Question about 1990 Chevrolet Camaro

1 Answer

Iroc z needs help

1990 iroc z 305 tpi car will start if you put fuel in plenum for a few minutes then it will stall and wont start again even when running you cant give it gas or she stalls you can unplug altenator and she will allow you to give it a little gas many new parts like o2 throttle position idle air fuel filter ignition module tune up coil map sensor rebuild altenator when the car first broke down it was lossing power you could not give it gas it stayed idleing that day i put new exhaust cat back tried taking cat of but no difference fuel pump at fuel rail reads 40lb while car running looking for someone with similar problem please help cars been down for over 2 years thanks tom_bezaire76@hotmail.com

Posted by on

  • tom_bezaire7 Jan 05, 2009

    Hi checked fuses pulled motor apart got injectors out got to get them tested and redo all gaskets on car.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 26 Answers

Have you checked the fuses?

Posted on Jan 03, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Truck starts runs for a few minutes then stalls sometimes starts again sometimes wont start


Can either be fuel filter is dirty or fuel pump is going and there may be a short or burnt wire on the fuel relay. they should all be located in the same area.

Feb 29, 2016 | Cars & Trucks

1 Answer

1987 CHEVY IROC Z28 350 TPI- RUNNING RICH, LOTS OF CARBON BUILT UP ON THE INTAKE, BAD FUEL MILAGE


I'd be looking for a few things there. First, make sure that the temperature sender is working. If not, the computer thinks the engine is always cold so it sends more fuel even though it's not needed. Next, make sure that there aren't any exhaust leaks ahead of the O2 sensor. That will cause the sensor to think that the actual mixture is lean, again asking for more fuel. Also check that the O2 sensor is good. Out of range can do the same thing. There are other more complicated causes but those are the most common.

Jul 19, 2011 | 1987 Chevrolet Camaro

1 Answer

1985 iroc started this morning then stalled and will not start...... checked for fuel OK checked spark OK cranks but still will not start. Car is 305 TPI Auto


maybe check the battery, check all wired that source of electricity, and check starter assembly if its working, or go to your nearest service center and ask the mechanic for assistance











rate me please thanks.....

Jun 05, 2011 | Chevrolet Camaro Cars & Trucks

1 Answer

87 IROC WITH A ZZ4 OUT OF A 91 Z28... fitted a


Fuel pressure? Do you hear the fuel pump running? Read the codes to see if ECM is still alive. Do you have spark at the plugs? Remember all motors need 3 things to run air, fuel, and fire at the right time.

Mar 16, 2010 | 1987 Chevrolet Camaro

1 Answer

1991 5.7 TPI trans am wont start back up after warming up


This is my own take on your problem, i don't think thats enought pressure from fuel pump, thats pressure you get from throttle body injection. I believe fuel injection should be around 60 psi. Just a few pounds below that it won't run right.

Feb 09, 2009 | 1991 Pontiac Firebird

1 Answer

90 camaro ignition relay


tom_bezaire76@hotmail.com hi got a 90 iroc as well still cant figure it out if you put fuel in plenum then try to start will she start

Jun 15, 2008 | 1990 Chevrolet Camaro

1 Answer

Vacuum hose came off from somewhere


some cars have a vacium diagram tag some where under the engine compartment but if not go to autozone.com and try to get the diagram, or try to add pictures here so i know what are you refering to

Jun 15, 2008 | 1988 Chevrolet Camaro

1 Answer

1988 iroc-z 350 tpi - runs poorly when hot (190-200degrees)


Does it run poor at full throttle or between quarter and half throttle? Does it hessitate? If it does the EGR valve may be worn out. I had an 87 transam with TPI and was having problems with it stumbling and hesitating when it was warmed up. If the car starts hard and you have these problems then the issue may be low fuel pressure. Hook a guage up to the fuel rail and make sure you are getting pressure. If you are only getting a few pounds of pressure it may be the fuel pump or fuel pressure regulator. Good luck and if you thought this information was helpful please rate it when you get a chance.

Thanks - Tech101

Jun 08, 2008 | 1988 Chevrolet Camaro

Not finding what you are looking for?
1990 Chevrolet Camaro Logo

376 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

63456 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...