Question about 1996 Geo Prizm

1 Answer

HELP!? Hey, could you help me find out where the IAT is at on a 1996 Geo Przm 1.6 L? I am installing a Performance chip. I got it from Dynamic Peformance.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 373 Answers

Hey .
you did all ready or need help.
Let me know.
I will stay on line a few hours.

Posted on Jul 25, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2008 Pontiac G5 I was wanting to install a performance chip to it. It says to connect it to the IAT senor which has 5wires witch wires are for the IAT


The other three wires are for the Mass air flow sensor . That's a new one for me , performance chips or turners are used through the DLC . You program the engine computer . I have no idea what they can do from the intake air temp. sensor .The tan an lit blue wires are for the IAT sensor !

Oct 15, 2015 | Pontiac Cars & Trucks

1 Answer

Where is iat sensor on 2006 toyota tacoma 4.ol 4door located ?


This is the 2001-2012 Toyota Tacoma wiring diagram, Toyota Tacoma IAT (Intake Air Temperature) Sensor Location and the Toyota Tacoma MAF (Mass Air Flow) Sensor Location, also included is a pinout of the sensor. You are likely installing a performance chip or a cold air intake kit for increased HP (Horsepower). You will want to be sure to disconnect the car battery before adding performance products.




Here is the Toyota Tacoma's Iat sensor diagram:




ab0b7213-0c7f-459c-b26e-77a685236e74.jpg

Apr 14, 2015 | 2006 Toyota Tacoma

2 Answers

On my 1993 Geo Prizm i need to know were the intake temperature sensor is because i need to install a performance chip. Thanx


On the air inlet pipe from the airbox to the throttle body. But, don't believe those IAT performance chips, they are waste of money.

Nov 18, 2009 | 1993 Geo Prizm

1 Answer

How do I install a performance chip for the IAT. Instructions say there are 2 wires to jumper but the IAT has 4 wires. The resistor has to go across the IAT wires.


that "performance chip" is not good for you car. that resistor is trying to make your car think the air coming into the intake is colder than it is, thus making your car use more fuel to perform better. slightly feel like more horsepower, use more gas.

Oct 14, 2009 | 2006 Infiniti G

2 Answers

Boss performance chip installation


sometimes the air temp sensor is in the mass air too.

Jul 10, 2009 | 2005 Chevrolet Avalanche

1 Answer

Locating the iat sensor on a 2003 dodge 5.9


The IAT sensor is along the intake tube before the throttle body. If your planing to buy the performance chip from EBAY or any other place, save your money. You can go to Radio shack and it will cost you less then $3.00 for the resistor needed to make your own "performance Chip" IF you like you can use and 10K ohm potentiometer wire it through to the IAT sensor wire harness so you can adjust your timing for the type of fuel you want to use or how much performance you want out of your engine. Here is a link to the installation of the resistors and the different resistor's you can use or like me use a Potentiometer. Note if the timing is to high on hot days, the knock sensor may trigger and the engine will power down 15% till next start up. Good luck and hope this helps. http://kingenterprises.net/IAT-Timing-Tricker.htm

Jun 15, 2009 | 2008 Suzuki SX4

1 Answer

Can't find IAT sensor


Do not recommend doing this.

May 09, 2009 | BMW 328 Cars & Trucks

1 Answer

Any Photo or Diagram of location of Air Temperature Sensor/IAT/MAT etc;


LOL. 70 horsepower? From a FUEL SAVER CHIP? Nope, you got jacked man.

Aug 07, 2008 | 1995 Geo Tracker

Not finding what you are looking for?
1996 Geo Prizm Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6876 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...