Question about 1997 Mercury Sable

1 Answer

Drivers power window went down but won't go back up.... replaced drivers window relay, still does not work.... all other windows work properly

Posted by on

  • kenyaellis Oct 26, 2008

    My driver side and back passenger window wont come back up? I wanted to try and replace relay but dont know where to buy them?

  • Anonymous Mar 31, 2014

    All others windows work with the same control.

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Had the same problem with mine, Removed the door panel and removed the window motor( two bolts holding it in), reconnected the window switch and ran /tested the motor. If it runs reinstall the motor and it should go up and down now. I had 2 windows jam down and this fixed both of them

Posted on Jul 23, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Tried it today and none of the windows work from master switch on drivers side except ft passenger window, which went down but will not go back up.


You can't put up the front passenger window with it's own switch ? Did you check the POWER WINDOW RELAY in the instrument panel fuse / relay box ? An you checked POWER fuse 30amp same fuse box ? All window switches have direct power from power window relay !
Fuse Block - Instrument Panel
Left of the Steering Column, behind the storage Compartment
P/W Relay
--
Sunroof Switch Assembly, Window Switch - Left Front, Window Switch - Left Rear, Window Switch - Right Front, Window Switch - Right Rear

Apr 02, 2015 | 2003 Pontiac Vibe

2 Answers

2007 toyota tacoma started truck this morning windows all went down started driving now noticed no windows will work at aall on all doors.the doors power locks work but no power any of the windows on all...


There is a Power Window Relay labeled P/W Relay. Located under the hood, bottom right hand corner of the relay / fuse block. There is a 50A fuse feeding the PW relay. After the relay there are individual fuses for each window.

Loss of ground from the Drivers Door window switch bank could also disable the windows. The window switch should ground by your left foot, under the plastic somewhere.

Feb 09, 2015 | 2007 Toyota Tacoma

1 Answer

On my 2001 kia sportage the back two windows won't go down and the right front window is stuck halfway up


make sure power windows lock out switch on driver side not on position, that will cause power windows not work or you have faulty power window relay.

Sep 11, 2012 | 2001 Ford Explorer Sport Trac

1 Answer

2000 dodge durang power window relay switch


these are all powered up from the drivers door, check the wiring in the drivers door opening area for breaks in the harness

Jun 10, 2012 | 2000 Dodge Durango

1 Answer

I have a 2005 PT Cruiser. The convertible top was down. When I went to put it back up, I had no power. The fuse was fine. I bled the pressure off the cylinders and manually put the top up. The wondows on...


HYDRAULIC PUMP/MOTOR ASSEMBLY Any diagnosis of the power top system should begin with the use of a scan tool and the proper Diagnostic Procedures Information. The scan tool can provide confirmation that the Controller Area Network (CAN) data bus is functional, that all of the electronic modules are sending and receiving the proper messages on the CAN data bus, and that the power top motor is being sent the proper hard wired output by the driver window regulator module.


NOTE: The convertible top system is equipped with a hydraulic bypass screw that is used to relieve pressure from the hydraulic system in the event that the top must be manually raised or lowered (such as a low battery or a convertible top operating concern). Always verify that the bypass screw is tight in the pump housing prior to replacing a hydraulic pump/motor assembly (Refer to 23 - Body/Convertible Top - Standard Procedure). If the power top is completely inoperative and the hydraulic pump/motor assembly is suspect, perform the following:

(Refer to 23 - Body/Seats/SEAT BACK - Removal).(Refer to 23 - Body/Convertible Top/ASSEMBLY, Hydraulic - Removal). If not OK, use a scan tool and the proper Diagnostic Procedures Information to complete diagnosis of the power top system.

On convertible vehicles, the convertible top switch is hard wired to both window regulator modules by the Power Top Switch Mux circuit. When a top operation input is received by the driver window module, it will ground the respective relay control circuit which in turn will operate the motor. If the convertible top switch is pressed and held to the down position second detent, it will command both modules to drop all windows to the fully down position. The windows cannot be raised when the convertible top switch is in the top down position. When the switch is held in the top up position and all four windows are fully up, the modules will lower the respective front window 40 mm (1.6 in), lower the respective rear window approximately 55 mm (2 in) and the driver window module will ground the top up relay control circuit. Once the top is back up the windows will not raise automatically.

Your missing that you don't have a clue on how the electronic's on your vehicle work . Your best bet , take it to a qualified repair shop . Your trying to fix something you have no clue on how it works , going at it blind .

Jan 04, 2018 | Chrysler PT Cruiser Cars & Trucks

3 Answers

Ford Taurus Window won't go up


If you are hearing the clicking from the power window relay the only things left would be a break in a wire or a failed window lift motor. If this window only goes down but not up I would inspect the wiring at the door jamb for a damaged wire. If this fails to go either way I would remove the panel, insert test light into the lift motor leads (X2)and actuate the switch, if I get power then I would replace the lift motor. If you get no power in one direction - test switch.

Jun 06, 2009 | 1999 Ford Taurus

1 Answer

Drivers side rear power window not working


the window wouldnt do that as a sign of defect. most likely the motor went out. but also maybe the clips on the windows bottom broke causing it to fall. the only way to know for sure would be to open it up it could come down to being something as simple as a switch

Sep 20, 2008 | 2002 Chrysler PT Cruiser

1 Answer

Power windows


I think on that year there is a safety switch on the inside of rear door jam so the children cannot roll windows down and fall out. It should be on the back door when you open the door look for a caution sticker that says child protection switch, I sure hope thats the problem And if so Great If not get back to me I can look up where the power relay is for rear windows. Ok Take care, Bear001

Jun 16, 2008 | 1998 Dodge Durango

Not finding what you are looking for?
1997 Mercury Sable Logo

445 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

fordexpert

Level 3 Expert

5572 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...