Question about 2003 Ford Expedition

1 Answer

Where is my blower motor resistor on my 2003 expedition

Posted by on

  • sjgsr23 Jul 26, 2008

    I know it is behind the glove compartment, just uncertain from there

  • Anonymous Oct 27, 2008

    fan motor seems to work once in a while

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

The blower resistor is located behind the glove compartment inside the cabin. Simply release the glove compartment and this opens the area right to the resistor.

Posted on Feb 14, 2009

5 Suggested Answers

chryslertech
  • 115 Answers

SOURCE: Replacing Blower Motor Resistor

  1. Disconnect and isolate the battery negative cable.
  2. Open the glove box.
  3. Flex both sides of the glove box bin inward near the top far enough for the rubber glove box stop bumpers to clear the sides of the glove box opening, then roll the glove box downward.
  4. Reach through the glove box opening to access and disconnect the instrument panel wire harness connector for the blower motor resistor from the resistor connector receptacle (Blower Motor Resistor).
  5. Reach through the glove box opening to access and disconnect the blower motor pigtail wire connector from the resistor connector receptacle.
  6. Remove the two screws that secure the blower motor resistor to the evaporator housing.
  7. Remove the blower motor resistor from the evaporator housing.80ac4e54.gif

Posted on Mar 08, 2009

pittmanc
  • 194 Answers

SOURCE: where is the heater blower motor resistor located

if you locate the blower motor the rester is the wire that atachec to blower motor fallow wire till you find a circuit bord this is ur resistor

Posted on Dec 06, 2008

USfalcon
  • 175 Answers

SOURCE: Where is the blower motor resistor on a 2003 Chevy Malibu

its close to the blower motor under neath the dash from the passenger side
i hope its help
thanx

Posted on Mar 18, 2009

michigan man
  • 3533 Answers

SOURCE: I need to know the location of the blower motor

under the dash on the passenger or under the hood on the passenger side

Posted on Apr 18, 2009

  • 1 Answer

SOURCE: where in a 2003 Saab 9-3 is the blower motor

Where does the blower motor resistor go on a 2004 saab 9-3 ?

Posted on Dec 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My ac in my 2003 ford expedition only blows out in the front vents , why not in second or third rows?


Check your rear resistors it could have the blower working it's back by the rear door remove cover should right there under blower motor

Mar 25, 2015 | 2003 Ford Expedition

1 Answer

Rear blower motor resistor for 1998 ford expedition


Hello kenthill49,

The blower motor resistor is on the rear right hand side see image below.

netvan_210.png

I hope this helps.

Regards,

Jerry

Aug 28, 2011 | 2003 Ford Expedition

1 Answer

My 2004 Expedition EB front blower motor quit working for a week, then started to work again but works once in awhile. Is it the motor or the resistor?


First thing I would check is the relay in the fuse panel for the blower motor R06.

See page 252 for the diagram with the location of the relay.

2004 Ford Expedition

It may be the motor starting to go also. There is no need to worry about the resistor. The resistor would only be bad if the motor only opereated on one speed, normally high. The resistor does just that it causes resistance in the blower circut to reduce the speed from high.

Hope this helps.

Zeppelinx12

Mar 05, 2011 | 2004 Ford Expedition

1 Answer

Blower Fan Motor Works On High Only


HI this sounds like the blower resistor has failed,it is a very common problem you will find your local dealer will have one in stock. good luck

Aug 25, 2010 | 2003 Ford Expedition

1 Answer

1998 Ford Expedition Fan Blower Resistor Location


It should be located on the blower motor housing under the right side of the dash, it will have wiring connector and 2 screws holding it in.

Jan 09, 2010 | 1998 Ford Expedition

1 Answer

2004 Expedition blower noise


the squirrel cage is probably loose on the blower motor shaft.

here's 2003, don't have 04.

SECTION 412-02: Heating and Ventilation 2003 Expedition/Navigator Workshop Manual
REMOVAL AND INSTALLATION Blower Motor Removal and Installation
  1. Remove the RH lower instrument panel insulator.
  1. Remove the RH scuff plate.
  1. Position the carpet aside.
  1. Remove the blower motor.
    1. Disconnect the electrical connector.
    1. Remove the screws.
    1. Remove the blower motor.

May 22, 2009 | 2003 Ford Expedition

1 Answer

Heat levels..


need new technician.if the blower motor works even with only one speed than the blower motor works and did not need replacement.sounds like blower motor resistor or resistor wiring,when there is a problem with the resistor or wiring you will only have one speed,this way you atleast have heat.so if your tech replaced the blower motor when it worked and did not need replacement then it sounds like he is just throwing parts at it,you have to wonder if he really checked anything.have the resistor and wiring checked and if ok then check the heater control head and wiring.

Nov 06, 2008 | 2001 Ford Expedition

Not finding what you are looking for?
2003 Ford Expedition Logo

Related Topics:

800 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...