Question about 2002 GMC Denali

1 Answer

I have a 2001 GMC Yukon. It was running fine until two days ago. I went to start it on Saturday and it would only make a clicking noise. I was able to start it with jumper cables. I drove for an hour and then when I parked and turned off the engine it went dead immediately. I was not even able to unlock the doors. I was able to jump start it again and make it home. Again when I turned it off, it was completely dead immediately. I bought a new battery and installed it this morning. The Yukon will now start without having to be jumped, but when I take my foot off of the accelerator it dies immediately. As long as I push on the accelerator the engine runs. There are no noises coming from anywhere. All of the gauges read normal and there are no messages on the dashboard. Could it be because it in a new battery and I have to do something else after replacing it or does it sound like something else?

Posted by on

1 Answer

I had the same exact problem with my chevy s-10, but once i replaced the battery it ran fine no problem, u may have fried some circuits and relays while jumping the car, and alot of times that clicking noise is your relay burning out, did your car start doing weird things too? like ejecting cd's, flashing lights really fast and weird noises?

Posted on Sep 11, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why do my all my lights work on my 2001 GMC jimmy except my low beams.


Replace the turn signal switch. All the exterior lights run threw it except the high brake light. There is a small plastic clip/switch in it that controls high and low setting. Because of heat it starts to melt and quits working.

Jul 05, 2015 | 2001 GMC Jimmy

1 Answer

96 GMC Yukon won't turn over


Thats what i would try and if that dont help, maybe check the connections at the starter.

Feb 18, 2013 | 1996 GMC Yukon

1 Answer

2001 Yukon Denali Front wheels buckle when there are turned at an angle after the vehicle was warmed up.When I start off in the morning everything is fine.(FYI- There is no Clicking noises, it just buckles...


Probably the hub bearings are going bad. My wife s truck needs one now (same truck). Get it looked at soon. Bearings range from 90.00 on ebay to 160.00 local stores and dealer.

Jun 18, 2010 | 2002 GMC Yukon Denali

2 Answers

GMC YUKON XL 2WD 5.3ENGINE DIES LOW IDLE


Problem my be your throttle sensor.

Mar 18, 2010 | 2001 GMC Yukon XL

2 Answers

My 1999 yukon wont start i changed master air flow


Fuel pumps are real common to go out on those vehicles

Mar 15, 2010 | 1999 GMC Yukon

1 Answer

While in stop and go traffic my brake pedal went


check the brake fluid level, if its low, there may be a leak, if the level is good, the master cylinder is bad.

Oct 15, 2009 | 2001 GMC Yukon

1 Answer

Noise in rear end 2001 gmc yukon xl


broken ring gear, defective U-joint, i would go with having the U-joints checked.

Jan 09, 2009 | 2001 GMC Yukon

1 Answer

Two days ago my 2001 Yukon would not start; it would only make a clicking noise when I turned the key. I was able to start it by jumping it. I drove it for an hour and when I turned it off it went dead...


It sounds as if your alternator may have gone out. If you take the Yukon by an autoparts shop (Checker, Autozone, etc.), they can run a quick charging system test for you. Good luck!

Jul 21, 2008 | 2007 GMC Yukon Denali

1 Answer

Yukon attiude problem


when changing the battery on a General motors product you run the risk of erasing the PCM you will probably have to go to the dealer and have it reprogrammed please only go to the dealer if not done right you will have more problems.

Jul 02, 2008 | 2002 GMC Yukon XL

Not finding what you are looking for?
Cars & Trucks Logo

445 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

63572 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...