Question about 2007 Chevrolet Suburban Three-Quarter-Ton LS

1 Answer

2007 Suburban C-1500

Engine seems to run fine, but the yellow indicator outline of an engine profile is lit continuously on the instrument panel and won't go out. Have checked the gas cap per the manual. Any suggestions as to what the problem may be?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had the same problem. I had to replace the Evpor Soinoid ( not sure of spelling). it is located underneth the spare tire. It cost me $33 and did it myself. Fixed problem. just don't forget to disconnect the battery.

Posted on Sep 15, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 chevy trailblazer is not charging battery. battery and alt are new


Volts slowly drop to where what quits ,The vehicle stops running ? Is the charge indicator light lit on the instrument cluster /? are any lights lit on the instrument cluster ? The instrument panel cluster (IPC) illuminates the charge indicator and the BATTERY NOT CHARGING message is displayed in the message center when the following occurs:
The engine control module (ECM)/powertrain control module (PCM) detects that the generator output is less than 11 volts or greater than 16 volts. The IPC receives a serial data message from the ECM/PCM requesting illumination.


?€¢
The IPC determines that the system voltage is less than 11 volts or greater than 16 volts. The IPC receives a serial data message from the body control module (BCM) indicating the system voltage.


?€¢
The IPC performs the displays test at the start of each ignition cycle. The indicator illuminates for approximately 3 seconds.


?€¢
The ignition is on, with the engine off

Mar 11, 2015 | 2006 Chevrolet Trailblazer

1 Answer

I have a 2007 1500 suburban - check engine light came on and started missing - code showed cylinder 1 missing - i changed spark plugs and noticed that the #1 spark plug had a piece of the ceramic broken...


cylinder 1 getting too hot causing ceremic crack could have wrong heat range plug in which spark plug too hot.or need replace spark plug wires.one plug wire could be bad best replace all spark plug wires.

Sep 08, 2013 | Chevrolet C1500 Cars & Trucks

1 Answer

2003 chev silverado instrument panel gear light out


The selector sensor sends a signal to the engine computer which sends power to the indicator.

Jul 22, 2013 | 2003 Chevrolet Silverado 1500

1 Answer

I have a 2007 1500 suburban with 5.3L ''Still under warrenty'' When I decelerate then accelerate, the engine valves clatter, should I hear any at all or maybe the question is how much is normal


Is it valve clatter or spark knock. You should not have any valve noise or knocking noises from the engine. Has the service engine light ever come on.
You can have the Suburban scanned at your local Auto Zone or Advance Auto Parts free of charge.
Let me know.
Regards,

Apr 10, 2009 | 2007 Chevrolet Tahoe

1 Answer

Orange or red engine outline


Oil light/sensor is more than likely triggering chk engine light. Chk oil sending unit ,oil level. All else fails ck w/dealer. 03's had instrument panel recall. ck with dealer for any recalls in effect.

Apr 05, 2009 | 2004 Chevrolet Silverado 1500 Crew Cab

2 Answers

Oil Lamp Indicator in instrument panel stays lit (1997 Camery)


I would go back to Walmart and have them fix it for free. I suspect it's a bad oil filter. If you hear engine knocking or noise, don't drive vehicle.

Feb 23, 2009 | 1997 Toyota Camry

1 Answer

Engine comes on dash 2007 jeep grand cherokee


if you are talking about the yellow engine symbol in the instrument cluster it is telling you there is some kind of problem and you ned to have the codes checked to get an idea what it may be

Jan 06, 2009 | 2007 Jeep Grand Cherokee Overland

5 Answers

Switch off tire pressure warning light


From the manual: First find the reset button, located below the handbrake (emergency brake) lever. The button has an "exclamation mark in a tyre" symbol.

Make sure the pressures in all tyres are what you want them to be. 35psi all 'round is good for sporty driving.

Engine off. Turn ignition to the second position (ON) but don't start the engine.

Keep the re-set button pressed until the flat tyre indicator light on the dashboard COMES ON for several seconds.

Start the engine, and drive the car normally for several minutes. This will re-set the indicator to whatever pressures you have in the tyres. Hope this helps!!

May 15, 2008 | 2004 Mini Cooper

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

175 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...