Question about Ford Bronco

1 Answer

1991 Ford Bronco with 5.0 and automatic. no power suspect main fuse but can't locate. battery good.

Posted by on

  • Anonymous Aug 04, 2008

    gauges rpm inop fuel reding hugher loss of power but runs no backfire

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

The main fuse block on a 1990 full size bronco will either be under the dash/steering wheel column, bolted to the firewall or under the hood on the passenger side of the vehicle on the firewall. I would also look at the ignition switch.

Posted on Jul 26, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No power to my stearing colom 1991 ford bronco


Your 91 Bronco is equipped with a solenoid relay switch...trace your battery cables to locate this switch...on the positive side, a few inches from the battery on the inner fender...be sure all connections are tight and clean before replacing.

Feb 01, 2013 | 1991 Ford Bronco

1 Answer

Why dont i have power when i turn my key on in 1991 ford bronco


There are some fuseable link wires between the key switch and the battery. One of these links may have an open circuit.
You would use a test light to trace the main circuits from the battery and starter solenoid back to the key switch.

Feb 01, 2013 | 1991 Ford Bronco

1 Answer

Why dont i have power when i turn my key on in 1991 ford bronco


Either power is not getting to the switch-check for an ignition fuse or a fusible link just off the battery-or power is not being transmitted through the switch-in that case, replace the electrical part of the ignition switch.

There should always be a hot wire going to the switch-it is hot at all times, just waiting to be sent somewhere through the switch to run, accessories, or start. First check if you have power to the switch. If not, may need to consult a wiring diagram, but likely a fusible link near the battery has failed.

Feb 01, 2013 | 1991 Ford Bronco

1 Answer

Good battery and connection but no power at all nothing works


maybe the main battery wire are broken did you check the continuity in wire and the fuse box follow the power and found the problem. I hope to be a helpfull to you

Jun 07, 2011 | 1996 Ford Bronco

2 Answers

Transmission leak in a 1991 ford bronco. trani fluid all over most of the engine. can't tell where it's coming from. Main puddle is under the radator.


I would say transmission cooling lines cracked or loose near or at the radiator, If so get the lines from any auto parts they should be 1/4, 5/16, or 3/8 screw the right one into the radiator tank and cut the lines to fit and use a compression union to put them together

Nov 23, 2010 | 1991 Ford Bronco

1 Answer

No power,no dash lights,no power to fuse box or ignition switch


Check your fusible links. There will be one main one at the starter relay. You'll find it bolted to the fender nearest your battery (passenger side). One link controls the majority of the power in the bronco. A word of caution though... If you replace it and your new link blows again, you have a short somewhere that you'll have to track down.

Apr 08, 2010 | 1984 Ford Bronco

1 Answer

Where is the fuse box located on a 86 ford bronco II


Fuse Panel is located inside the passenger compartment, under the drivers-side of the instrument panel...

c0f56fa.jpg

To access the fuses, release the retaining tabs...

b1a62d6.jpg

...then pull the cover from the dash

ca94a19.gif

Fuse panel and fuse identification-Ranger/Bronco II (clic for zoom)

Power Distribution Box
Located under the hood, inthe engine compartment. It houses the fuses and relays for most of theunder hood components which are not controlled by a dash mounted switch(such as the alternator, fuel pump, ECM, etc.). The fuses and relaysare replaced in the same manner as the fuse panel inside the vehicle.The power distribution box cover is hinged on one end and utilizes aretaining latch on the other. Simply release the latch and lift thecover up to gain access to the fuses and relays.

Good luck (remember rated this help).

Feb 08, 2010 | 1986 Ford Bronco II

1 Answer

Where is the thermostat located on a 1991 ford bronco fullsize with a 5 liter 302 cubic inch engine


follow the upper radiator hose to the engine it is behind the housing that the hose is clamped on, two 13mm bolts hold it on

Aug 03, 2009 | 1991 Ford Bronco

1 Answer

88 Bronco ii won't shift into 4 wheel drive.


Check to see if you are getting power through your switch on your dash. I also suspect your shift motor but it is a lot easier to check it with a test light.

Jul 01, 2008 | 1988 Ford Bronco II

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

213 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...