Question about 1995 Toyota 4Runner

1 Answer

DIPSTICK LENGTH I HAVE A DIPSTICK IN MY 4 RUNNER THAT IS THE SHORTEST I have ever seen, i am not sure it is the proper one. do you know the length for a 1995 4 runner?

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a 95 Toyota 4-Runner and the dipstick measures 18-1/2" in length.

Posted on Jul 31, 2008

  • Luciano Chitembeni Feb 09, 2014

    Length does not really matter for as long as it reaches the oil pan/sump and measures engine oil levels correctly.



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the dipstick for transmission fluid on Aveo 5 2008 manual transmission?

I've never seen a manual transmission with a dipstick. Even most modern automatic transmissions are sealed units designed to go 200k+ miles without a fluid change. Dipsticks are pretty much a thing of the past.

Manual transmissions almost always have two plugs on a side somewhere... One at the bottom to drain, and another 4 to 6 inches above it to fill. You add fluid until it just starts to dribble out of the fill-hole and put the plug back in. If your manual tranny uses ATF like my T-56 does, I find it easiest to drill a hole in the cap on the fluid bottle and add a grommet from a hardware store and stick in a 3' length of tubing. Now you have a squeeze-bottle making it easy to fill through an inconveniently placed hole in a hard-to-reach place.

Aug 16, 2016 | 2008 Chevrolet Chevrolet Aveo 5 Special...

1 Answer

Whats transmission dipstick legnth to 1999 gmc jimmy

Unusual question. I have never seen a spec for this. Best bet would be to try a salvage yard for a similar trans and either measure theirs, or buy one if yours is lost or broken.. Dealer might be able to give length if you really must know.

May 09, 2015 | 1999 GMC Jimmy

2 Answers

Oil dipstick length

Hi Anthony, I assume your question is 'How long is a dipstick?' If so the answer is the same for 'How long is a piece of string?'. 'However long it needs to be'. The length of a dipstick isn't significant. The markings etched into the dipstick close to the lower end enable you to gauge whether the volume of oil in the reservoir is sufficient to enable proper functioning of the system whether it be the power steering, transmission or engine.

oil-dipstick-length-5g1squqlbq5n4a2ttxnmb3u4-4-0.jpg oil-dipstick-length-5g1squqlbq5n4a2ttxnmb3u4-4-3.jpg

Jan 04, 2015 | Cars & Trucks

1 Answer

Length oil dipstick

That measurement is not found in any book, outside of the factory where it was made.
However, look around at parking lots in the daytime, and find a car just like it, and politely ask the driver if you could please measure their dipstick.
Be blessed.

May 22, 2014 | Nissan Hardbody Cars & Trucks

1 Answer

Plug wires diagram

Place plug wires in order, from shortest to longest on ground beside vehicle, or on a portable work table. Carefully match the length of the shortest one to the shortest on motor. Lay the new wire alongside the old and remove one end of old, attaching the same end of the new one and then do the same to the other end. Fairly simple so far, so repeat this procedure with all the remaining ones one at a time, being carefull to only remove one end at a time, and also be sure of plug wire lengths. Note wires are routed the way that they are to keep them from contacting any hot surfaces or moving parts. Last step: put hands on hips and admire the fine job you just did!

Nov 11, 2013 | 1997 Mercury Mountaineer

1 Answer

Length of dipstick on 98 Oldsmobile intrigue?

Go to a salvage yard & get one

They know the length

Just tell them the motor size

Mar 14, 2013 | 1998 Oldsmobile Intrigue

2 Answers

I need to know where the spark plug wires go back on to. 2001 ford focus 4 straight

2001 Ford Focus 2.0 liter SOHC L4 VIN "P"

Hope this helps (remember rated and comment this).

Sep 06, 2010 | 2001 Ford Focus

1 Answer

Plug wire lengths 94 jimmy

Just buy a new set of wires and use the shortest to the closest spark plug and so on till you have them all connected make sure you follow the proper firing order

Nov 26, 2008 | 1994 GMC Jimmy

1 Answer

Dipstick guide gets bend while torquing

never mind reading the book and working to it ,you are obviously doing it wrong by over tightening it when re-building engines or anything mechanical you work by feel,knowing the metals used and what stress and vibration levels they have to withstand.just tighten it with a small spanner and dont be so heavy handed, firm pull and thats it

Nov 21, 2008 | Isuzu Trooper Cars & Trucks

Not finding what you are looking for?
1995 Toyota 4Runner Logo

Related Topics:

365 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

79851 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides