Where is crank sensor - 1994 Chevrolet Lumina APV

images for Where is crankshaft sensor location on 95 ...

eplaced engine on '97 SC300 now new engine does not have Crank ...

www.clublexus.com/.../633233-replaced-engine-on-97-sc300-now-new-...

May 4, 2012 - Location: arizona. Posts: 3 ... apparently 95-97s had an additional crank sensor. .... 1995 Lexus SC300 5spd Na-T ( TT Ecu Mod + a few others) 2jzge position sensor??
Nov 2, 2011
SC400 Crank Shaft Position Sensor. WHERE?????
Oct 11, 2011
SC300 No Spark
Oct 2, 2010
What happens if the Camshaft Position Sensor goes bad?
Jun 18, 2009
More results from www.clublexus.com

Lexus Crank Position Sensor ' LS400 SC300 ES300 GS300 ...

www.partsgeek.com > Crank Position Sensor > Lexus Parts & Accessories

Products 1 - 10 of 68 - 95 1995 Lexus LS400 Crank Position Sensor Denso NLA 7/13 ... 96 1996 Lexus SC300 Crank Position Sensor Denso Includes Pigtail.

Crank shaft sensor.

i think it's the starter. On most nissans, the starter and the crank position sensor are close to each other. Some nissans have 4 position sensors, between crank sensor, crank angle sensor, cam position sensor, and sensor sensing sensor, oh and cam angle sensor. Oh wait, maybe it's a bad ground. Nope, gotta be the staerter.

The crank sensor is not a powered sensor, it is a hall effect device.

To replace crank angle sensor .
1.you will need to remove drive belt
2.remove harmonic balancer to get to crank angle sensor
3.remove crank angle sensor
then do these steps in reverse to reassembly

If the crank sensor circuit is malfunctioning, then that is your problem. The code does not mean that you must replace your crank sensor. (sometimes it means this, sometimes it does not) The code means that either the crank sensor CIRCUIT is out of range or the crank sensor cannot SYNCRONIZE with the cam sensor. There is a whole lot more to diagnosing a crank sensor circuit than simply replacing the crank sensor. Proper diagnostic procedures need to be followed to locate the exact cause of the problem.

sounds ike it could be the Crank sensor, do you have the OBDII code off hand?

the crank sensor sends the signal to the coil, i would check it next

Does this pertain to the Crank Shaft or the Ignition sensor? I've never heard of a crank sensor... I'll check...

I found this from a guy on another website..."It does however have a crank sensor and if you look at the lower crank pulley just to the back of the pulley and go around the pulley you should find the sensor mounted on a bracket. You should see what appears as a sprocket with widely spaced teeth on the engine side of the pulley. This "sprocket" so to speak is what the crank sensor "reads". I believe that the crank sensor is the only sensor used for engine timing. "

Good Luck

crank sensor location