Front passenger window does not work

Window regulator is bad in the drivers door . Do you know what a regulator is ? The Trainer 24 Power Window Troubleshooting Do you know anything about automotive electrical testing ? How to read an use a wiring diagram ? Do you know there are two side to a electrical circuit ? B+ voltage an a ground side . Plus there is electronic control modules and class 2 serial data network involved . When you push the switch for a window othen then drivers window on the drivers door . a class 2 message is sent to the other doors modules . The correct module will then open it's window .
http://www.bbbind.com/free_tsb.html Check out free wiring diagram here .Enter vehicle info . year , make , model and engine size. Under system click on body & accessories , subsystem click power windows . Click search button , then click each link one at a time .

Have to remove the door panel & replace a broken
window regulator

If the motor and regulator both work fine or sound like they are engaging when your try to raise the window,but you hear nothing when you try to lower the window then I think it is a pretty safe bet to say your switch is bad.

The problem is that you probably have pushe dhte rear window button thinking it wasthe front window button. Have you ever pushed the rear window button thinking it was the front and then push harder. Inside the switch ther are little plastic pins. Open the switch and turn the little pns around and you should e fine. you cna e-mail me if you like and I can tell youhow to fix it...jams1@cox.net

Sound like a window switch.
If you didn't hear any mechanical noises from window before it happened , most likly - switch.If noises were present , might be window regulator or a motor.

I would suggest the switch as if the motor was faulty it wouldn't have gone down. The extended warranty should cover that..

Taps maybe. Just kidding. there is an apparent short in the switching.

If you can do it, run a jumper from the drivers door to the passenger door. Unplug both motors. try to run the passengers door off the drivers switch to rule out the motor. I don't think it is because the motor is dc. But this is the common point. Please mark this as helpful or fixya. Shuold you have anymore problems, I used to be a mobile mechanic electircian. Looking forward to hearing from you.

The gears may be stripped. In any case you may be able to raise the window by hand by pulling it up and, on the cheap and easy, duct tape the window up (it's already broke you can't make it too much worse unless you break the glass). If you can't just pull it up you will have to take the door apart and check out what's really going on ... Try to push it up by hand from inside the door and see what the problem is. Be very carefull if you should try to run the window with the motor never put your hands in a place that they could be mangled by the motor or the movement of the window if it should 'catch'... You can also prop the window up from inside the door with a vice grip or a piece of wood of the correct length.

Krischen,
Same problem appeared on my car, and sometimes it helps if you shut the passenger door at the same time as pushing the button to make the window go up, but mostly it's not something you can fix. They just wear out like most other things on this car