Question about 1999 Chevrolet S-10 Pickup
Replaced fuel pump on my 99 s10 automatice 6cyl by removeing bed. Had power prior to removal now no power to the grey wire at pump. any ideas?
There are two grounds on each side of the rear frame behind the bumper,those worked for me.
Posted on Nov 04, 2008
Tested grey wire again but this time used the frame as my ground, had power now. Traced ground wire. My son did not put back on driver side rear bolt that it came off of. Wa La problem fixed. I have heard that sometimes this wire goes bad so if it is still connected you might have to splice in a new one.
Posted on Jul 24, 2008
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: No power to fuel pump.
well your fuel filter is located on the passenger side of the firewall underneath the hood..also on the same side is the relay box check your fuel pump relay..
Posted on Dec 04, 2008
Tips for a great answer:
Open the hood and support it with the hood prop rod. Unhook the negative battery cable from the terminal with the battery wrench. Position the cable end away from the battery so that it cannot accidentally contact the battery during the rest if this procedure.
Disconnect the fuel filler neck from the side of the truck bed with the socket set. Unbolt the truck bed retainer bolts from the floor of the bed with the socket set.
Lift the bed up and off the Ranger's frame with the assistance of another person. Walk the truck bed off the back of the Ranger and set it off to the side.
Rap the rag around the tip of the screwdriver, place the tip against the fuel pump retaining ring and tap the screwdriver's handle with the rubber mallet to turn the retaining ring counterclockwise. Remove the ring by hand.
Disconnect the fuel pump wiring harness and fuel lines with the screwdriver. Lift the old pump out of the gas tank and insert the new pump in its place. Make sure the new pump occupies the same position and orientation the old pump had prior to removal.
Tighten the fuel pump retaining ring with the rag, screwdriver and mallet by rotating it clockwise. Reconnect the wiring harness and fuel lines with the screwdriver.
Lift the truck bed off the ground and place it back on the Ranger's frame with the assistance of another person. Make sure the fuel filler neck clears the frame and seats into the filler neck hole in the bed wall when you're lowering the bed onto the frame.
Reinstall the bed retaining bolts with the socket set and reconnect the negative battery cable to the battery with the battery wrench
Jul 16, 2016 | Ford Cars & Trucks
May 06, 2011 | GMC Sierra 1500 Cars & Trucks
Jul 29, 2010 | 2001 Chevrolet S-10
Apr 20, 2010 | 2001 Chevrolet S-10
Oct 18, 2009 | 2000 Chevrolet S-10
Jun 11, 2009 | 2001 Dodge Ram 1500 Truck 2WD
Jun 02, 2009 | 1999 Chevrolet Silverado 1500
Jul 29, 2008 | 1995 Toyota Tacoma
Dec 05, 2016 | 1999 Chevrolet S-10 Pickup
99 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: