Question about 1995 Honda Civic del sol

2 Answers

Brake Problems The brake pedal on my del sol sometimes goes to the floor, I have enough fluid, I think it might be the Master cylinder but want to know if it can be anything else?

Posted by on

2 Answers

Same issue here, Turns out it was the Master Cylinder as well. You could also try bleeding the brake lines because sometimes air gets trapped and can cause the brake pedal to depress too easily.

Posted on Sep 22, 2008

I had the same issue, and it was the master cylinder. Got the part through napa. Brakes are strong now

Posted on Aug 08, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1999 buick century brake pedal goes to floor-put new master cylinder on and blead both brake lines and master cylinder and pedal still goes to floor


Sounds like you may have a hydraulic leak somewhere. Check the rear wheel cylinders and front brake hoses going to the calipers.

Jan 26, 2012 | 1999 Buick Century

1 Answer

I replaced disc brake pads, rear shoes. wheel cylinder,master cylinder, power brake booster all new. Question: My brake pedal is not solid,goes low to the floor almost. I have bled the master cylinder 1st,...


Check your lines going to the brakes the rubber hose on the 1993 chevy have a tendancy to crack and brake are you using an excess of brake fluid

Sep 12, 2011 | 1993 Chevrolet C1500

2 Answers

The brake cylinder in the right rear tire started leaking. I changed it and bled the brakes., now they won't stop and will go all the way to the floor. where and how do I adjust them? THANK YOU jOE!


You may need to further bleed the brakes. Something pumping to bleed the brakes can **** in air at the brake fluid reservoir. Try using a vacuum pump to **** out brake fluid from the release screw at the brake side. Make sure you always have enough fluid at the reservoir.

Feb 28, 2011 | Chevrolet Caprice Cars & Trucks

3 Answers

Brake pedal goes to the floor? replaced all the brakes and bled them. worked for very short time and now the pedal goes to the floor.


If the fluid level is staying constant then it sounds like the brake master cylinder or the master cylinder booster. If the seals are bad on the master cylinder the piston just goes through the fluid. Many boosters use air pressure to assist in the braking proces and it could have a leak.

Mar 14, 2010 | 1996 Chrysler Town & Country

1 Answer

Brake pedal is sometimes sinking to floor. Brake


most likely your master cylinder is acting up try to press hard on your break for a period of time and see if the pedal will sink/replace master

Jan 13, 2010 | 1993 Toyota Pickup

2 Answers

Brake pedal still goes to floor 2000 GMC Jimmy


It's very possible to be the master cylinder, the o-rings on the piston could be worn, letting the fluid seep back through instead of getting full pressure through the lines. Could also be the brake booster.
Try changing the master cylinder first, which is cheaper and easier, and see if there is a difference, you'll need to bleed the brakes again.
To check the booster,
With the engine off, pump the brakes until the pedal is hard, then hold pressure on the brake pedal and listen for air escaping, or the pedal goes slowly to the floor, Do that after the master cylinder has been changed, at least that will be eliminated.

Sep 15, 2009 | 2000 GMC Jimmy

3 Answers

Brakes


bad power booster

Jul 13, 2009 | 2002 Nissan Sentra

3 Answers

Replace brakes. now they go to the floor. bled air


When you fixed the brakes, did you take the lid off the master cylinder. I just wonder if you spilled out your brake fluid. The only reason the pedal should go to the floor is if the brake fluid is gone or the master cylinder is not working. Check the fuse. Check the brake fluid level. The pedal only goes to the floor if there is no back pressure in the lines between the master cylinder the lines to the brake pistion on the calipers. Please give me a good ratin and keep me informed.

Jul 07, 2009 | 1999 Cadillac DeVille

1 Answer

96 Taurus brakes


Presuming you have NO leaks in the hydraulic system,it would be a bad brake master cylinder.What's happening is,the piston inside the master cylinder has rubber seals,and when the pedal goes to the floor,the master cylinder is leaking internally,past the rubber seals.If the brake booster was bad,the symptom would be an extrememly HARD,unresponsive,brake pedal,and the engine would idle terrible (vacuum leak).Good luck.

Jul 10, 2008 | 1994 Ford Taurus

Not finding what you are looking for?
1995 Honda Civic del sol Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...