Question about 1998 Buick LeSabre

1 Answer

Horn keeps honking

The horn honks sometimes without my touching it. It looks like there isn't a fuse for it. I want to pull a wire under the hood but don't know the location of the horn. Thanks.

Posted by on

  • 1 more comment 
  • Anonymous Sep 07, 2008

    Just driving down the road and the horn suddenly starts blaring. Pressing the horn will stop it but it soon does it again. What gives?

  • Anonymous Mar 16, 2014

    I know where the fuse panel is, and have the diagram. I cannot tell by that though which fuse is for the dome light and the horn. Thanks for the help

  • Anonymous Mar 30, 2014

    Horn does not work. Does not honk. On e in a while it honks.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The headlight on my 1992 Buick LaSaber will not cut off.Were are the fuse for the lights

Posted on Jul 27, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car was starting and running fine, then suddenly lost all electrical, no crank no start and the horn keeps honking. I changed out the ignition module and the DIM/body control module


That sounds like a burglar alarm, immobiliser issue if the horn goes off. Did you pull a wire when you were under the hood?

The items you swapped out have no bearing on the problem you have, except for possibly the fuses. Did you check what those blown fuses protect?

2000 Buick LeSabre fuses Bing images

Sep 30, 2015 | 2000 Buick LeSabre Limited

2 Answers

2003 ford explorer eddie bauer horn randomly honking


One honk means all doors are closed. Door ajar you have 2 honks telling you a door is open. My 03 Explorer has had the door ajar light on for awhile

Mar 17, 2012 | 2003 Ford Explorer

1 Answer

The horn in my 2003 pontyiac grand am wont stop honking


you will find a fuse labeled HORN and a relay labeled HORN in the under hood fuse flock. Pull either of those to stop the horn from blowing.

If you need info on how to fix it i can help. You will need a test light or a voltmeter.

You can also try swapping the horn relay with another relay in the fuse block that is the same. If the horn works normally than the relay is bad and will need to be replaced.

Feb 14, 2012 | 2003 Pontiac Grand Am

1 Answer

I have a 2008 chrysler 300 and I installed an alarm system. I connected the factory horn to the alarm using a relay. I installed a relay under the hood and got the power from the battery the problem is...


you have either a blown fuse or the factory wire harness isnt connected to horn first check fuse owners manual will have location and description of fuses if ok retrace your steps when you hooked horn to new alarm you disconnected wire at horn or you cut the wire to access horn wiring

hope this helps
plz vote leave a comment if need more help reply

Jan 18, 2011 | 2008 Chrysler 300

1 Answer

Horn does not work


This could be as simple as a fuse. Under your left hand side dash there should be the fuse box but it may be on your left side or even in the glove box.
Once you locate the fuse box then look for horn in the diagram on the outer cover or under neither the inside of the outer cover. If you have no cover or diagram then just start pulling one fuse at a time and checking the wire inside to see if is burnt through. Replace any that are bad. The next step would be to take to lead wires long enough to reach from the battery to the horn under the hood. Put one lead on the positive side and one on the negative side and touch the other end of the wires to the connection ends of the horn. I bet you can't keep from jumping when it honks. If it does honk then the problem lies elsewhere. Let me know if this fixed the problem and if not I will delve into it further with you. The Raz

Apr 16, 2010 | 1996 Chevrolet S-10 Pickup

1 Answer

Horn honks when turning, randomly


sounds like a electrical problem. When you turn it is completing the circuit some how, sounds like wires are touching each other and making the horn honk when turning. easiest thing is remove the fuse if possible.

Feb 06, 2010 | 1989 Volkswagen Golf

1 Answer

My 92 Buick horn won't honk ever even when you lock the doors and try to open them without unlocking them --it never honks. What can I do?


I would first try pulling fuses to see if it is bad there. If not, you can try to run wires directly from the battery to the horn to see it it can honk. Disconnect it from the circuitry and then just touch the wires to the terminals.

Jul 16, 2009 | 1992 Buick Park Avenue

1 Answer

1992 Dodge Ram 50: Horn honks all by itself.


Check the horn actuating contact at the centre of the steering wheel. It may be damaged or mis-aligned.
Also check the carbon contact that runs on the slip ring under the steering wheel (associated with steering wheel horn actuate switch) It may be damaged or mis-aligned.

If none of the above are faulty, you should look for a possible intermittent short to ground on the horn actuation control wiring.

Jun 12, 2009 | 1992 Dodge Power Ram 50

Not finding what you are looking for?
1998 Buick LeSabre Logo

Related Topics:

664 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...