Question about 2004 Jeep Wrangler

2 Answers

2004 Jeep wrangler

I have a 2004 JW that will not hold a charge, and the interior gages go crazy. I can jump the vehicle and it will start but will only maintiain running for like 3 min, then makes an awful animal like noise and dies. what might this be?

Posted by on

  • jwalde15 Aug 27, 2008

    I have the exact same problem. I thought it was the battery so I bought I new one today and replaced the old one. I still have the same problem so I guess I will be trying the alternator now.

×

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 64 Answers

If you have a multimeter, you can check the voltage on the battery with the engine running. It should be above 13.5 volts dc, if not, then you are running off the battery, and the battery is probably good.

Posted on Jul 24, 2008

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 726 Answers

Try the altinator
run the car take positive of if the car runs altinator is good
if the car dies the altinator is dead
aslo check how old battery is and the top up levels

Posted on Jul 24, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 Jeep Wrangler charging problem


nothing wrong with the ECM unless it has the voltage regulator as part of the system
indicates faulty wiring and faulty alternator
have a load test done on the battery
have an auto electrician do a full charging system check
charging voltage should be 14.5-14.8 volts DC
battery voltage should be 12-13.5 volts dropping to 11 volts when cranking the engine
make sure that the drive belt tension is correct and the belt is in good condition

Dec 22, 2017 | 1993 Jeep Wrangler

3 Answers

Is it good to jump start a car with a new vehicile


Yes it is ok to jump start a car with new car

Feb 22, 2010 | 2008 Jeep Wrangler

1 Answer

Check Gauges Light 1997 Jeep Wrangler


bad battery or bad,corroded terminals

Oct 15, 2009 | 1998 Jeep Wrangler

1 Answer

My 2004 Wrangler won't start and the dash board is


check your battery for proper voltage (12.5 or greater)
Battery terminals if corroded. Replace/clean if necessary. Hopefully this helps

Aug 16, 2009 | 2004 Jeep Wrangler

1 Answer

2008 wrangler x with 3.8 v6 32,000 miles just purchased driven home 750 miles then parked in garage a half hour later tried to start it but wont crank just a slight click, lights work gages work, radio...


Sounds like the starter. You can try several things but the main idea is to start it to be able to bring it to a mechanic. Disconnect the battery and push on the brake pedal. This will drain the power from the vehicle. Reconnect the battery and try to start the car. The theory behind this is the starter solenoid could be stuck energized. You can also locate the starter slightly tap on the starter and then try to start the vehicle. Also if the vehicle has sacked for some time before you purchased it the battery may not have the cranking amps necessary to start the vehicle. The electrical gizmos will work but it will not be enough to crank the engine. Check the battery is fully charged and possibly try to hook up jumper cables to another vehicle or a jump start Appliance.

Sep 20, 2017 | 2008 Jeep Wrangler

2 Answers

2004 JEEP WRANGLER TURN SIGNAL


replace all bulbs on that side,or check for broken ground wires.

Aug 04, 2008 | 2004 Jeep Wrangler

1 Answer

WOnt run over - battery good - can turn it over but jumping the starter


if the battery is good and you jump the starter she should run otherwise you may have a sensor issue, try to get a hold of a code reader and see if any codes have popped up..

Aug 02, 2008 | 1998 Jeep Wrangler

Not finding what you are looking for?
2004 Jeep Wrangler Logo

141 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...