Question about 1995 Ford Mustang

2 Answers

No brake lights have turn signals and running lights

Posted by on

  • Difm646 Jul 22, 2008

    bulbs ok will check switch

×

2 Answers

I have checked the bulbs and they are good as well as the fuses. I cannot signal left and my left brake light doen't turn on either. I am at a lost here.. can someone please help?.. thanks in advance

Posted on Aug 13, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 60 Answers

There is a switch on the brake pedal that makes the brake lights come on. You may check that to ensure it is working properly. You can also check the bulbs to make sure the high filament hasn't burned out in them.

Posted on Jul 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

Tip

Both Lower Brake Lights Not Working


Check Brake Light Bulbs: All cars have three brake light bulbs that create the brake light illumination affect. If the lower two bulbs fail no lower brake light operation will occur. I know what you're thinking, you might say two brake lights at once? But in reality one brake light went out at a time and you did not notice. People only tend to notice something when they almost run into the back of your car to help persuade them to inform you the brake lights aren't working. Remove either of the brake light bulbs to confirm the bulb is ok or burned. After the bulb has been removed inspect the filament and replace if failed. If the brake light bulbs are ok continue to the next step.

Checking the Turn Signal Switch: Most American cars are designed to have the brake light switch wiring intergraded into the turn signal switch. Because the brake light bulb and the turn signal bulb are one and the same the turn signal switch interrupts the brake light circuit and installs the blinker signal circuit when the turn signal switch is activated. If this switch fails it will not allow the brake light signal through to the brake light wiring. To test for this condition a car repair manual is needed to test incoming and outgoing electrical current. If brake light switch power is present at the turn signal switch but not at any outgoing brake light wires the turn signal switch has probably failed.

on Dec 18, 2009 | Honda Civic Cars & Trucks

2 Answers

Turn signal and brake light not working.


Change the bulb.The bulb has two lights.Running,and brake light turn signal.Its the bulb

Apr 14, 2013 | 2004 Chevrolet Silverado 1500

1 Answer

95 mustange gt brake light dont work check #9 fuses change all bulbs replaced switch on brake pedal hazards lights works ,parking or running lights works,turning signal lights works,what other places i...


I assume the fuse has power if the hazards work.
The third brake light skips the turn signal switch, the regular brake light circuit goes thru the turn signal switch.
Do you have power going into the turn signal switch on the red lite green wire from the brake switch ?

Feb 17, 2013 | 1995 Ford Mustang

1 Answer

Turn signal,brake lights not working


I would check for voltage at the turn signal switch. The brake lights go thru the turn signal switch, except for the high mount light.

Jul 24, 2012 | Cars & Trucks

2 Answers

95' Buick regal, 3rd brake light works, tail lights work, turn signals work, stoplight switch seems to work ie 3rd brake light working, fuse is ok, changed bulbs, but no rear brake lights.


If the third brake light works and the regular ones don't, it is most likely a bad turn signal (multifunction) switch. The switch is able to kill the brakes lights to run the turn signals, and in rare circumstances does this. I've seen it several times. It could also be wiring, especially near the turn signal switch, but it is usually the switch.

Nov 25, 2009 | 1995 Buick Regal

2 Answers

Rear turn signals and brake lights out. Front signals and rear tail lights work fine.


the brake lights and the rear turn signals should be the same bulb check the bulbs to make sure they are not blown does your third brake light work if all brake light are out and the bulbs are good check the brake light switch on the brake pedal

Nov 04, 2009 | 1986 GMC C1500

1 Answer

I need to know what colors are for the brake lights, left and right turn signals, running lights, brakes and flashers so I can hook up a plug for a utility trailer


brown= running lights
green=right turn
yellow=left turn
the brake lights run of of the turn signal
white is the ground

Sep 26, 2009 | 1993 Chevrolet K2500

1 Answer

Brake lights dont work, Turn Signals all goofy


First thing i would do is chg. the break light switch, and make sure to chk. all grounds around tailights, sometimes if there is a ground problem it will travel back thru the hot wire to get a ground, witch in turn makes everything go wackey.

Mar 10, 2009 | 2004 Chevrolet Tahoe

Not finding what you are looking for?
1995 Ford Mustang Logo

Related Topics:

172 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...