Question about Toyota Camry

1 Answer

Where is blower motor resistor located on a 2001 Toyota Camry?

Posted by on

  • 3 more comments 
  • Mariodiiorio Jul 21, 2008

    Thanks Guill however after a closer look under my dash and another response(from different site) I thought I located it(looks like it) in the passenger far right corner mounted above motor. Or is this something different?

    Thanks for your comments.

    Mario

    ToyotaCamry 2001 owner

  • Anonymous Feb 24, 2009

    Where is the blower motor fuse on the 2005 toyota corolla?

  • Anonymous Mar 12, 2014

    vibrating blower motor on 1995 toyota camry

  • Anonymous Mar 12, 2014

    how to remove blower resistor on 1995 toyota camry

  • Anonymous Mar 23, 2014

    blower motor does not work. replaced resistor. pushed in on circuit breaker to reset - springy - no click heard, so guess it did not trip. How do you remove blower motor switch for cleaning?

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 373 Answers

HI....
The BLOWER motor resistor on a Toyota Camry 01.
Is located Behind center right side of dash.
ON blower housing.
If you vehicle is equipaded with protection cover.
Just you need to remove the cover. and will see the blower resistor.

I hope this information work for you.

Thank you for use fixya.

Posted on Jul 21, 2008

3 Suggested Answers

mutthu273
  • 3 Answers

SOURCE: location of blower motor resistor

in china

Posted on Jun 16, 2008

  • 691 Answers

SOURCE: how do you replace the blower motor resistor in a

The resistor pack is almost always close to the blower. It needs air moving across it to keep it cool. It is usually installed into the duct with two small screws. It has a connector with about 5 -6 wires, and is about 3/4 inch wide, and about 3-4 inches long. Some can be a little difficult to get out due to clearance, and their shape.

Also, it could be the fan speed switch that's giving you problems.

Posted on Aug 31, 2011

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heater fan only works on high


this sounds like you need the resistor that allows the blower motor to operate on the different speeds. if you follow the wires from the blower motor back they lead to the resistor that needs replacing. this is a common problem and are designed to only operate on high if the resistors go bad.

Oct 11, 2014 | 2001 Toyota Camry

1 Answer

How do I replace the blower motor resistor on 95


find the blower motor and follow the wires back to the resistor is the easiest way, it is located in the air box as it uses the air flow to help keep the resistors cool and not overheat.

Sep 24, 2014 | 1995 Toyota Camry

1 Answer

Blower motor resistor location


if you follow the 2 wires from the blower motor back along the wiring it goes to the resistor. it should be within about 8-12" of the blower motor.

Aug 17, 2014 | 2001 Toyota Tundra

1 Answer

Need step by step instructions on how to replace a resistor for blower motor on 2000 toyota camry


The blower motor resistor is under the dash on the passenger side of cabin to the left of the blower motor. Remove panels to access it. The resistor is the one with blue wires going to it on the left of picture below.
10_9_2012_10_43_43_pm.jpg

Oct 08, 2012 | Cars & Trucks

1 Answer

Hello,i have Camry 2001 Le.the ac. speed control switch only work at high speed,1st 3 or 4 does not work? so what is wrong in it?


you need to replace the blower motor resistor and it should be located behind glove box in evaporator box. about 1.5" wide and 3' long in the front.

Jun 14, 2011 | Toyota Camry Cars & Trucks

1 Answer

Blower motor on 2000 toyota camry works only on hi settig


Hi!!
The blower motor speeds are ultimately controlled by the Blower Motor Resistor, when the Resistor becomes defective, current goes right thru it and the Blower Motor only operates at max. speed. Replacing the Resistor is a simple task. Locate electrical connector to blower motor, trace back wiring no more than 8" to next plug, The device where the plug is connected to is the Blower Motor Resistor, disconnect plug and remove the two screws, remove and replace Resistor.
Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa.

Mar 15, 2011 | 1998 Toyota Camry

1 Answer

No lower blower speed only high blower


The blower motor resistor is a pretty common fix for this problem. It will be located near the blower motor.

Sep 26, 2010 | 1991 Toyota Camry

1 Answer

1999 camry blower fan only works on high setting


this problem is caused by the blower speed control resistor, it is located near the blower motor.

May 27, 2010 | 1991 Toyota Camry

1 Answer

I am trying to locate the resistor for the blower motor on a 91 camry i have stood on my head under the dash and cant locate it, i have the glove box out so i can see pretty good. any help would be greatly...


You're on the right track. The blower resisitor is located underneath the box, right next to the blower motor. This photo should better help you find it, provided by Toyota Nation: I hope this helps! :)


27399d4.jpg

Oct 05, 2009 | 1991 Toyota Camry

1 Answer

2001 toyota camry . The heater fan only blows on high. Where is the part located to control fan speed / I had the part replaced once before and it only took them a few minutes to change the module, but I...


Sounds like the blower motor resistor has gone bad. It is located near the blower motor it's self. Pull the glove box down and you should be able to see it.

Sep 17, 2009 | 2001 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

2,857 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

63242 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...