Question about 2000 Ford Focus

1 Answer

06 ford ranger how do you dissconnect the fuel filter lines....Do you just use force to pull them out?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 60 Answers

First off, make sure you relieve the fuel system pressure. Second, to get the clips off, you need to get a fuel line disconnect tool. You can find those at most auto parts stores and they should be able to tell you which one you need. Also, you may want to spray both connectors down with a penetrating lube first and let it sit a bit just in case dirt, etc. got on there, which can "freeze" them.

Posted on Jul 25, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

No fuel from diesel pump when turning engine

Sometimes an air bubble - just before the injectors cause this problem. Loosen the fuel line there and crank the motor. Fuel pressure should force the air out and then fuel will squirk out. Turn key off and tighten up the line. Hope this is it. Other diesel fuel start tips are listed below that will help.

May 05, 2017 | 2000 Ford Ranger SuperCab

1 Answer

How to use Lisle air conditioning / fuel line disconnect tools

Clamp on to line with the tool, push the tool into, let's say, the filter assembly, pull out fuel line while pushing in on the tool.

Sep 02, 2011 | 2003 Ford Ranger Regular Cab

1 Answer

How do i change fuel filter on 1987 ford ranger 2.9 liter

look under truck at drivers side door for the fuel lines. they will go into filter there and back out of filter're looking for a round canister,you'll need to release the pressure by removing the gas acp also.there will be a plastic clip on both sides of the filter holding the fuel lines into the filter. pull those clips out with needle nose pliers, install the filter with the flow towards the front of motor, reinstall those clips unless new ones came with the new filter.keep in mind that you are under the truck looking up at filter, eye protection is a must!!!! hope this helps!!

Aug 23, 2010 | 1987 Ford Ranger

2 Answers

Where can i obtain a diagram of the location of

the fuel filter is located on the inside of the frame rail on the drivers side about where the driver seat is bolted to the floor board, it is round and about the size of a coke can

Apr 20, 2010 | 1986 Ford Ranger 2WD

1 Answer

Fuel Filter location in my vehicle?

It has a carb right. It is screwed into the carb. The fuel line is screwed to the filter.

Apr 13, 2010 | 1983 Ford Ranger

2 Answers

How do I remove the fuel lines from the filter on a 2002 ford ranger. I bought a tool that says that is what it is for but it didn't come w/ directions

pull the metal retaining clip off of the fuel line. you slide it over the fuel line , slide it into the fitting. push fitting against the tool, then slide fitting off. not to bad to do.

Jan 02, 2010 | 2002 Ford Ranger Regular Cab

1 Answer

Fuel filter installation on 1990 ford ranger xlt

It's on the driver side just behind the door. You need a special tool to pull the lines off of the existing filter. It seems to be a cheap simple tool. it slips over the line then you push toward the filter, it will click then you can pull the line off. Just pull the lines then replace with the new filter. The truck will start funny at first because it will be deprived of gas for a moment but then it should be fine.

HTH, Mike...

Dec 07, 2009 | 1990 Ford Ranger SuperCab

1 Answer

Name of toll to release the fuel filter lines?

ford has several different sizes for full size, not sure about rangers though. They are called fuel line tools though. Did you blow air through the connecters to remove all dirt? How about removing the metal clips that are there as a saftey measure? Those clips looke like a weird J shape that helps prevent accidental disconection.

Jun 14, 2009 | 1998 Ford Ranger SuperCab

2 Answers

How do i change a fuel filter for kia optima

there is an access cover over ur fuel pump in the trunck. Pull that back and dissconnect ur electric from pump. run car til it uses all the gas in the lines. Then dissconnect lines. Then u pull out ur pump and ur filter will be on that. Replace and thats it.

Mar 26, 2009 | 2004 Kia Optima

Not finding what you are looking for?
2000 Ford Focus Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5655 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides