j = 0; i

Jun 14, 2011 | 2002 Dodge Grand Caravan

1 Answer

Vehicle shuts down after reaching operating temperature


In side the left corner of the glove box is a cover....remove the cover and you will see 2 square relays...swap these one for the other and then try....these relays will fail..and when it does overheat it WIll shut the engine down.

Aug 23, 2009 | 1995 GMC Jimmy

1 Answer

2002 2.4 eclipse will spin but not crank.


yep its the crank shaft sensor, had the same problem with my pos

Mar 14, 2009 | 2002 Mitsubishi Eclipse

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Alfa Romeo Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

yadayada
yadayada

Level 3 Expert

63801 Answers

Fabrice Wolters

Level 2 Expert

162 Answers

Are you an Alfa Romeo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...