Question about 1991 Mazda 323

1 Answer

My transnission slips

Hi, from a cold starting position my transmission slips until the temp. guage moves from the dead cold position then every thing is ok for the rest of the day

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 86 Answers

Need to have a service done .sounds like a sticking vavle in the valve body

Posted on Aug 12, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transmission problems


wow jess, 14 posts all the same, a new record here, 4 was record.
you are a texas tornado. if ever.. there was.
why not tell is this.
1: what transmission, its and automatic right>
2: and what it does wrong, exactly and clearly
3: stated all things it does good and bad, ALL !
4: and does it fail hot and cold engine or both? key that is.
do all gears fail. and how.
slips, dead, jerky, flares?
in gear , can you make engine RPM go over 3000 rpm not moving
or with it slipping>????????
do you know the difference from a weak engine and a slipping trans or clutch? if not, ask that first.

Feb 09, 2014 | 1996 Toyota Camry

1 Answer

My 1990 Chrysler New Yorker 5th avenue will not shift up past second gear.


Probly no one ever changed the trans fluid,now you did and its to late,But get a bottle of Lucas trans slip.cost about 12$ at walmart,put the whole bottle in the trans,it is really thick, so heat the bottle on a register for a good while so that it will pour right in in this cold wheather.Let car run for 20 min. than try driveing it.if it wont move,let it rin another 20 min. if it moves drive it around untill it starts driveing better ,might take up to 3 days to get moved through trans real good.It worked for me on 6 cars now

Feb 25, 2013 | 1990 Chrysler New Yorker

2 Answers

Temperature needle stays on the hot and doesnt move even when the car is cold?


YOur guage is faulty. Your will need to replace your guage if it stays in the hot position even when your car is off and your key is out of the ignition. If it only rises to hot when you turn the key to the run position, you have a wire between your guage and your temp sending unit that has been gounded out. Usually this happens when a person opens their hood to add oil or perform some minor maintenance on the engine and inadvertantly bumps the sensor or switch or wiring. This causes about 65% of these minor issues people incur, but if it does stay all the way up with your key out of the ignition switch, then you will need to replace your temp guage.

Oct 18, 2012 | Ford Escort Cars & Trucks

1 Answer

Slipping transmission when cold. Will not engage in drive completely until temp guage is in the middle.


Is your check engine light on? If so find out what the cause of the light is. These car have a bad problem with shift solenoids. When they go bad they can cause slippage. They do usually cause the check engine light to come on first. Another cause could be someone put the wrong type of fluid in the transmission. If this is the case you will need a complete fluid exchange. Last cause would be the bands in the transmission have gone bad and you will be in need of an overhaul. Hope this helps!

Oct 31, 2010 | 1998 Honda Accord

2 Answers

Ford mondeo mk3, intermitent dumping of water from cooing system,found crack in header tank, changed same,ran car at idle, temp guage at normal & heater blowing hot , took car for run , temp guage off...


You may have an air pocket in your system which some times happens.  One way to get rid of it is to take the upper hose off on the engine side,  fill your system with water until it runs out from your engine block, replace the hose, start your car turn you heater on and set to hi keep the radiator cap loose until the temp start to rise then close tight.  Once the air pocket had been remover you can drain some of the water from the radiator using the lower drain plug and add antifreeze.   

Mar 09, 2009 | 2001 Ford Taurus

3 Answers

Temp guage barely moves and runs rough just off idle


Try a full tune up.. get Bosch platnium+4 spark plugs and Acel wires, do the fuel filter and air filter(i suggest K&N) buy some fuel injector cleaner or use Marvel Mystery oil. The ECU could e gone but hard to diagnose if the car needs a tune up.

Jan 18, 2009 | 1992 GMC Sonoma

1 Answer

Heat blowing Cold when in drive. When in Park, it is warm


have you chg. any thing lately like thermostate? added any coolent to system? if not, thermostate could be stuck in the open position. if stuck open, setting still, it will throw heat, but moving coolent flows to fast and does not get a chance to get hot. if you did chg. thermostate it could have a air pocket in the system. and also adding coolent can create an air pockets too. you will know this when your traveling down the road and temp guage fluctuates up and down. witch means air in system.

Jan 15, 2009 | 2000 Pontiac Bonneville

1 Answer

Temp guage goes to max (right) when engine is cold.


change the themostat when you remove the old themostat you should see it stuck in the open postion . before i install the new one i fill the the block with coolant install the new stat run the mtr and heater core until hot iwould also replace the cap

Jan 01, 2009 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

Over heating when idle in traffic


if ac dont work idleling it start to work when you move our fan is not coming on because when you activate the ac compressor kick in and fan should come on if it start to be cold only when you drive the force air cool the condensor ac work temp goes down HOPE IT HELP FIXYA OUR POST THANKS . PIERRE

Jul 09, 2008 | 2004 Honda Accord

Not finding what you are looking for?
1991 Mazda 323 Logo

Related Topics:

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...