Question about 2001 Cadillac DeVille
Its your engine to chassis ground I had same problem replace wire or try sanding paint around connection for better connection. The wire is located on top left of engine, very visible
Posted on Oct 03, 2008
This might work for most:
Theft Module Re-learn Procedure without a T5O or T6O
During this procedure, the vehicle battery must maintain a minimum of 10.5 volts. If the battery is not fully charged or is weak, a battery charger may be connected.
NOTE The battery charger must NOT be set in 12 volt boost. This will prevent this procedure from working.
1. Cycle the ignition switch to the "Run" position.
2. Wait a minimum of 10 minutes, cycle the ignition switch to the "Off" position.
3. Cycle the ignition switch to the "Run" position.
4. Wait a minimum of 10 minutes, cycle the ignition switch to the "Off" position.
5. Cycle the ignition switch to the "Run" position.
6. Wait a minimum of 10 minutes, cycle the ignition switch to the "Off" position.
7. Verify the repair.
and if not try this:
STARTING DISABLED/DUE TO THEFT SYSTEM/REMOVE IGNITION KEY"
If the Powertrain Control Module (PCM) does not receive the Fuel Enable message it will use the class 2 serial data line (CKT 1807) to tell the Instrument Panel Cluster (IPC) to display the "STARTING DISABLED/DUE TO THEFT SYSTEM/REMOVE IGNITION KEY" message on the Driver Information Center (DIC) . This will inform the driver of why the engine is not starting. When the ignition is turned "OFF", the IPC will start a timer and display messages to inform the driver to wait for the PASS-Key II timer to run out. The messages will read "WAIT 3 MINUTES", "WAIT 2 MINUTES" (after 1 minutes has passed), "WAIT 1 MINUTE", and "START CAR".
If the timer was not run out, the IPC will not send the Fuel Enable message. When the PCM does not receive the Fuel Enable message, it will command the IPC to re-start the message process.
This message is most likely caused by an improper key resistor value or the IPC did not properly sense the ignition key resistance.
Posted on Oct 18, 2008
Anti theft system is on and car want start97deville how do you reset
Posted on Nov 21, 2010
Change the key switch one of the wires have broken.its two wires connected two the key switch.my car was down a year an the whole time it was the key switch.Mack
Posted on Jan 03, 2009
I have a piece of **** lemon car what should i do?
Posted on Feb 24, 2009
make sure your key is clean try again, if not the system will tell you to wait 3 mins while key is in ignition this will reset the system and dash will tell you to start vehicle, you should be fine after that, common cause dirty key!!!!!!!!
Posted on Apr 20, 2009
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Dec 03, 2012 | 1997 Cadillac DeVille
May 17, 2012 | 1997 Cadillac DeVille
Jul 03, 2010 | 1997 Cadillac DeVille
Mar 01, 2010 | 1997 Cadillac DeVille
Dec 09, 2009 | 1991 Cadillac Eldorado
Nov 22, 2009 | 1997 Cadillac DeVille
Apr 13, 2009 | 1997 Cadillac DeVille
Mar 30, 2009 | 2001 Cadillac DeVille
Mar 24, 2009 | 1997 Cadillac DeVille
6,932 people viewed this question
Usually answered in minutes!