Question about 2001 Dodge Intrepid

1 Answer

Nocking motor the motor starts nocking after about ten to fifteen minutes of running.and looks like it is overheating but i do not understand the overheating signals on the dashboard.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The motor starts nocking after about ten to fifteen minutes of running.and looks like it is overheating but i do not understand the overheating signals on the dashboard.

Posted on Oct 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine running rich


Most likely throttle positioning sencer

May 08, 2016 | Cars & Trucks

1 Answer

My windshield wipers run wide open no matter where the switch is set. Also, the don't go down when the switch is turned off.


Undo the motor... wait a good ten fifteen minutes push wipers down reconnect the motor try again

Oct 29, 2015 | 1997 Chevrolet Cavalier

2 Answers

1997 chey lumina runs fine until motor warm-up then shut off and won't start until motor cool off


Try getting your transmission solenoid replaced. After I got mine replaced it ran fine after that. That's the exact same thing my Lumina was doing.

Sep 12, 2012 | 1991 Chevrolet Lumina

1 Answer

Starts fine runs until reaches normal temp,then dies?


here are a few causes for this. low coolant, failing coolant tepurature sensor, air in water pump, failed radiator fan, it takes ten to fifteen minutes to reach operating range. good-day !!

Jul 16, 2011 | 1991 Honda Accord

1 Answer

Car was running but shutdown after ten minutes


IF your car is NOT overheating (temp gauges are normal) and the vehicle will not start when the motor has warmed up there are two potential problems that are common. If the car won't run right or start right when warm, but does so when cold, look for a failing cam position sensor. If the car starter won't turn over correctly when the motor is warmed up, but does so when cold, suspect a failing bushing that holds the starter shaft in line. A starter repair is needed to fix that. I hop this is helpful. More details about what you have tried would help the community at Fixya to troubleshoot your issue.

Feb 10, 2011 | 1998 Dodge Stratus

1 Answer

My car anti-theft seems to have kicked in and I can't get it to start. What do I do next?


hi, you can perform the reset with just your key and a battery charger to see if this will allow for restart. what you do is, hook up a battery charger to start with, low amperage setting like 15 amp, or maybe 2 amp, and leave it on the battery, you will be leaving the key on for up to an hour and the battery must not die during this time. turn the key on and try to start once for about 1-2 seconds, then let go and let key rest in run position for fifteen minutes at minimum. then turn off the key, wait ten seconds, and turn on again to run position only, leave on for another fifiteen minutes, then again, turn off for ten seconds, turn back on to run position for fifteen minutes. after this time, turn the key off, wait ten seconds, and try to start the car. if it starts, check to see if the check engine light is illuminated, or the security light is on, if one or the other is on, take to a shop and have codes checked and diagnosed, if no lights on, you should be able to drive on. if the vehicle does not start after three reset key cycles, try the process one more time. it may have been interupted somehow. if you try twice and still no start, you have to have diagnosed further, maybe in the key, maybe in the lock cylinder, maybe in the theft module.

Jun 30, 2010 | 2000 Buick Regal

1 Answer

My 2000 ford explorer runs rough when started after sitting for a while but once i drive down the road for ten to fifteen minutes it runs better.


Have a mechanic check your idle bypass valve, since it may be bad
or need cleaning, also, have a tune-up done, if you haven't had one in
the past 30K miles. Good luck.

Mar 27, 2010 | 2000 Ford Explorer

1 Answer

Starts nocking 10 minuits after running sound great the first ten minuits and the truck throws no codes


a 95 is only obd1 so problably wont get many codes. the oil is thicker in the first ten minutes or so, after it warms up the oil thins out. short of rebuilding the engine and/or doing a head job, try some lucas oil treatment or high tach. both are very viscous and help with thin oil

Oct 03, 2009 | 1995 GMC Sonoma

1 Answer

How do I program my key for my 2006 Chevy Impala?


Add Duplicate Key (PK3 or PK3+ key)
1. Insert an existing key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.
Originate New Master Key (PK3 or PK3+ key)

1. Insert new key into ignition cylinder and turn it to the ON (RUN) position.
The security light on the dash will illuminate and stay on for ten minutes.
2. When the security light goes out, you have one minute to start the next
step. Turn the ignition cylinder to OFF and then back to the ON (RUN)
position. The security light on the dash will illuminate and stay on for ten
more minutes.
3. When the security light goes out, you have one minute to start the next
step. Turn the ignition cylinder to OFF and then back on the ON (RUN)
position. The security light on the dash will illuminate and stay on for ten
more minutes.
4. After the security light has gone off the third time, the key has been programmed
into the vehicle’s computer and will operate the car. It has replaced ALL the
previous electronic key codes and is the ONLY key programmed into the
vehicle’s computer.

Add Duplicate Key (PK3 or PK3+ key)

1. Insert an existing key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.

May 20, 2009 | 2006 Chevrolet Impala

Not finding what you are looking for?
2001 Dodge Intrepid Logo

Related Topics:

439 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...