Question about Chrysler Sebring
Replacement parts and labor could run $200 + from the dealer.. Yes, a replacement switch can be obtained from a salvage yard, BUT NOT from an auto parts store. It is not difficult to remove old switch and replace
Posted on Apr 04, 2009
most likely the switch is bad if you disconnect the plug to the forward backwards motor the power should swap back and forth depending on which way thw switch is pushed if it doesnt switch is bad let me know how you make out
Posted on Jun 02, 2009
I just had the same problem. When the seat is powered all the forward, one of the worm drives reached the end of its travel and jammed against the threaded block that it passes through. To fix this the seat has to be unbolted and tipped back. There are four tiny 6mm bolts that hold the motor plate in. Remove these and the motor will come out. The worm drive is bolted in at one end and has a set pin at the other. Remove the worm drive and use a couple of vice grips or equivalent to loosen the threaded block from the worm drive.
Posted on Jun 21, 2009
It can also be theseat motor since there is seperate motors for up/down & forward/backwards. You can test the switch to see if you are getting power to the connector on the motor by using a multimeter.
If there is power to the motor, I would remove the motor and give it a tap on the ground. Alot of the time the motor is fine, and the tap will free it up again. If it doesn't work you may be up for a new seat motor. Giving mine a tap solved the issue with mine.
Posted on Nov 05, 2009
Tips for a great answer:
Dec 15, 2015 | 2003 Chrysler Town & Country
Jul 16, 2014 | Chrysler Sebring Cars & Trucks
Feb 07, 2013 | 2004 Chrysler Voyager
Oct 23, 2010 | 2002 Buick LeSabre
Feb 15, 2010 | 2002 Chrysler Sebring
Nov 08, 2009 | 2003 Ford Expedition
Oct 03, 2008 | 1998 Chrysler Sebring
Jul 19, 2008 | 1993 Chevrolet Corvette
144 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: