Question about 1997 Buick LeSabre

1 Answer

Exterior lights and door locks

Turn signals keep blowing fuse and now automatic doors lock/unlock.

Posted by on

  • Anonymous Mar 12, 2014

    Keep blowing fuses to break lights and turn signals. Water in driver side back beak lights.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 67 Answers

Wiring short. You'll have to replace the wire.

Posted on Aug 27, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2005 Chevy Equinox Driver & Passenger Door Unlock Relay. How To Remove & Install. They Are Power Locks. Front Doors Must Roll Windows Down Use Hand To Open Thanks. Ms. J. C.


Door Lock and Unlock Operation
When a door lock switch is activated in the lock or unlock position the BCM will receive a voltage signal on either the door lock switch lock or unlock signal circuits.
The BCM, upon receipt of a lock switch lock or unlock signal, will switch the appropriate lock relay control circuit(s) to battery positive voltage. This will energize the appropriate lock or unlock relay(s). The relay will supply voltage to the door lock actuator lock or unlock control circuits to one side of the lock actuator. Since the opposing side of the lock actuators are connected to ground through the other lock actuator control circuit and the normally closed contacts of the lock or unlock relay, the doors and liftgate will then lock or unlock appropriately.
Three relays are used to operate the lock. Driver door unlock, passenger door unlock and all door lock. This is done to isolate the driver door lock actuator so it can be unlocked by itself using the keyless entry transmitter.
Your door locks are controlled by the BCM - body control module (a computer ) . An a scan tool is a must to diagnose system operation . Your best bet would be to take your vehicle to a qualified repair shop . The only way you could try to fix this is by changing parts ! Suppose you find an replace a door lock/ unlock relay an that doesn't fix it ? There could be DTC'S stored in the BCM . Do you know what a DTC is ?
?€¢
DTC B3132 All Door Unlock Circuit Low


?€¢
DTC B3133 All Door Unlock Circuit High




Your

Aug 10, 2016 | Cars & Trucks

1 Answer

Mercedes-benz slk 32 amg blows fuse 25 doors will not lock remotely


There's a wiring short or earthing problem somewhere on the fuse 25 circuit.

You can spend a lot of time trying to track down a wiring fault. My honest advice would just be to take your car to an auto electrician and let him sort the problem out.

Mar 12, 2016 | 2002 Mercedes-Benz SLK-Class

1 Answer

My right side passenger door does not lock automatically anymore. Is there a fuse that operates this.


no all is related to one fuse you can remove the door internal controls and decore and remove center lock motor plug and test two connectors with multimeter with set on 12v and then lock un lock door and check the reading of the multimeter if it read signal then all plugs and wires from central lock control unit to the door central lock unit is okay it this cae you have to replace the door central lock unit with the same if no signal is readed while you lock unlock the door then you have to check central control unit and all wire plus out of it to the door plug

2- you can remove central control unit from driver door and test it in passenger door (usually the same unit ) if it works with lock unlock its then the replaced unit is faulty and needs to be replaced if it not work then check plugs wires from central lock unit (usually found inside driver door ) to the central lock unit in passenger door

3- check signal for said door fro the output of central door unit if no signal then it mean that faulty central lock control unit

Feb 23, 2015 | 2005 Honda Accord

1 Answer

Why does my 2002 jeep liberty keep blowing the #34 fuse?


This is most likely a short in one of the door wires. It could be very hard to locate.

Jul 28, 2014 | 2002 Jeep Liberty

1 Answer

Why key fob wont unlock doors neither will windows roll down or radio turn off when opening door is it a security module?


Yes. Or it could be a loose wiring problem... best bet would be take it to a gm dealer. If not find your fuse box and locate the fuse maybe thats bad.

Jul 17, 2014 | 2002 Pontiac Bonneville SLE

2 Answers

I have a 1998 chevy suburban. The dome lights don't work. checked fuse box under hood. All good. Are there other fuses on the truck?


Instrument Panel Fuse Block
The instrument panel fuse block access door is
located on the driver side edge of the instrument panel.

Pull off the cover to access the fuse block.

The vehicle may not use all of the fuses shown.

Fuses Usage
1 Rear Seats
2 Rear Accessory Power Outlet
3 Steering Wheel Controls Back light
4 Driver Door Module
5 Dome Lamps, Driver Side Turn Signal
6 Driver Side Turn Signal, Stop lamp
7 Instrument Panel Back Lighting
8 Passenger Side Turn Signal, Stop lamp
9 Passenger Door Module, Driver Unlock
10 Power Door Lock 2 (Unlock Feature)
11 Power Door Lock 2 (Lock Feature)
12 Stop lamps, Centre High Mounted Stop lamp
13 Rear Climate Controls
14 Power Mirror
15 Body Control Module (BCM)
16 Accessory Power Outlets
17 Interior Lamps
18 Power Door Lock 1 (Unlock Feature)
19 Rear Seat Entertainment
20 Ultrasonic Rear Parking Assist, Power Liftgate
21 Power Door Lock 1 (Lock Feature)
22 Driver Information Centre (DIC)
23 Rear Wiper
24 Cooled Seats
25 Driver Seat Module, Remote Key less Entry System
26 Driver Power Door Lock (Unlock Feature)

Aug 23, 2011 | Chevrolet Suburban 2500 Cars & Trucks

1 Answer

The automatic locks are not working and the turn signals are no longer blinking. They just stay lit. I have checked the fuses, and there doesn't seem to be a problem.


the turn signal issue is just the flasher unit has gone bad , check under the dash in the fuse panel area for the flasher unit, It just unplugs and you plug the new one back in,
  1. If there is only ONE door lock not working, the problem is more than likely isolated within that particular door, barring some unusual wiring issue.
  2. If all the door locks work with the passenger side door lock switch, but not the driver's door lock switch then the problem is more than likely the driver's switch.
  3. If a single door lock only works in one direction, either to lock or unlock but not both, then the problem is likely to be the door lock actuator.
  4. If ALL door locks work only in one direction, ether to lock or unlock but not both, then the problem is likely to be a bad door lock switch.

Jul 19, 2011 | Mazda MAZDA6 Cars & Trucks

2 Answers

Lost remote to disable alarm on 2000 mercury villager how can i disable it and start my van


If you have the factory alarm system, you can put your key into either door and lock and unlock the door, that signals the computer to deativate the alarm. If you have an aftermarket alarm system installed, it will have to be removed and the wiring that the alarm ties into must be restored to factory design.

Apr 23, 2010 | 2000 Mercury Villager

1 Answer

Remote door locks won't work


There is a flash for the body control module for this problem. You need to go to the dealership to get it performed though.

Mar 07, 2009 | 2005 Dodge Grand Caravan

2 Answers

Keep blowing out auto door lock fuse


You have a short Somewhere. Check inside the Door where the Harness goes into the Doors. It is the Black Flex duct that looks like a Vacuum hose.

Jan 19, 2009 | 2004 Chevrolet Blazer

Not finding what you are looking for?
1997 Buick LeSabre Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6864 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...