- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
TAKE FRONT COVER OFF(AFTER REMOVING FAN, BELT S, PULLEY AND FAN SHROUD).THEN REMOVE CRANK SHAFT PULLEY. WHEN COVER IS REMOVED YOU'LL SEE 3 SPROKETS, SUGGEST TO BRING CRANK TO TOP DEAD CENTER UNTIL YOU SEE ALL 3 MARKS FOR THE TIMING BELT. REMOVE BELT/INSTALL NEW AND REVERSE PROCEDURE.
take off trim along lower door jamb, remove cover between doors. unbolt torques type bolt holding upper seat belt.same with the lower or floor connection bolt. need to buy large torques bit!! attn.. theres a elect. conn. to reconnect on the new or used belts, srs light may half to be reset at dlr. good luck !!