Question about 1998 Jeep Cherokee

1 Answer

Back lights wont turn off-got pulled over

Can you tell me where the fuse is or what to do?

Posted by on

  • samica Jul 21, 2008

    I have pulled every fuse in floor board box.

  • samica Jul 21, 2008

    back up lights, i meant.



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert that has over 500 points.


    An expert whose answer got voted for 20 times.

  • Expert
  • 183 Answers

Hi,sounds like the neutral safety/ back-up light switch may be stuck.This is located on the side of your tranny.It should have only 2 to 3 wires going to it.Unplug the connector and see if the lights go out.If so replace the switch. Good Luck!!!!

Posted on Aug 03, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Which fuse if for the door and interior lights?

If you have the owner's manual it will tell you. If you don't and the fuse is blown, use a test light. Connect light to a good ground, turn the key to run and check to see if both tabs at the top of the fuse light the test light. Any that only light from 1 tab are blown. You can also pull 1 fuse at a time to see if it is blown, remember to put it back in before pulling the next one.

Jul 11, 2014 | 1997 Lincoln Continental

1 Answer

2008 Kia Rio interior lights and clock wont turn on

You are right... You will need to check your fuses. You can buy a fuse puller and pull each one out to check to see if the metal bar is separated or you can often times just tell by looking at it. Most interior fuses is on drivers side .

May 09, 2014 | 2008 Kia Rio

1 Answer

Just changed ignition lock cylinder and my 1999 toyota 4runner limited wont start

wont start, or wont crank>????????

did you follow all the steps in the FSM for this?
and heed the warnings?
did you shut down the AIR bags first. (battery pull and the 90 second rule) and keep battery pulled whole time?
air bags can kill, and ign. key fiddling is #1 here.
i bet you did not pull the battery as the FSM directs and you blew the fuses. or worse.
do you have the IMMO , immoblizer option, is the IMMO dash lamp
telling you, its ACTIVE, that is, IMMOBILized? bingo
the IMMO lamp tells you , im ok, at key on, and then tells you Im off or on. the operators guide covers this lamp, lost your guide?

the IMMO cuts fuel , not cranking in most cars.
Does the CEL glow key on, if not the ECU is dead, blown fuse #1 reason.

Jan 02, 2014 | 1999 Toyota 4Runner

1 Answer

I pulled a charger out my 1991 Chevy caprice car lighter n it sparked. My glove box light my cigarette lighter and the trunk button wont work no more. Wut cud b wrong?

You popped the fuse in the fuse box. If you still have the owners manual it will tell you which one it is. If not use a test light and turn the key on and test both sides of all the fuses. The bad fuse will only light the test light from one side of the fuse.

Mar 14, 2013 | Cars & Trucks

1 Answer

Hazard lights, break lights, turn signal lights wont work. Ive changed all the bulbs and they still wont work.

have you checked to see if you have any power to lights. it might be a blown fuse! if you do not have a book on where the fuses are call auto-zone and they will tell you. or pull one fuse at a time to check. check to see if any power to bulbs. good-day ! if you have problem it might be a ground wire to lights.

Aug 25, 2011 | 1990 Chrysler Imperial

1 Answer

Head lights wont turn off after turnning off car

See if you have fuse under dash or under hood if more fuses in there that is marked DRL , or DRL module. (daytime running light module) may be at fault. Pulling that fuse may isolate problem, otherwise you may have to pull connector off back of light switch to test it.

Jun 06, 2009 | 1995 Dodge Spirit

1 Answer

Need the location of dome light fuse, and i don't have the cover to tell me which one

here is a list by numbers i hope this is helpful
kind of go by the fuse amp sizes that will help you determine which is which

May 02, 2009 | 1999 Ford Expedition

1 Answer

Dash lights wont hardley dim.

sounds like you have burnt through the insulation of two or more cables and they are fused together in the loom .Start looking from radio back

Jan 29, 2009 | 2000 Chevrolet Blazer

1 Answer

Daytime running lights

Check the relay for the daytime running lights - probably stuck on ya.
My 94 didn't have them, so I can't tell you where it is.
Somebody on here will know....

Oct 26, 2008 | 1994 Toyota Camry

Not finding what you are looking for?
1998 Jeep Cherokee Logo

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides