Question about 2000 Cadillac Catera

4 Answers

Have a 2000 Cadillac Catera and the passanger rear window goes down but it is not coming up. Trying to find how to remove door panel and repair it. Any suggestions

Posted by on

  • 1 more comment 
  • robert1961k Dec 09, 2008

    I have the same problem. A mechanic worked on it for a while and decided the window seemed to be a bad fit. Catching/seizing. I just stopped using the window.

  • taylor_debor Dec 27, 2008

    my left back window does the same. I was told it needed a new motor on that window. goes down have to pull it up.

    One good thing if I ever lock in my keys I can get them out! LOL

  • bellj2282 Dec 31, 2008

    my engine light is on have replaced o2 sensor and still is on until some one resets it, also my radiator light is on no problem their, i also have a light on that looks like a tire, and finally my radio goes off and comes back on can you advise?

×

4 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 4 Answers

First, you want to remove the 4 screws on the door panel. Next you have to remove the door grip. To do this, you have to get a small screwdriver with a long shaft. Insert it into the top of the grip and it will force a clip that holds the grip to the handle. Remove the screw found there. Next is the tricky part. You have to find something very small but capable of prying with. Pull door lock up, pry out the orange clip - it may take some doing so don't give up. After you have removed clip, remove screw found there. Finally pull cover from around door handle and remove final screw.

Posted on Jun 07, 2009

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

There is a screw behind the ashtray of the door, and also another
in the armrest of the door.....underneath little cap. Once removed, the motor assembly can be removed by drilling the rivits out. The
replacement can be installed by using M5-0,8mm x 12mm bolts
and nuts (part # 44192 at Advanced Auto Parts. Motor assembly
for window was purchased at Salvage Yard for $40.

Posted on May 19, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

On the 2000 Catera, the rear door panel is held together with screws around the perimeter ,behind the ashtray and the one in the middle which is located under a rubber cap at the bottom of the door grip well.Which is hard to see.

Posted on Sep 13, 2009

Darn. i have the exact same prob and i was hoping there would be a solution in here. i removes all the screws around the outside and in the door handle but could not figure out how it was still connected to the door in the middle of the panel.

Posted on Aug 11, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rear passanger electric window keeps falling down. buick century 2000. Have it taped up, is it the moter or just off the track? What do I have to do? to tell what is wrong?hanks


either the cable is worn or broken, or the window has come off the old down bracket that holds the glass in place,, remove the inner panel of the door and look to see that the window is attached to the mechanism and that the window glides in the door haven't come loose

Jun 01, 2011 | 2000 Buick Century

3 Answers

Car: 2000 Cadillac Catera Radio: Bose Info: Power goes off to radio, fuel door and trunk release. Seems to happen randomly. Any thoughts?


K134 Multifunction relay is on the driver side, inside the dash above the driver's left ankle (area). (2) panels need to be removed below the steering column to access this area. The first is a panel that matches your dash. The second is a cardboard panel with foam padding on it that encompasses the arms holding the brake pedal and accelerator. You'll then need to lay on your back on the floor board, head in first. Look for a gray box about 3" square by 1 1/2" thick. Push it 'up' off of it's mounting bracket to release. Unplug the wiring harness. Plug in new relay and re-mount.

Nov 01, 2010 | 2000 Cadillac Catera

3 Answers

My radio, trunk and fuel door all work sometimes. Where is the Multifunction relay? I believe the part# 90494163 It is a 2000 Catera Cadillac. Thanks


K134 Multifunction relay is under the dash on the driver side. When sitting in driver seat, above your left ankle, it is located behind a cardboard panel. Replacing cures many problems with the Bose radio, sunroof, gas and trunk releases, fog lights.

Oct 28, 2010 | 2000 Cadillac Catera

1 Answer

I am a owner of a 2000 cadillac catera and my driver and passanger side vents blow only cold air when the heat is on. Please help!


THIS PROBLEM OF NO HEAT IS CAUSED BY A FAILED AC/HEATER AIR TEMPERATURE CONTROL BLEND DOOR OR BY THE MOTORIZED ACTUATOR THAT MOVES THAT DOOR, THESE ARE THE ONLY PARTS THAT CAN CAUSE THIS PROBLEM, WHICH IS COMMON IN LATE MODEL CARS SINCE THE 90'S, THE REAL PROBLEM IS THAT THE DASH MUST BE REMOVED FROM THE CAR TO ACCESS THESE PARTS.

Oct 27, 2009 | 2000 Cadillac Catera

1 Answer

My brake and all back lights went out. Sometimes my radio suddenly goes out what should i do 2000 cadillac catera


When you say all back lights go out is that also the indecators as well if no then the problem sounds like in the wire conectors from front to rear but if indecators also go out then you have a brake in the wires or plug coming adrift somewhere like under the Firewall/Seats or along the side were the wires run /or in the boot where something has been pulled or moved,, turn on lights play around with wires untill goes out ,,,then find and FIX

Oct 06, 2009 | 2000 Cadillac Catera

1 Answer

How do i remove the rear passanger 2000buick lasabre door panel.


You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

May 08, 2009 | 2000 Buick LeSabre

1 Answer

How do you take out the little window in the rear dooe in a 98 cadillac catera?


hi take the door panel off then find the screws to remove the rear window door frame with window. good luck

Mar 20, 2009 | 1998 Cadillac Catera

Not finding what you are looking for?
2000 Cadillac Catera Logo

637 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

64052 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...