Question about Saturn Relay

1 Answer

Every time i fil the gas tank the gauge reads empty

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

I had the same problem...I purchased an inexpensive code checker/reset module at Princess Auto. Plugged the unit under the dash below the steering column and reset the error codes. This forced the gauge to reset and the sending unit now reads correctly. Give it a try.

Posted on Jul 29, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel gauge not working


You will need to test a number of things, the fuel gauge is part of a rather simple circuit.

Battery -> gauge -> tank sensor -> chassis ground to battery

If the circuit is broken at any of the steps, your gauge will read "empty". If the tank sensor is bad, it could read empty, or if the float in the tank has sunk, it will read empty.

I start at the gauge with a "test light" that glows when it sees battery voltage. Get a light at the connection to the gauge? Good. find the sensor connection, usually on top of the tank, accessible in the trunk. Probe with test light. Light on? Good. Connect wire to ground, gauge should read "full". If all that is as I said, then the tank sensor is bad. If you don't read battery at any step, you know where the problem is.

Nov 13, 2015 | Cars & Trucks

1 Answer

Digital gas gauge reading incorrectly and inverted


sounds like a faulty sender unit or your just realy low on fuel before you spend any money on repairs try filling the tank up with fuel as if its been low for a long time the sender unit in the tank may be sticking the fuel will lube it and may start working again

Feb 22, 2014 | 2008 Honda Civic 1.8

1 Answer

My gmc envoy gas gauge always reads empty


I think its time to change your sending unit in the tank,not sending a signal to the gauge

Feb 09, 2013 | Cars & Trucks

1 Answer

Fuel gauge not working and empty lite is on


Looks like the sensor inside the gas tank is shot! It will need to be replaced. The tank needs to be removed to pull out the sensor and replace it....the empty light will work normally after that!

Jan 10, 2013 | 2004 Saab 9-3

1 Answer

2002 Saturn VUE Gas gauge reads empty with a full tank of gas. What is problem?


possible blowen fuse or a bad sending unit inside fuel tank also check the connections at the tank

Jul 27, 2012 | 2002 Saturn VUE

1 Answer

Fuel gauge reads past full all the time


when the tank is full the resistance is low so the power through the gage make is read full
as the tank empties , the resistance increases so the less current means the gauge reads less until empty there is little or no power , the gauge reads empty
simple check , turn the ignition off, no power , no gauge reading

Sep 09, 2017 | Chevrolet S 10 Cars & Trucks

1 Answer

Fuel gauge reads past full all the time


float may be stuck up;Take tank unit out and check it with power on and observe the travel and relative gauge position.

Sep 09, 2017 | Chevrolet S 10 Cars & Trucks

1 Answer

Have a 2001 gmc jimmy...drove home gas gauge read 1/4 tank..next day cranked over but wont start..gas gauge reads empty...put $10.00 from spare gas can..cranked over but no start ..gas gauge still reads...


chevy and gmc trucks have an on going problem with this,turn the key on,and get a rubber mallot or a hammer and hit the bottom of the fuel tank a couple of times,this will unstick something in the fuel pump/sending unit.

Jan 05, 2010 | 2001 GMC Jimmy

3 Answers

Gas gauge is not reading correctly. Shows a full


the problem is caused by a defective gas gauge sending unit, this part is located inside the gas tank, you must remove the gas tank to replace it.

Dec 02, 2009 | 2002 Cadillac Deville

2 Answers

We just got a 1988 Porsche and filled with 1/2 tank, there was what seemed like overflow happening - Any idea what may be the problem.


fuel tank vent could be blocked by mud/pebbles etc, not letting the gas fumes escape while your adding fuel making it overflow, check underneath the car near the fuel tank .. something to start with..

Oct 10, 2009 | 1991 Porsche 944

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...