Question about 1990 Mazda MX-6

1 Answer

Primera starter motor

A leaflette which came with my new srarter said that "a week or defective battery will damage the starter motor" and the battery should be load tested befroe starting the car. Is this really important or can I try it first.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Nissan Primera starter motor, problem was solved by ringing a local mechanic.

Posted on Jul 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 92 nissan primera wont start lights work on dash board turn key on wont start


turn headlight on - either with another person or facing a wall.
try starting. If lights dim it is a bad battery ot connection to the battery.
If not it is in ur starter ckt - relay, starter motor, starter solinoid.

Aug 11, 2014 | Cars & Trucks

1 Answer

I cant find the starter motor on my nissan primera p11 1.8 saloon. need to take it off to get it reconditioned as some times it spins and makes a whizzen noise


follow your positive battery cable the starter is at that end ,or locate the fly wheel is between the motor and the transmission

May 03, 2011 | Nissan Pulsar Cars & Trucks

1 Answer

07 Dodge Ram 2500-starter is cycling when the key is not even in the ignition. Changed out starter, still cycling when off.


the srarter relay is stuck, you need to replace it . you will find this under the hood on the driver's side= follow the Positive battery cable to it. good luck.

Jan 03, 2011 | 2005 Dodge Ram 2500 Truck

1 Answer

I have a Nissan Primera 2002. The battery appears to be fine, although when attempting to start the motor there is a click sound and no engagement of starter motor. What can be the cause of this problem.


Chances are, you have a problem with the solenoid contacts inside the solenoid that is mounted on the starter assembly. It is a very common problem with a lot of the starters used on some Nissan products. Here is a very good site that explains the repair procedure, or you can just have the starter assembly replaced.

http://www.4crawler.com/4x4/CheapTricks/Starter.shtml

Dec 28, 2010 | Nissan Pulsar Cars & Trucks

1 Answer

I have a 2000 Nissan Maxima that was having trouble starting. I put a charger on the battery over night but it would not even turn over. I replaced the battery but it still won't turn over?


Check the following:
1. Broken, loose or disconnected wiring in the starting circuit.
2. Starter motor pinion jammed in flywheel ring gear
3. Starter Solenoid faulty
4. Starter motor faulty
5. Ignition switch faulty
6. Defective Battery fusible link (140 amp)
7. Automatic transaxle not completely engaged in park or clutch pedal not completely depressed.
8. Broken or stripped timing chain
9. Ignition components damp or damaged.
10. Broken, loose or disconnected wires at hte ignition coils or faulty coils.
11. Defective MAF sensor.
12. Worn, faulty or incorrectly gapped spark plugs.

Jun 27, 2010 | 2000 Nissan Maxima

1 Answer

Nissan primera- starter motor needs new brushes . how long to repair?


I don't think you can even get starter brushes,unless we roll the clock back to 1970.

May 25, 2010 | 1995 Nissan Altima

1 Answer

How do i remove the starter


First thing is to remove the negative wire from the battery. Raise the front of car/truck and use jackstands to support it. Block the rear tires. Remove electrical wires from srarter solinoid and mark them so you will know how to put them back in the right spot. Then remove the starter mounting bolts and remove the starter for the car/truck. installation is the reverse of removal. Hope this will help you.

May 20, 2010 | Cars & Trucks

1 Answer

Starter solinoid replacement enstruction


SOLENOID REPLACEMENT
(see Figures 5, 6 and 7)

Prior to removing the solenoid from the starter motor unit, matchmark the solenoid-to-starter motor housing position, as shown in the accompanying illustration.
  1. Remove the starter motor from the vehicle.
  2. Detach the solenoid-to-starter motor wire from the solenoid terminal.

Do not disassemble the solenoid; if the solenoid is defective, replace the entire unit with a new one.
  1. Remove the two attaching screws, then slide the solenoid out of the starter motor housing flange.
9b9a219.jpg

Fig. 5: Before removing the starter motor solenoid, matchmark the solenoid-to-starter motor housing relationship

44d3238.jpg

Fig. 6: Disconnect the field coil lead from the solenoid by loosening the retaining nut ...

e357fdb.jpg

Fig. 7: ... then remove the two attaching screws and separate the solenoid from the motor housing


To install:
  1. Inspect the solenoid plunger joint for wear or other damage. Replace it, if damage is evident.
  2. Apply Suzuki Super Grease A (99000-25010) or equivalent, to the solenoid plunger and to the tip of the lever arm (inside the starter motor-to-solenoid housing hole).
  3. Insert the solenoid into the starter motor housing, ensuring that the matchmarks made during removal are aligned.
  4. Install and tighten the two attaching screws securely.
  5. Attach the starter motor-to-solenoid wire to the solenoid terminal.
  6. While the starter motor is removed form the vehicle, perform the testing procedure to ensure that the new solenoid functions properly.
  7. Install the starter motor.

Hope this help (remember rated and comment this).

Mar 23, 2010 | 1994 Geo Tracker

1 Answer

Nissan primera wont start


could b anything try the battery first as its the easyest prob to fix if its nt that could b plugs, starter motor, fuel pump. shouldnt b anything too expensive to fix

Feb 22, 2010 | 2002 Nissan Quest

1 Answer

Starts at times but not at others. maybe a theft deterent problem?I it started like 8 times consecutively and now all electrical works but no crank or anything.


Try this keep your headlights on and crank starter. Do lights go out?Dash too? If your battery is fully charged it is most likely your srarter motor ,if clicking then selonoid. A starter is a motor with brushes that wear out just like any motor.Try to see if a jump start cranks the motor,if so then your battery doesn't have enough cranking amps to start.Also clean battery posts cables make sure all are tight including grounds.Good luck.

Sep 19, 2009 | 2000 Mercury Mountaineer

Not finding what you are looking for?
1990 Mazda MX-6 Logo

591 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...