Question about 1998 Jeep Wrangler

1 Answer

AUTOMATIC TRANSMISION I HAVE A JEEP WRANGLER 1998 2.5 LTS 4 CYL AUTOMATIC, AND HAD A LIQ OF TRNSMITION OIL, BECAUSE HAVE A HOLE IN THE BOTTOM OF THE TRANSMISION, NEAR TO THE SUPPORT OF THE TRANSMISION...THE HOLE LOOKS LIKE FABRIC NO MADE FOR SOMEONE AND I DONT KNOW THE REASON OF THAT HOLE BECAUSE WHEN I PARK THE JEEP IN A HORIZONTAL POSITION, DONT LIQ, BUT WHEN IS PARK IN DIAGONAL POSITION IN MY GARAGE LIQ A LOT OF OIL....CAN YOU HELP ME..... IF SOMEONE TALK IN SPANISH IS BETTER FOR ME... THANKS.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 32 Answers

There is an oil seal between the transfer case and trasnmission housing, if your bearings have gotten hot in the transfer case, this could have caused the oil to heat up and damage the mechanical seal

Posted on Oct 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hello, I'm looking for a replacement for my jeep cherokee 99, the current part number is Chysler P56041 629AD, I found a Chysler P56041 278AD, can this computer works ok with my cherokee?


THE PCM MODULE.
no country stated, the 728ad shows Europe. (why?)
"I found"

where, at ebay, at pick-apart, or ?
USA cars have 11 PCM for one engine. fact.
and 100s more world wide.
what a question, just a p/n
then you post to grand Cherokee and then text leaving out Grand.?
why?
i searched the part at jeep and is wrangle part, 629ad.

you do know that it must be reprogrammed to your car right:?
the pcms on cars can vary
by engine, trans opted , 4wd/2wd,and year.
federal PCM
Calif PCM
and mexico PCM
and 9 more. just for 1999

is yours 42RE for 45RFE?? tranny??? 30/32 RH? what?
post county (or state if calif)
post engine and year
post body and not contradict.?
post drive line, in car, tranny and if 4wd?
then we can match it up
or call jeep.com

they (jeep) will do this magical thing!
ask you the VIN.
and then look it up in their database.
and see ALL THE ABOVE even what radio is in it. of 5.
me, im a glass half full guy (hard knocks, reality stuff)
id not even believe the part in car is correct.
im too SAVVY !
i find out from jeep what it should have first.

not one matches the 4.0L in the GC.


the 629 posted shows this at jeep.com

JEEP WRANGLER 2.5L Power Tech I-4 Cyl., 3-Spd. Automatic 30RH 1998
JEEP WRANGLER 2.5L Power Tech I-4 Cyl., 5-Speed Manual 1998
JEEP WRANGLER 4.0L I6 Power Tech, 3-Spd. Automatic 32RH 1998
JEEP WRANGLER 4.0L I6 Power Tech, 5-Speed Manual 1998
(if true needs to be programmed to each)

the send number
56041 278AD

lands at.
(part not found, is this a non usa part?) im stumped

was fun to try.
but im stumped.

Mar 31, 2016 | 1999 Jeep Grand Cherokee

2 Answers

Automatic transmision of ford taurus 2000, 3.8 lts. will not work


CHECK FLUID...MAKE SURE SHIFT CABLE IS MOVING LEVER ON TRANSMISSION...MAY BE NEW CAR TIME..CAR NOT WORTH 2000 FOR NEW TRANSMISSION

Mar 20, 2010 | 2000 Ford Taurus

1 Answer

1998 wrangler 4 cyl 110,000 miles. The engine


quite possibly it may be taking a little while to build fuel pressure. next time try cycling the key on and off 3 or 4 times with out cranking the vehicle to allow the pump to build pressure the try to star it up if it starts right up then your problem is it's just taking time to build pressure

Oct 19, 2009 | 1999 Jeep Wrangler

1 Answer

Have a 95 jeep wrangler. 4 cyl engine. Oil pressure gauge is reading high. What might be causing this?


Oil pressure switch short on a 2.5 it is on the passenger side on the back of the engine block if the is oil on the switch replace it 99.9% of the time this is the problem cheep to replace and not hard to do.

Oct 05, 2009 | 1995 Jeep Wrangler

1 Answer

Describe your 1997 Jeep Wrangler 1997 jeep wrangler 4 cyl idle fluctuates 900 rpm to 400 rpm after warmup no service engine light but check guages light comes on momentarily when rpm gets low and oil press...


The check gauges light is normal because at 400 rpm it isn't running fast enough to build sufficient oil pressure. I am guessing maybe a vaccum leak???

Jul 10, 2009 | 1997 Jeep Wrangler

Not finding what you are looking for?
1998 Jeep Wrangler Logo

Related Topics:

142 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...