Question about 1999 Toyota RAV4

1 Answer

Fuel problem it runs for a very short time 5 min ,then engine stops replaced fuel pump problem still exist, where is the fuel relay or other problem to look for

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 178 Answers

Was this vehicle hit could be faulty fuel cut off switch best way hook a fuel pump pressure gauge to shrader valve located on fuel rail check pressure if not within specs possible regulator

Posted on Sep 12, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1989 ford f-150


If the fuel pump(s) run while the pressure is falling, replace the fuel pressure regulator and (although I'm sure you've already done this), replace the fuel filter. If the fuel pumps appear to be turning off by themselves, replace the inertia (fuel cutoff) switch.

Apr 13, 2014 | Cars & Trucks

1 Answer

1994 f150 6 cyl engine shuts down every 10 min restart after 5 min


Sounds like the module inside the distributor. Have to be replaced.

Sep 29, 2012 | Cars & Trucks

1 Answer

95 bonneville stalls then starts then in about 5 mins. Stops again. Replaced fuel pump a fue months back. Best luck was replacing relay for fuel pump. Now that doesn't help.


If your check engine light is on, find out the codes. I would have the fuel pressure checked again, first run the car until it stalls again and check it. I've installed pumps that went bad in as little as a couple days

Jun 16, 2010 | 1995 Pontiac Bonneville

3 Answers

2000 vw cabrio runs normal and shuts down, takes 5 to 20 minutes to restart, engine cranks but doesnt start, changed ignition coil, pulled diagnostic codes getting short to ground codes on cylinder...


On some models, the Engine Control unit has a power supply relay. These relays some times get internal dry solder points. After driving for some time the the solder will get hot and separate. When it cools down it makes contact again. You will have to replace this relay or open it up and re- solder the solder joints. The relay is usually located on the main relay station in position 3. the relay station is located behind the right dash panel.[right hand drive vehicles]. You may need to refer to a manual for your specific model to find the exact location of the relay.

Jun 04, 2010 | 2000 Volkswagen Cabrio

1 Answer

Engine (97 ford ranger) stopped at stop lite and would not restart. Spark to plug wires, plenty of gas, good battery. after cranking several times, will start and run 3 or 4 sec. THE RELAY TO THE FUEL PUMP...


Just for the hell of it replace the fuse with a new one relative to the fuel pump also clean and inspect all electrical plugs and connections associated with the fuel system. There may be a bad ground with out the truck in front of me it will be difficult to go any further it is possible the pump is not creating enough pressure to close the relay have you replaced the fuel filter? If possible do a fuel pressure check at the fuel rail it should be 30 - 40 psi if not replace the pump.

Oct 05, 2009 | 1997 Ford Ranger SuperCab

2 Answers

Fuel pump relay


check fuel psi at fuel rail with fuel tester, if u think its a fuel problem.
prob a spark prob. check spark with spark tester.

Sep 07, 2009 | 1991 Geo Tracker

2 Answers

Engine cuts off


Check the relays. A worn connection could cause this.
The fuel pump relay is often the culprit.
If you try twisting the relays, gently while it's running, or while you try starting it, you may find the problem.
Hope that's it.

Jul 12, 2009 | 1993 Volvo 240

2 Answers

2000 2.0 vw shutt down after running 20 min


Replace the fuel pump relay, it's easy and cheap.

Jun 08, 2009 | 2000 Volkswagen Jetta TDI

1 Answer

Honda civic 92 stops after short run


you might need to put a non return valve on the inlet pipe from the tank to the carburator

Mar 31, 2009 | 1992 Honda Civic

Not finding what you are looking for?
1999 Toyota RAV4 Logo

402 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...