Question about 1996 Nissan Maxima

1 Answer

Primera 1996 the inside light stays on once the car is turned off and key removed from ignition. the light on dashboard indicating that one of the doors is open even though all doors/trunk and bonnet is closed. This drains the battery life. Is there a wiring fault or fuse?? This is for a Nissan Primera 1996

Posted by on

  • 3 more comments 
  • ejm5723 Dec 31, 2008

    I have the same exact problem. 1996 nissan altima.

  • Anonymous Mar 16, 2014

    01 dodge caravan keep draining battery. With ignition key off and driver door open , the chimp come on, indicating the key still in the ignition

  • Anonymous Mar 18, 2014

    ssan primera 03 battery died recharged but now can only open car manually on passanger side with key

  • Anonymous Mar 18, 2014

    ssan primera 03 battery died recharged but now can only open car manually on passanger side with key

  • Anonymous Mar 23, 2014

    2012 Ford Focus : There is an indication where the trunk/back compartment is open even though it's closed, and so when I lock the car there is two beeps which indicates something is open.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 25 Answers

Probably has a faulty door switch...

Posted on Aug 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to code new batteries in car key


1. Turn the ignition switch from Position 0 to ON 6 times within 10 seconds.
2. Then turn ignition switch to OFF position. Leave key in ignition switch.
3. After 2 seconds, the system will enter programming mode and will flash the warning lights twice.
4. Press and HOLD the unlock button on the Plip.
5. While pressing the unlock button, press the lock button 3 times.
6. Release the unlock button.
7. The warning lights will flash once to indicate successful programming.
8. Repeat procedure 4 to 7 for up to 4 plip key's.
9. When completed turn ignition ON, and the warning lights will flash 2 times.
10. Remove key, and check all plip key's for operation.
NOTE : The programming mode will stop when either the ignition is switch ON, 4 plip keys have been programmed or no input signal either from the switch or plip keys has been received for 120 seconds.

Nov 08, 2014 | 1999 Nissan Primera

5 Answers

Security light flashes and it won't start


top
CODE ALARM SYSTEM
information is always subject to change and correction Used on:
Impreza 1996-2001
Legacy 1995-1999
Forester 1998-2000
codealarmremote2.jpgBattery GP-23A
Lock: Left button will lock all doors. Double chirp indicates locked.
Unlock: Right button will unlock driver's door only. Hold unlock button app 6 seconds, it will unlock all doors including rear gate. Single chirp indicated unlock.
If the car chirps or lights flash 4x the alarm was triggered.
Panic. Press both buttons to activate emergency honk and flashing lights.
Valet mode: With optional alarm only Press the red alarm button on the left of the steering wheel. The light will quickly double flash. To re-set back to normal mode, press the red alarm light button again

Battery failed and lights flashing?
Parking lights will flash when the vehicle's battery is disconnected and reconnected.
To stop lights from flashing, either:
Press remote transmitter “UNLOCK” button once OR turn the ignition switch to the “ON” position and press programming button for one second (see below).
The vehicle interior (courtesy) light and door open warning light (DOOR AJAR indicator) will then illuminate for 60 seconds when the ignition is turned off, or until the doors are locked with the remote transmitter. Yes, the dashboard instrument panel lights will flash when the parking lights flash.
Programming or Overriding the Alarm when you have lost the remote
Open driver's door.
Turn ignition key to 'On'
Press and *hold programming button* in (see diagram, button under dashboard)
After 15 seconds the the door locks will cycle 3 times. Do not release Programming button
Press lock (left) button the remotes to be programmed. The door locks will cycle one time.
Exit programming mode by releasing Programming button under dashboard and turning key to off.

codealarmremote1.jpgCode Alarm Programming Button is under dashboard on the kick panel by the driver's left knee, left of the steering column. If you can't find it, it might still be tucked up in the wiring harness higher up in that same general area. The botton is recessed in a plastic ring (see diagram).
This button must be pressed while programming remotes or if the battery was disconnected and the lights are flashing.
top

Jul 10, 2008 | 1996 Subaru Legacy

1 Answer

Ignition key will not turn


There seem to be two problems in your case. First thing first. Shift your steering wheel left or right to free the catch so your key will turn. Brake lights, mean the back lights or the red light indicator on your meter for the hand brake? Pease confirm!!

Oct 11, 2014 | 1996 Honda Civic

1 Answer

2001 mitsubishi eclispse gs wont start how do you bypass the security system


  • 1 Turn the ignition key counter clockwise in the driver's side door to unlock the caricon1.png. This deactivates the alarm long enough for you to gain access to the vehicle. Then, place the key in the ignition and turn the key until it clicks once. This starts the car's battery, but doesn't ignite the engine. The LED light on the dashboard should stop blinking, indicating the alarm is temporarily disabled.
  • 2 Locateicon1.png the box for the alarm under the dashboard on the driver's side of the car. Then, look for the override button on the box. Typically, the small button is either red or black. With the ignition key in the "on" position, press the override button and hold it in until the alarm chirps once. This disables the alarm until you manually reactivate it.
  • 3 To reactivate the alarm, turn the key to the "on" position and press the override button once. The alarm chirps twice, indicating the alarm is active.

  • Hope this helps!

    Mar 15, 2014 | 2001 Mitsubishi Eclipse

    1 Answer

    How do i reset central locking on a micra 04 reg


    Try the following:

    "KEY FOB PROGRAMMING
    NISSAN
    SYSTEM DESCRIPTION
    The Central Door locking is controlled by the Multi-Remote Control system which controls
    the door locking, door super locking and hazard reminder. When the doors are locked and
    unlocked the unit flashes the hazard lights once for lock and twice for unlock.
    A maximum of four remote controls are allowed to be programmed.
    ALMERA
    ALMERA TINO
    PRIMERA
    MAXIMA
    MICRA
    SERENA
    VANETTE CARGO
    TERANO II
    Ensure all the doors have been unlocked, either by using a good transponder key or remote
    control plip key.
    Procedure
    1. Turn the ignition switch from Position 0 to ON 6 times within 10 seconds.
    2. Then turn ignition switch to OFF position. Leave key in ignition switch.
    3. After 2 seconds, the system will enter programming mode and will flash the warning
    lights twice.
    4. Press and HOLD the unlock button on the Plip.
    5. While pressing the unlock button, press the lock button 3 times.
    6. Release the unlock button.
    7. The warning lights will flash once to indicate successful programming.
    8. Repeat procedure 4 to 7 for up to 4 plip key?s.
    9. When completed turn ignition ON, and the warning lights will flash 2 times.
    10. Remove key, and check all plip key?s for operation.
    NOTE : The programming mode will stop when either the ignition is switch ON, 4 plip keys
    have been programmed or no input signal either from the switch or plip keys has been received
    for 120 seconds."

    Mar 12, 2012 | Nissan Cars & Trucks

    2 Answers

    I have a 1996 neon. When you turn the key in the ignition the dash board lights come on but when you turn the key to start the car there is a click sound from starter ,the car does not start and the lights...


    check your cables at the battery and the starter,,make sure they are clean and tight and check the water level in your battery if it is not a sealed battery and also have your battery tested, if everything is ok, it seems like you have bad starter.

    Aug 26, 2010 | 1996 Plymouth Neon

    1 Answer

    Starter will not engage anti theft light is on it is a 2005 cobalt


    I found this on a website try this

    1. Put the newly cut Master key into the keyway and turn it to the ON (RUN) position. A "security" indicator
    light on the dashboard will stay on for 10 minutes.
    2. Within 1 minute after the indicator light goes off, turn the ignition to "OFF", then return to the ON (RUN)
    position. The indicator light again will stay on for 10 minutes (Do not remove the key.)
    3. Again, within 1 minute after the indicator light goes off, turn the ignition to "OFF", then return to the ON
    (RUN) position. The indicator light again will stay on for 10 minutes. (Do not remove the key.)
    4. When the light goes off the third time, the new key is programmed into the computer and will start
    the car. Remove the key and then re-insert it into the ignition lock and start the car.
    All previously stored codes will be erased. To stop the process at any time, simply remove the key and use
    an existing key to start the car.

    Mar 25, 2009 | 2007 Chevrolet Cobalt Coupe

    1 Answer

    CHEVY S10 - Once key is ignition won't stop with the ringing nois


    I would just disconnect or remove the ringer from the car. Under the dashboard. Listen until you locate it and remove it. They have a timing sensor that is suppose to turn off the ringer after a few seconds. It seems this timer has gone bad. if you replace the whole ringer circuit it may work. But if you have a fairly good memory to take out the key, you can just disconnect the ringer. But it is up to you.

    Feb 16, 2009 | 1996 Chevrolet S-10 Pickup

    Not finding what you are looking for?
    1996 Nissan Maxima Logo

    542 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Nissan Experts

    yadayada
    yadayada

    Level 3 Expert

    60541 Answers

    Phil Lovisek
    Phil Lovisek

    Level 3 Expert

    705 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    21927 Answers

    Are you a Nissan Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...