Question about 1996 Dodge Caravan

1 Answer

Plz help The heather level is not working what do i need to fix. it only works on high

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

I'm thinking that you may possibly mean that the blower motor is only working in the highest position. I suggest that you find the resistor bridge and replace it, but I'm sorry that I don't know where it is on this vehicle. Good luck.

Posted on Jul 29, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How can I fix my Heather is not working And the light work on the panel but it don't throw heat my car is a Nissan quest 1997

Worth engine cold check coolant level

Carefully with the engine warm place your hand on the two heater core hoses at the back passenger side of the engine compartment. If one is cold compared to the other then you need a heater core. If both are about the same temp then you probably have a stuck blend door.

Oct 24, 2016 | 1997 Nissan Quest

1 Answer

My LandRover lr3 was stuck in park I googled temperaily got it out to get it home but it is stuck again now. Is there a way I can reset it so the issue stops? Thank you for your help, Heather

Hi Heather, I'm Al the owner of Big A's Auto Repair
The easiest way to solve this problem is to replace the shifter unit itself. What happens is the solenoid on some units quits working and on other units the lever breaks and won't allow the shifter to move out of park. Give me a call from my website if you need further help. Have an awesome day Heather.
Auto Repair

Feb 01, 2015 | 2006 Land Rover LR3

1 Answer

A week ago my car stop having hot heather when i was stuck in the traffic and as soon as i move again the heather was i have no heather at all and my heather gage goes high...what could it e

Please RUN the scanner /computer for easy diagnostic, the electronic involve in the car now is very complicated. You must have very skill in electronic+electricity for troubleshooting+instruments

God bless you

Oct 30, 2013 | 2004 Nissan Sentra

1 Answer

Blower switch only works on high on nissan sentra 1995

Hi Heather,sounds like your blower motor resister is bad,that's one of the signs that it's bad,running on one speed,if relay were back,it would run always or not at all.It is located next to the bolwer motor,2 screws hold it on,just remove them with a phillips screwdriver and first disconnect electrical connector from it.Here's where the blower motor is.Here's the resister.

Feb 17, 2013 | Cars & Trucks

1 Answer

Ok the car dosent shift properly and it stalles out could it be the tps or what plz give me a call at 4802383284 if u can help me plz and thank u so much

Seems to be a transmission issue. From your description of the issue it looks like the trans is attempting to go into what is called limp mode. Start and run the car shift into all gears and allow the car to reach it's normal operating temp. Then check the trans oil level. Simplest fix is not enough oil which can be fixed by adding more oil. Make sure you purchase the correct type for your transmission. Or there could be damage to the transmssion which would need to be taken care of by a professional shop

Nov 16, 2011 | 1990 Oldsmobile Eighty Eight

1 Answer

Fan only works in high

Resistor burned out located on heather blower.I don't think they sell it separatly, but instead you will have to replace blower unit located on passenger side dashboard

Jan 04, 2010 | 2000 Ford Focus

1 Answer

Plz help

could be broken heater wire for O2 sensor. go here for files and pics for villager

Jul 09, 2009 | 1997 Mercury Villager

1 Answer

A/c heater climat control switch

Check the relais module located inside under the rh side of the heather box you can see the connector most of them need to be replaced as they burn out you may need to replace the blower motor as well,high amp draw caused by faulty bearings will overload the blower motor controller

Jan 16, 2009 | 2004 Chevrolet Silverado 1500 Crew Cab

Not finding what you are looking for?
1996 Dodge Caravan Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides