- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Are you looking to discharge and remove air bag or just remove from steering column
To remove air bag from steering column Disconnect battery Behind steering wheel there are four bolts tha hold bag on They are tricky to see the bolt holes but their there tight spot Now for the trick of wiring hopefully new style came with a release wire clip older style fed wires down column with release clip located under dash Remove the key ignition box The wires should be bright orange or yellow from air bag going threw column If old style you will have to loosen turn signal indicators if wires run under mount Once you get to end of wire clip Use a sewing needle to push buds out of clip mark your the main side Now for ease part Tape a little 3 foot wire to the ends before pull completley threw this will help pull bud wires back down threw tutn indicator switch Never force wire threw gently Removing air bag hopefully made simple by quick release clip under horn press
The battery is located under the back seat. The specifications of the battery on your particular model can be found on top of the existing battery. To remove the back seat,simply grab the front of the seat with both hands underneath and pull straight upwards, this releases the spring clips, no bolts or screws to remove.
On ALL gasoline models there is no separate voltage regulator. The
regulator circuitry is contained in the engine controller. If this
circuitry is found faulty, the entire engine controller computer must be
replaced as a unit.
REMOVAL & INSTALLATION (see
This procedure covers diesel models only.
Fig. 1: Pull on the connector body, not the wiring when
removing the electronic voltage regulator
Disconnect the negative battery cable.
Release the spring clips and pull off the regulator wiring plug.
See if your bolts are rusty or hard to remove, if so use lubricant
and allow to sit for a few minutes before removing.
Remove the regulator.
Install the regulator and secure using the hold-down bolts.
Hook the spring clips to the wiring plug. Make sure the clips are
Push lower end of rear seat back to unlock clips (takes a bit of effort) Lift bench out Should be clips or bolts holding the top of the rear seat - release these Push up on the upper section of seat to release top clips. in some car models Remove the 10mm bolt behind the bench near the seat belt fastening sight and then lift the seat up from the back to the front..towards the front seats. The clips are angled down and in so that the back has to lift up first. This will help. Thanks please keep updated. please please do rate the solution positively
.thank you for using fixya
No you don't have to remove battery.
Look on the back side of the headlamp assembly and you will see to black retainer clips.Pull up on them and this releases the headlamp assembly,pull it forward then replace bulb reinstall the assembly and then push the retainer clips back down.
Drivers side: Remove plastic cover on rear of headlamp by pushing down on long wire clip.Pull cover outwards and downwards to release the two clips on top of cover.
Remove wiring connection from rear of bulb.
You will now find that a mirror and torch will come in handy.Using the mirror you will see that the bulb is held in place with a spring clip that locates under a metal lug on the headlamp.Push the clip so that it releases from the lug and swing the clip away from the bulb.Remove old bulb.
Insert new bulb making sure the locating tab is in the correct position.[Use the mirror to check].
Replace spring clip.
Replace rear cover and long wire clip.
Passenger side:Little more difficult.Remove battery cover and follow the same instructions as for the drivers side.Not so much room to work this side though.
Do not touch the glass parts of the bulbs whilst changing them and if you do clean the glass with metholated spirits before fitting.