Question about Buick Roadmaster
if you replaced fuel pump i would look at backward wiring when replaced and i would start at the source of work if your vehicle was working fine before replacement then 9 out of 10 it will be your fuel pump wireing
sometimes when putting wireing back together the connectors have the missing clip and in turn you can turn the wireing in both directions now where positive is touching the ground on both sides of connector kris kross problem check your work this is crucial use a test light to find the right wires where they go
Posted on May 26, 2008
It's located in the trunk on the drivers side. You should see a black and yellow sticker below a hole indicating that the fuel pump shut off switch is here. Even if your sticker has worn off, if it's a 92 topaz it most likely will be there in that hole. Shine a flashlight in it and you should see a black unit with a red button on top. Push the button down until it clicks in place. If the button is already down, your problem is something else.
Posted on Apr 07, 2009
with the key on there should be power (12 volts) to 2 terminals, you need to cycle the key to sense the power, it only stays on 5 seconds, have someone turn the key on and off while u check..
Posted on Apr 10, 2009
The fuel pump relay is located Under hood, driver side, upper firewall, mounted in
The fuse is located under the instrument panel to the left of the steering column. The fuse block should be visible from underneath the steering column, near the pedal bracket. If the panel is not visible, check for a removable compartment door or trim panel which may be used on later models to hide the block.
Posted on Jun 03, 2009
Tips for a great answer:
Jul 02, 2012 | 1992 Buick Roadmaster
Jun 29, 2012 | Cars & Trucks
Jan 27, 2010 | 1992 Buick Roadmaster
Nov 13, 2009 | 1992 Buick Century
Jun 21, 2009 | 1995 Buick Roadmaster
Jun 13, 2009 | 1992 Buick Roadmaster
Jun 08, 2009 | 1992 Buick LeSabre
May 12, 2009 | 1992 Buick Roadmaster
Mar 24, 2017 | Buick Rendezvous Cars & Trucks
135 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: