Question about 2006 Toyota Sequoia

1 Answer

I have a problem with the trac control, the ligh is on, i dont know how fix it thanks

Posted by on

  • Toyota Ed May 11, 2010

    Did you have the TRAC system scanned? Without a DTC, I cannot help you with your issue. Thanks.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Are your VSC and Tracking lights on, plus check engine light. The check engine light causes the other lights to light up. Take off both battery cables and touch together for 20 seconds and then reconnect. the problem should reset. I had this happen after an oil change it is caused by the mechanics forgetting to reset a computer signal. I hope this works............

Posted on Nov 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cobalt 2009. Traction Control ligh ON Possibles solutions, Please


Traction Control System Indicator
TRAC OFF The instrument panel cluster (IPC) illuminates the TRAC OFF indicator when the following occurs:
?€¢
The electronic brake control module (EBCM) inhibits the traction control system due to a malfunction in the traction control system. The IPC receives a serial data message from the EBCM requesting illumination.


?€¢
The body control module (BCM) detects that the traction control switch has been pressed (signal circuit is low). The BCM sends a serial data message to the EBCM in order to disable traction control. The IPC receives a serial data message from the BCM requesting illumination. The BCM sends a serial data message to the radio in order to activate an audible warning.
you need to have the ( EBCM ) electronic brake control module checked fro codes !

Jan 07, 2015 | 2009 Chevrolet Chevrolet Cobalt LT

1 Answer

My .a.b.s... is on, trac control isnt working, stablity control service light is on, and when im driving i can turn the wheel to 9 o'clock left andtiers dont move. when i reverse it locks my wheels up?...


This is a dangerous problem, dont worry about the abs or trac lite till you get the steering fixed..... Could be a loose steering rack ...when you move the steering wheel that much and the tires dont move you have a serious problem..PLEASE DO NOT DRIVE until you can have someone look under the car it should be vey very easy to see whats wrong Good luck

Aug 26, 2010 | 2005 Pontiac Grand Prix

1 Answer

2002 Ford Explorer Sport Trac. the turn signals click real fast and they dont work and the brake lights dont work either. what could be the problem and how do i fix it?


check the wiring to the rear sockets, including grounds then work your way forward, check the brake light switch then the signal light switch which i figure is bad but no sense replacing till you know everything else is good

May 27, 2010 | 2002 Ford Explorer Sport Trac

1 Answer

Trac off ligh is on what does that mean


traction control button is somewhere on your dash or on or near your shifter on center console its a button that says trac

Mar 29, 2010 | 1997 Pontiac Grand Prix

1 Answer

Is there only 1 computer for the 2000 olds intrigue? if not whick one controls the ABS and TRAC controls. The ABS , TRAC control, brake ans service engine soon lights are.


dont think its computer,but you have one for engine and another for abs/trac and then body computer, scan engine codes and go from there,hope this helps.

Oct 10, 2009 | 2000 Oldsmobile Intrigue

2 Answers

Ball joint replacement-2003 Ford Sport Trac


if you dont have a ball joint press and dont know how to use one then dont do it, but if you do its not that bad of a job just jack the truck up under the control arm remove the brake rotor then take the lower ball joint nut off then use a pickle fork to break the ball joint loose then take the axle nut off push the axle out of the bearing and use the ball joint press to remove and replace the ball joint

Jul 19, 2009 | Ford Sport Trac Cars & Trucks

1 Answer

ABS light and trac control light off


YOU NEED TO HAVE ABS CONTROLLER SCANNED FOR DIAGNOSTIC TROUBLE CODES..THE SYSTEM HAS DETECTED A FAULT..A GOOD SCAN WILL YOU LEAD DOWN THE PATH TO FIXING THE PROBLEM..YOU CAN SEE IF WHEEL SPEED SENSORS ARE NOT WORKING,IF YOU CAN'T COMMUNICATE WITH CONTROLLER,ETC..LET ME KNOW WHAT IS FOUND

Jun 11, 2009 | 2003 Chrysler Town & Country

1 Answer

Check Traction Control warning light


I can't give you an explanation for why the car is telling you to check trac. control but i can try to give some help on maybe fixing it. Try - turning on the car, turn the traction control off, turn the car off, turn the car on. Then turn the traction control back on and push the system check button. That should i guess "reset" the trac control system.

Now the noise from the front right of the car is MOST LIKELY the air compressor pumping air into the bags. (i own a 97 Continental but i've never had a problem witht the trac control)

Jan 21, 2009 | 1997 Lincoln Continental

1 Answer

Traction Control


traction control selected by driver on or off should light up both ways

Aug 26, 2008 | 1999 Lexus ES 300

Not finding what you are looking for?
2006 Toyota Sequoia Logo

895 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...