Question about 1989 Mazda MX-6

1 Answer

Right turn singnal will not flash it clicks verry fast under the dash dose not flash on dash the the lights are good and the left works fine

Posted by on

  • Anonymous Mar 18, 2014

    the turn blub is good. work on running lights. But the haszer relay click fast when the the r/h turn single is on. change out the relay and the same.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Hi. check all wires running to your indicators a faulty wire can cause this. and also your turn signal relays under the dash where all the fuses are swap the relays around then test it. if it works the its the relay if not id say a wiring problem. also a blown bulb on the right side can cause this also. cheers

Posted on Dec 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

WHY DOSE MY DASH NOT LIGHT UP WHEN HEAD LIGHTS ON


There is usually a dimmer switch for the dash lights near the left side of the dash behind the steering wheel. Sometimes that can get bumped when you get in the car and turn the dash lights completely off.

Oct 26, 2015 | 1991 Nissan Maxima

2 Answers

Where is the flasher relay located on 2006 Montana


Relay located in right side of dash in fuse block behind access panel

Jul 18, 2014 | 2006 Pontiac Montana SV6

1 Answer

Cant resolve a blinker issue, Tried the easy stuff.


The signal wire going to the right front has a splice for the dash indicator, a wire branching off from the turn wire and going to the dash. It sounds like that right signal wire is broken or lost a connection before it splices off to the dash, so the problem sounds like it is under the dash, either coming out of the turn signal switch to the flasher or from the flasher to that splice. You may need a multi-meter to check voltages on that wire at various places under the dash. Ascertain which color wire you need to concentrate on. Check for voltage on it with key on and right blinker on-voltmeter will spike to battery voltage, then fall to zero as the flasher breaks voltage continuously, if checked after the flasher. If checked when leaving the turn switch, it should be a continuous signal on that wire. Think you better find a wiring diagram to find the right wire to check. Good luck.

Apr 27, 2013 | 1998 Buick Century

1 Answer

Bulb and fuse good relay clicking fast


What is different between fleming left hand rule and right hand rule
1_26_2013_9_19_11_pm.gif

Jul 06, 2012 | 1997 Buick Century

1 Answer

Chevy malibu turn signals will flash really fast while driving but all bulbs are good


Replace the flasher relay. It is usually under the dash. Follow the clicking sound when the flasher is on. It just unplugs.

Dec 01, 2011 | 2002 Chevrolet Malibu

5 Answers

2000 taurus left turn signal flashes rapidly and the left rear turn signal lamp does not work. Does ford have burned out bulb sense circuit that would give this indication? The right side flashes normally.


Yes - the fast flashing is a warning that a bulb is burned out. Change the bulb (be careful to put it in the same as the old one as it probably is 2 bulbs in one , parking and turn/stop) and you should be fine.

Jul 08, 2011 | 2000 Ford Taurus

1 Answer

Where is the exact location of the hazard light flasher for a 1989 GMC Sierra C2500, and what is the possibility that it is the true problem behind the hazards not working? Beyond my hazards not working my...


Are you sure the right side bulbs all flash? You say you replaced all the bulbs? Why would you replace bulbs that were working? Did you have this problem before you replaced the bulbs, or after. The hazard flasher is down under the dash, left side, turn the signals on and follow the clicking noise.The hazard flasher and the turn signal flasher should be near each other, and are interchangeable. If it clicks fast, a bulb or a bad socket is usually the cause. These trucks have a lot of problems with the tail light circuit boards.

Nov 04, 2009 | 1989 GMC C2500

2 Answers

98 Sebring JXI turn signals work right/left and


Change the flasher which is located up by fuse block under dash

Jul 29, 2009 | Chrysler Sebring Cars & Trucks

1 Answer

Left Turn Signal Flasing Very Fast


try replacing the bulb and make sure the new one is in the sock all the way push and twist good luck

Jun 27, 2009 | 2000 Volvo S40

Not finding what you are looking for?
Cars & Trucks Logo

280 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...